Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
POWERED LIFT-AWAY® with Self-Cleaning Brushroll
QUICK START GUIDE
WHAT’S INSIDE
A Wand |
D Vacuum Pod |
B Motorized Floor Nozzle |
E Pet Crevice Tool |
C Handle & Hose |
F Pet Multi-Tool |
ASSEMBLY
C
2
A |
(Click) |
1
(Click)
B
Insert wand into |
Insert handle into wand. |
motorized floor nozzle. |
|
3
(Click)
D
Place pod onto wand and slide down to connect.
4
(Click)
E F
Connect hose to back of pod, pressing until it clicks into place. Store accessories on the posts on the pod.
MAINTENANCE
Empty dust cup after each use
Pull up on |
Hold dust cup over |
Press top |
dust cup |
a trash bin and press |
empty-release |
release latch |
the empty-release |
latch to access |
and lift dust |
latch on the bottom. |
dust screen and |
cup off pod. |
|
remove built-up |
|
|
debris as required. |
Cleaning Filters
Foam filter
Filter
Felt filter
HEPA
Pre-Motor (foam and felt):
TIP:
Wash foam and felt filters every 3 months to keep
the suction strong.
Rinse filters with water only and allow them to air-dry completely. Tap loose dirt from foam filters as needed between washes.
With the dust cup removed, take out the foam and felt filters and rinse them with water only.
Post-Motor (HEPA):
To access the HEPA filter, pull the Filter Access latch under the filter cover and take off the cover. Remove the HEPA filter and rinse it with water only.
Self-Cleaning Brushroll
The self-cleaning brushroll automatically removes hair wrap. If some hair or debris remains after continued use, remove the cover to access the brushroll.
Using a coin, |
Clear |
Replace cover, |
turn locks |
blockages |
pressing down |
counterclockwise |
from airway. |
firmly on all sides |
to open, then |
|
before turning |
lift off cover to |
|
locks clockwise |
access brushroll. |
|
to close. |
VERSATILE FLOOR-TO-CEILING CLEANING
FLOOR CLEANING
1 Plug In Vacuum
Press the Power button, then step on the floor nozzle and tilt the handle back.
POWERED LIFT-AWAY® MODE
Press Lift-Away® button to lift pod off floor nozzle. You are now ready to clean those hard-to-reach places.
L i f t A way®
2 Choose Setting
Slide the selector switch to the appropriate surface setting:
For thick carpets and area rugs:
Set switch to
Thick Carpet/Area Rug.
Wand
Release
For low-pile carpets:
Set switch to Carpet/Low Pile.
For bare floors or above-floor areas:
Set switch to Hard Floor.
To clean with a longer reach, detach the wand from the floor nozzle by pressing the Wand Release button.
NOTE:
For deep cleaning, use Carpet/Low Pile setting.
LIFT-AWAY ABOVE-FLOOR CLEANING
To clean above-floor
Handle areas with the handle, detach it from the
wand by pressing the Handle button.
Attach any of the specialized cleaning accessories to the handle or wand.
For questions or to register your product, visit us online at sharkclean.com
© 2019 SharkNinja Operating LLC. LIFT-AWAY, POWERED LIFT-AWAY, ROTATOR, and SHARK are registered trademarks of SharkNinja Operating LLC.
ZU632_QSG_MP_Mv4