Shark S3501CO User Manual

OWNER’S GUIDE

S3501CO

Eng lis h

IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS

For Household Use Only

WHEN USING YOUR SHARK
STEAM MOP, BASIC SAFETY
PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING:

READ ALL INSTRUCTIONS
BEFORE USING YOUR
STEAM MOP.

DANGER OF SCALDING.

Please use caution when
using the steam mop. The steam
emitted from the steam mop is
very hot.

POLARIZED PLUG:

This appliance has a polarized
plug (one blade is wider than
the other). As a safety feature,
this plug will fit into a polarized
outlet only one way. If the
plug does not fit fully into the
outlet, reverse the plug. If it still
does not fit, contact a qualified
electrician. Do not attempt to

defeat this safety feature.

1. Use the system only for its
intended use.

2. DO NOT use outdoors.

3. DO NOT leave the appliance
unattended when plugged in.
Always unplug the power cord
from the electrical outlet when not
in use and before servicing.

4. DO NOT allow the appliance to be
used by children. Close attention
is necessary when used by or near
children, pets or plants.

5. Use only as described in this
manual.

6. Use only manufacturer’s
recommended accessories.

7. DO NOT operate the appliance
with a damaged plug or cord, or
if the unit has been dropped or
damaged. To avoid the risk of
electric shock, do not disassemble
or attempt to repair the appliance
on your own. Return the appliance
to EURO-PRO Operating LLC (see
warranty) for examination and
repair. Incorrect re-assembly or
repair can cause a risk of electrical
shock or injury to persons when
the appliance is used.

8. To protect against a risk of electric
shock, DO NOT immerse the steam
mop into water or any other liquids.

9. DO NOT handle plug or steam
mop with wet hands or operate
appliance without shoes.

10. DO NOT pull or carr y by power
cord, use power cord as handle,
close a door on the power cord, or
pull the power cord around sharp
edges or corners. Keep power cord
away from heated surfaces.

11. DO NOT unplug by pulling on
power cord. To unplug, grasp the
plug not the power cord. Do not
use extension cords or outlets
with inadequate current carrying
capacity.

12. DO NOT put any objects into
openings. Do not use with any
opening blocked.

13. DO NOT put hands or feet under
the steam mop. Unit gets very hot.

14. Use ONLY on flat, horizontal
surfaces. Do not use on walls,
counters or windows.

15. DO NOT use on leather, wax
polished furniture or floors,
synthetic fabrics, velvet or other
delicate, steam sensitive materials.

16. DO NOT add cleaning solutions,
scented perfumes, oils or any other
chemicals to the water used in this
appliance as this may damage the
unit or make it unsafe for use. If
you live in a hard water area, we
recommend using distilled water in
your steam mop.

17. When in use, NEVER turn the
appliance over or on its side.

NEVE R DIRECT STEAM TOWARDS
PEOPLE, ANIMALS OR PLANTS.

18. NEVE R LEAVE THE STEAM MOP
IN ONE SPOT ON ANY SURFACE
FOR ANY PERIOD OF TIME
WHEN MICRO -FIBER POCKET IS
ATTACHED.

19. Carefully remove the micro-fiber
pocket immediately after you have
unplugged and allowed the steam
mop to cool.

20. When cleaning the steam mop,
unplug the power cord from the
electrical outlet and clean with a
dry or damp cloth. Do not pour
water or use alcohol, benzene or
paint thinner on the unit.

21. Extreme caution should be
exercised when using this
appliance to clean stairs.

22. Never use steam mop without
micro-fiber pocket attached.

23. Keep your work area well lit.

24. Store steam mop indoors in a cool,
dry place.

25. To avoid circuit overload, do not
operate another appliance on the
same socket (circuit) as the steam
cleaner.

26. If an extension cord is absolutely
necessary, an extension cord rated
a minimum of 15 ampere, 14 gage
cord should be used. Cords rated
for less amperage may overheat.
Care should be taken to arrange
cord so that it cannot be pulled or
tripped over.

