Shark S3251 User Manual
WWW.SHARKCLEAN.COM
LIGHT & EASY™ STEAM MOP
S3251
OWNER’S GUIDE
S3251_11_ENG_IB_101117.indd 1 10-11-17 1:58 PM
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
For Household Use Only
WHEN USING YOUR SHARK®
STEAM MOP, BASIC SAFETY
PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING:
WARNING:
TO REDUCE
THE RISK OF FIRE , ELECTRIC
SHOCK OR INJURY READ ALL
INSTRUCTIONS BEFORE USING
YOUR LIGHT & EASY™.
DANGER OF SCALDING.
Please use caution when
using the steam mop. The steam
emitted from the openings is very
hot.
POLARIZED PLUG:
TO REDUCE THE RISK OF ELECTRIC
SHOCK,
this appliance has a
polarized plug (one blade is wider
than the other). As a safety
feature, this plug will fit into a
polarized outlet only one way. If
the plug does not fit fully into the
outlet, reverse the plug. If it still
does not fit, contact a qualified
electrician. Do not attempt to
defeat this safety feature.
1. Use the system only for its
intended use.
2. DO NOT use outdoors.
3. DO NOT leave the appliance
unattended when plugged in.
Always unplug the power cord
from the electrical outlet when
not in use and before servicing.
4. DO NOT allow the appliance
to be used as a toy. Close
attention is necessary when
used by or near children, pets
or plants.
5. Use only as described in this
manual.
6. Use only manufacturer’s
recommended accessories.
7. DO NOT operate the appliance
with a damaged plug or cord,
or if the unit has been dropped,
damaged left outdoors or
dropped into water. To avoid
the risk of electric shock, do
not disassemble or attempt to
repair the appliance on your
own. Return the appliance to
EURO-PRO Operating LLC (see
warranty) for examination and
repair. Incorrect re-assembly
or repair can cause a risk of
electrical shock or injury to
persons when the appliance is
used.
8. To protect against a risk
of electric shock, DO NOT
immerse the steam mop into
water or any other liquids.
9. DO NOT handle plug or steam
mop with wet hands or operate
appliance without shoes.
10. DO NOT pull or carry by
power cord, use power cord
as handle, close a door on the
power cord, or pull the power
cord around sharp edges or
corners. Keep power cord
away from heated surfaces.
TOL L F RE E: 1-80 0-79 8-739 8
S3251_11_ENG_IB_101117.indd 2 10-11-17 1:58 PM
11. DO NOT unplug by pulling on
power cord. To unplug, grasp
the plug not the power cord.
Do not use extension cords or
outlets with inadequate current
carrying capacity.
12. DO NOT put any objects into
openings. Do not use with any
opening blocked.
13. DO NOT put hands or feet
under the steam mop. Unit
gets very hot.
14. Use ONLY on flat, stable
horizontal surfaces. Do not use
on walls, counters, windows,
chairs or tables.
15. DO NOT use on leather, wax
polished furniture or floors,
synthetic fabrics, velvet or
other delicate, steam sensitive
materials.
16. DO NOT add cleaning
solutions, scented perfumes,
oils or any other chemicals to
the water used in this appliance
as this may damage the unit
or make it unsafe for use. If
you live in a hard water area,
we recommend using distilled
water in your steam mop.
17. When in use, NEVER turn
the appliance over or on its
side. NEVER DIRECT STEAM
TOWARDS PEOPLE , ANIMALS
OR PLANTS.
18. Carefully remove the microfiber pad immediately after you
have unplugged and allowed
the product to cool.
19. When cleaning the steam mop,
unplug the power cord from
the electrical outlet and clean
with a dry or damp cloth. Do
not pour water or use alcohol,
benzene or paint thinner on the
unit.
20 To reduce the risk of fire,
DO NOT use a flammable or
combustible liquid to clean a
floor.
21. Extreme caution should be
exercised when using this
appliance to clean stairs.
22. Never use steam mop without
micro-fiber pad attached.
23. Keep your work area well lit.
24. Store steam mop indoors in a
cool, dry place.
25. To avoid circuit overload, do
not operate another appliance
on the same socket (circuit) as
the steam cleaner.
26. If an extension cord is
absolutely necessary, an
extension cord rated a
minimum of 15 ampere, 14
gage cord should be used.
Cords rated for less amperage
may overheat. Care should be
taken to arrange cord so that
it cannot be pulled or tripped
over.
27. DO NOT leave unattended
when the system is connected
to a power supply or electrical
outlet. Turn off all controls
before unplugging the unit.
28 DO NOT store unit with damp
or wet micro-fiber cleaning
pad attached. Never leave the
steam mop in one spot on any
surface for any period of time
with a damp or wet microfiber cleaning pad attached as
this will damage your floors
WARNING: Your steam mop
is designed to clean hard floor
surfaces that will withstand
high heat. Do not use on
unsealed wood or unglazed
ceramic floors. On surfaces
that have been treated with
wax or some no wax floors,
the sheen may be removed
by the heat and steam action.
It is always recommended
to test an isolated area of
the surface to be cleaned
before proceeding. We also
recommend that you check the
use and care instructions from
the floor manufacturer.
ww w.s harkcl ea n. com
S3251_11_ENG_IB_101117.indd 3 10-11-17 1:58 PM
Quick Start
fig. 3
fig. 1
ASSEMBLE
1 Fit together the extension tubes
as shown in the illustration.
(fig. 1)
2 Place the micro-fiber cleaning
pad underneath the mop head,
with quick fastener strips facing
up. Simply press the mop to the
pad to attach it. (fig. 2)
TOL L F RE E: 1-80 0-79 8-739 8
S3251_11_ENG_IB_101117.indd 4 10-11-17 1:58 PM
FILL
3 Remove the cap to fill the
water tank. Use the filling flask
and funnel to fill the tank with
water to the “MAX” fill line.
Replace the water tank cap.
(fig. 3)
fig. 2
QUICK TIP:
For easier
pushing
and pulling,
extend the
handle length.
Quick Start
fig. 4
STEAM CLEANING
4 For your comfort, you can adjust
the height of the mop. Just lift
the latch on the tube 90 degrees
to the open position. Holding the
handle, extend the tube to the
desired height and then close the
latch to the locked position.
5 Plug in the mop. Wait 30
NOTE: Do not leave your
Steam Mop unattended
during use.
IMPORTANT: Never leave
the steam mop in one spot
for any period of time with
a damp or wet micro-fiber
pocket attached as this will
damage your floors.
seconds for the unit to heat up
and the steam to be ready.
Push the handle toward the
mop head in a pumping motion.
Customize steam output by slow
or fast mopping with a forward
and backward motion. (fig. 4)
ww w.s harkcl ea n. com
S3251_11_ENG_IB_101117.indd 5 10-11-17 1:58 PM
This ma nual cove rs mode l numbe r:
S3251 11
TECH NIC AL SPEC IFIC ATION S
Voltage: 120V., 60Hz.
Power: 1550 Watts
Water
Capacity: 250 ml (8 oz.)
TOL L F RE E: 1-80 0-79 8-739 8
S3251_11_ENG_IB_101117.indd 6 10-11-17 1:58 PM
Loading...