Shark Rotator NV750ANZ Owner's Manual
™
OWNER’S GUIDE
NV750ANZ
2
AUST: 1800 89 0 840
Thank you for purchasing the Shark® Rotator™ Professional Powered Lift Away™
Upright Vacuum.
This Owner’s Guide is designed to help you get a complete understanding of your
new vacuum cleaner. Please read it carefully and keep it for future reference.
For a list of what is included with this model, refer to inside flap of box.
If you should have a question about your Shark
®
Rotator™, please call
AUST: 1800 890 840 or NZ: 0800 002 999.
THANK YOU!
REGISTER YOUR PURCHASE:
AUST: 1800 890 840
NZ: 0800 002 999
RECORD THIS INFORMATION:
Model Number: ���������������������������������������������
Date of Purchase (Keep receipt):
����������������������������������������������������������
TECHNICAL SPECIFICATIONS:
Voltage: 220-240V~, 50/60Hz
Main Body Motor Watts: 1100W
Power Nozzle Watts: 80W
Motorized Brush Watts: 30W
RECOMMENDED FILTER CLEANING SCHEDULE:
See the MAINTENANCE section for filter cleaning instructions
Foam filter: XFF650 Every 3 months
Felt Filter: XFF650 Every 3 months
HEPA Filter: XHF650 Every 12 months
GMA-102233-EA-009
3
NZ: 08 00 0 02 99 9
IMPORTANT SAFEGUARDS
FOR HOUSEHOLD USE ONLY
READ ALL INSTRUCTIONS BEFORE USE
SAVE THESE INSTRUCTIONS
When using an electrical appliance, basic safety precautions should always be
observed, including the following:
WARNING
This appliance is not intended for use by persons with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children shall not use or play with this appliance. Close supervision is necessary to keep
appliance out of reach of children during use.
CAUTION
THE POWER NOZZLE, WAND, HOSE, MOTORIZED BRUSH AND HANDLE CONTAIN
ELECTRICAL CONNECTIONS:
• These are not seviceable parts.
• Do not use to vacuum any liquids.
• Do not immerse in water when cleaning.
• Prior to use, inspect hose for damage. Discontinue using if dammaged.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
1 DO NOT use outdoors or on wet surfaces.
2 Unplug from electrical outlet when not in use and before cleaning or servicing.
3 DO NOT use with damaged cord or plug. Contact Customer Service or Service Center for
the repair or replacement of the line cord.
4 DO NOT use if the appliance is not working, has been dropped, dropped into water,
damaged or left outdoors.
5 NO SERVICEABLE PARTS. Incorrect re-assembly or repair can cause a risk of electrical
shock or injury to persons when the appliance is used. Contact Customer care.
6 The hose contains electrical wires. Do not use when damaged, cut or punctured.
7 DO NOT pull or carry vacuum cleaner by the cord or use the cord as a handle.
8 DO NOT unplug by pulling on cord; to unplug, grasp the plug, not the cord.
9 DO NOT handle plug or vacuum cleaner with wet hands.
10 DO NOT run the vacuum cleaner over the power cord, close a door on the cord or pull cord
around sharp corners.
11 The use of an extension cord is not recommended.
12 DO NOT leave vacuum cleaner unattended when plugged in.
13 Keep cord away from heated surfaces.
14 Turn off all controls before plugging or unplugging the vacuum cleaner.
15 Always turn off the vacuum cleaner before connecting or disconnecting power nozzle.
16 Store your vacuum cleaner with the power cord secured around the two cord holders.
GENERAL USE
17 Use only as described in this manual.
18 DO NOT put any objects into openings. DO NOT use with any opening blocked; keep free
of dust, lint, hair, and anything that may reduce air flow.
19 Keep your work area well lit.
20 Keep the vacuum cleaner moving over the carpet surface at all times to avoid damaging
the carpet fibers.
21 DO NOT place vacuum cleaner on unstable surfaces such as chairs or tables.
22 DO NOT use without dust cup and/or filters in place.
23 DO NOT step on, run over, or bend hose. The hose is powered by electrical wires that may
be damaged as a result.
HOSE ATTACHMENTS
24 DO NOT use if air flow is restricted; if the air paths, the hose, or the
accessories become blocked, turn the vacuum cleaner off. Remove all obstructions before
you turn on the unit again.
25 Keep the end of the hose and accessory openings away from face and body.
26 Keep cleaning tools and hose suction openings away from hair, face, fingers, uncovered
feet, or loose clothing.
27 Only use manufacturer’s recommended attachments.
DUST CUP/FILTERS/ACCESSORIES
Before turning on the vacuum:
28 Make sure that all filters are thoroughly dry after routine cleaning.
29 Make sure that dust cup and all filters are in place after routine
maintenance.
30 Make sure accessories are free of blockages.
31 Use only manufacturer’s recommended accessories and replacement parts.
GENERAL CLEANING
32 DO NOT pick up large-sized objects.
33 DO NOT pick up hard or sharp objects such as glass, nails, screws or coins that could
damage the vacuum cleaner.
34 DO NOT pick up smoking or burning objects such as hot coals, cigarette butts, or matches.
35 DO NOT pick up flammable or combustible materials such as lighter fluid, gasoline, or
kerosene or use vacuum in areas where they may be present.
36 DO NOT pick up toxic solutions such as chlorine bleach, ammonia, or drain cleaner.
37 DO NOT use in an enclosed space where vapors are present from paint, paint thinner,
moth-proofing substances, flammable dust or other explosive or toxic materials.
38 DO NOT vacuum up any liquids.
39 DO NOT immerse vacuum cleaner in water or other liquids.
40 DO NOT use outdoors or on wet surfaces; use only on dry surfaces.
41 Use extra care when cleaning on stairs.
4
AUST: 1800 89 0 840
ASSEMBLY
1 Place the noz zle on the floor and insert the wand.
2 Insert the handle into the wand.
3 Slide the pod onto the wand.
4 Attach the hose to the back of the pod.
5 Insert the crevice tool and upholstery tool into the accessory clips as shown.
2
1
4
3
5
5
NZ: 08 00 0 02 99 9
UPRIGHT
CLEANING
WARNING: To reduce the risk of electric shock, unplug the unit before assembling, adding or removing attachments or converting modes.
WARNING: Always ensure the power is OFF (“O” position) before plugging and unplugging.
1 Press POWER and push the surface selector to THICK CARPET/AREA RUG for high piles, thick carpets, area rugs, and specialty carpets. This setting produces reduced
suction with the motorized brush roll. It is the best setting if the vacuum becomes difficult to push or pull due to high suction.
2 Press POWER and push the surface selector to CARPET/LOW PILE for low pile and normal carpet types. This is the default carpet setting and produces high suction
with the motorized brush roll.
3 Press POWER and push the surface selector to HARD FLOOR for hard floors and accessories. This setting produces high suction and turns off the motorized brush roll.
4 Place your left foot gently on the floor nozzle and tilt the handle back to start cleaning. Note: The motorized brushroll will only spin once the vacuum is reclined back.
Hard Floor
Carpet
Deep Carpet
4
2
Best setting for low pile carpet and normal carpet types. This is the default carpet setting and produces high suction
with the motorized brushroll.
Best setting for high piles, thick carpets, area rugs, and specialty carpets if the vacuum becomes difficult to push or
pull due to high suction. This setting produces low suction with the motorized brushroll.
Best setting for hard floors and the accessories. This setting produces high suction and turns off the motorized brushroll.
3
1
Loading...