27. DO NOT leave your Steam Mop
unattended when the system is
connected to a power supply
/electrical outlet.

28. DO NOT store unit with damp/
wet micro-fiber cleaning pocket
attached. Never leave the steam
mop in one spot on any surface for
any period of time with a damp or
wet micro-fiber cleaning pocket
attached as this will damage
your floors.

29 Always unplug and allow the steam

mop to cool before removing or
changing mop heads.

WARNING: Your steam mop

is designed to clean hard floor
surfaces that will withstand high
heat. Do not use on unsealed wood
or unglazed ceramic floors. On
surfaces that have been treated
with wax or some no wax floors,
the sheen may be removed by the
heat and steam action. It is always
recommended to test an isolated
area of the surface to be cleaned
before proceeding. We also
recommend that you check the use
and care instructions from the floor
manufacturer.

ww w.s har kco mpany.comTOL L FREE: 1 -8 00-79 8-7398

Quick Start

Quick Start

When assembling your steam mop
there may be a little water in or around
the water tank. This is because we test
all our steam mops 100% before you
buy them, so you get a quality

®

Shark

Steam Mop.

1

2

5

QUICK TIP:

For easier
pushing
and pulling,
extend the
handle length.

DIRT CAN’T HIDE ON
EITHER SIDE! All new

design allows for optimal
cleaning! When one side
of the pocket gets dirty,
just turn the mop head
over and clean with the
other side of the pocket.

6

3

4

ASSEMBLE

1 Insert the mop handle into the

pump actuator (the tube that leads
to the tank). Push the mop handle
and pump actuator together in
until you hear it click into place.

2 Select a mop head and cleaning

pad. Choose from the Rectangle,
Triangle or XL Rectangle mop
head. Fit one side of the pocket
onto the head first, then using
the lavender loop, pull the pocket
over the head. Attach the quick
fasteners on the top of the pocket
to secure in place.

3 Snap the mop head into the base to

secure it. Press the release button
to exchange mop heads.

TOL L FREE: 1 -8 00-79 8-7398

FILL

4 Lay the mop on the floor or on

a counter top and remove the
water tank cap by turning counter
clockwise. Fill the water tank using
the filling flask. Do not overfill the
water tank. Replace the water cap
and tighten.

IMPORTANT: Make sure your floors

are sealed. Before using the Steam
Mop consult page 4 for more
information.

PREPARE

5 For your comfort, you can adjust

the height of the mop. Just lif t the
latch on the tube 90 degrees to the
open position. Holding the handle,
extend the tube to the height that ’s
right for you and then close latch
to locked position.

6 Plug in mop and wait 30 seconds

or less for the mop to heat up.

Pump the handle of the mop by
pushing downward about 10 to 12
times to create stea m.

NOTE: Steam is created

automatically when you start
mopping.

QUICK TIPS: We’ve added

an additional mop head.
You can now choose from a
Rectangle mop head for all
the rooms in your house or
the Triangle mop head that
is perfect for bathrooms
and tight spaces or the
XL Rectangle mop head
for big jobs.

NOTE: Do not leave your

Steam Mop unattended
during use.

IMPORTANT: Never leave

the steam mop in one spot
for any period of time with
a damp or wet micro-fiber
pocket attached as this will
damage your floors.

ww w.s har kco mpany.com

Contents

Eng lis h

Thank you for
purchasing

®

the Shark
Steam Mop.

Getting Started ......................................................................2

Using Your Steam Mop .......................................................6

Using Your Carpet Glider ...................................................8

Care of Your Steam Mop ....................................................9

Ordering Replacement Parts ........................................... 11

Troubleshooting Guide ....................................................... 12

Warranty and Registration ................................................13

TOL L FREE: 1 -8 00-79 8-7398

ww w.s har kco mpany.com

1