How it Works
Shark
Loading...
NV22LE
Owner's Manual
32 pgs4.27 Mb0

Shark NV22L, NV22LA, NV22LE, NV22LCO Owner's Manual

Owner’s Guide Manual del usario
NV22L
NV22LA
NV22LE
NV22LCO
www.sharkclean.com
TOLL FREE: 1-800-798 -7398
TECHNICAL SPECIFICATIONS
Voltage: 120V.
Watts: 1200W
Amps: 10A
Hertz: 60Hz
1www.sharkclean.com
English
Contents
Important Safety Instructions 2
Getting Started 4
Using the Vacuum 6
Cleaning with the Vacuum Accessories 7
Emptying the Dust Cup Assembly 8
Proper Care of Your Vacuum 9
Troubleshooting 10
Checking for Blockages 11
Maintenance 12
Warranty and Registration 13
Thank you for purchasing the Shark® Navigator Upright Vacuum.
2
TOLL FREE: 1-800-798 -7398
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY DO NOT USE OUTDOORS OR ON WET SURFACES.
WHEN USING YOUR SHARK® NAVIGATOR UPRIGHT VACUUM, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING YOUR SHARK
®
NAVIGATOR UPRIGHT
VACUUM.
POLARIZED PLUG:
This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit into a polarized outlet only one way.
Do not force into the outlet or try to modify the plug to fit.
GENERAL ELECTRICAL SAFETY:
1. Unplug from electrical outlet when not in use and before servicing.
2. DO NOT use vacuum with a damaged cord or plug.
3. DO NOT pull or carry vacuum by the cord.
4. DO NOT unplug by pulling on cord; to unplug, grasp the plug, not the cord.
5. DO NOT handle plug or vacuum cleaner with wet hands.
6. DO NOT run the vacuum over the power cord.
7. DO NOT close a door on the cord.
8. DO NOT pull cord around sharp corners.
9. DO NOT leave appliance when plugged in.
10. Keep power cord away from heated surfaces.
11. Turn off all controls before plugging or unplugging vacuum cleaner.
HOSE ATTACHMENTS:
12. DO NOT use if air flow is restricted; if the air paths, the hose or the extension tube become blocked, turn the vacuum cleaner off. Remove all obstructions before you turn on the unit again.
13. Keep the end of the hose, wands and other openings away from face and body.
14. Keep rotating brush and suction openings away from hair, face, fingers, uncovered feet or loose clothing.
15. Only use manufacturer’s recommended attachments.
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
For Household Use Only
3www.sharkclean.com
English
GENERAL USE:
16. Use only as described in this manual.
17. DO NOT put any objects into openings.
18. Keep your work area well lit.
19. Keep the vacuum moving over the carpet surface at all times to avoid damaging the carpet fibers.
20. DO NOT place vacuum on unstable surfaces such as chairs or tables.
21. DO NOT allow young children to operate the vacuum or use as a toy.
22. DO NOT use vacuum cleaner if it has been dropped, damaged, left outdoors or submerged in water. Return to EURO-PRO Operating LLC for examination, repair or adjustment.
CYCLONIC CHAMBER/DUST CUP/FILTERS:
23. Before turning on the vacuum:
• Make sure that dust cup, cyclonic chamber
and all filters are in place after routine maintenance.
• Make sure that all components and filters are
thoroughly dry after routine cleaning.
• Only use filters and accessories provided by
EURO-PRO Operating LLC [Failure to do so will void the warranty].
GENERAL CLEANING:
24. DO NOT run the vacuum over large-sized
objects.
25. DO NOT pick up hard or sharp objects such as
glass, nails, screws or coins that could damage the vacuum cleaner.
26. DO NOT pick up smoking or burning objects
such as hot coals, cigarette butts or matches.
27. DO NOT pick up flammable or combustible
materials such as lighter fluid, gasoline, kerosene or use in areas where they may be present.
28. DO NOT pick up toxic solutions such as
chlorine bleach, ammonia or drain cleaner.
29. DO NOT use in an enclosed space where
vapors are present from paint, paint thinner, moth-proofing substances, flammable dust or other explosive or toxic materials.
30. DO NOT vacuum up any liquids.
31. DO NOT immerse vacuum cleaner in water or
other liquids.
32. DO NOT use outdoors or on wet surfaces; use
only on dry surfaces.
33. Use extra care when cleaning on stairs.
4
TOLL FREE: 1-800-798 -7398
Along with your upright unit, you will find the following components:
a Vacuum Body b Floor Power Nozzle c Handle Assembly d Super Stretch Hose e Cleaning Wand f Pet Hair Power Brush g Cleaning Attachments h 24” Crevice Tool i Hard Surface Brush
*
Note: Models NV22LCO and NV22LA come with an extra Cleaning Wand, extra Super Stretch Hose and the Hard Surface Brush. Model NV22LE comes with an extra Cleaning Wand and extra Super Stretch Hose. Optional tools are available for sale for any NV22L model: 1-800-798-7398.
Getting Started
a c e*
4
5
3
7
2
g
hi*
b
f
d*
Your Shark
®
Navigator Upright
is easy to assemble:
1 Lay your vacuum body on a
level surface.
2 Slide the electrical connection
from the power nozzle into the main body to click into place.
3 Connect the hose from the main
body to the power nozzle; push with a slight turning motion to create a snug fit.
4 Slide the handle assembly
into the upright unit aligning the hose hook on the handle assembly with the power cord hooks on the back of the unit.
5 Secure the handle assembly in
place with included nut/bolt (shipped attached to handle assembly).
6 Place the vacuum in the upright
position.
7 Store the Crevice Tool, Dusting
Brush and Cleaning Wand on the unit.
5www.sharkclean.com
English
10 To carry the vacuum:
With the unit in the standing
position, lift by the Dust Cup Assembly Handle (carry handle).
CAUTION: When lifting or
carrying, DO NOT press Dust Cup Assembly release button.
c
8 9
b
d
8 Attach the Super Stretch Hose:
a) Snap hose into swivel
connector
b) Route under anti-tip hook c) Route over upper hose
holder
d) Press securely onto cleaning
wand
IMPORTANT:
To prevent vacuum from tipping, secure hose under the anti-tip hose hook.
9 When storing your vacuum,
wind cord around the two cord holders and secure with cord clip:
• Quick Cord release at the top of the unit – place in the upright position.
• Second holder near the base – turn until it is pointing down.
To release the cord, turn the Quick
Cord release to the left or right.
IMPORTANT:
For suction to reach the Floor Power Nozzle, the Cleaning Wand and Super Stretch Hose must be attached securely on the vacuum body.
6
TOLL FREE: 1-800-798 -7398
Using the Vacuum
Your Shark® Navigator Upright Vacuum is a versatile tool that can be used to clean bare floor surfaces or carpets – with the click of a switch.
Stand the vacuum into the upright position.
Plug in the vacuum.
1 Start with the Power Switch in
the “O Off” position.
2 Place your foot on the Floor
Power Nozzle and pull handle towards you.
3 Set the Power Switch to desired
cleaning setting.
4 When cleaning bare floors:
Select the “I On” position for
suction only cleaning to avoid scattering dirt while cleaning.
When cleaning carpets:
Ensure you have pulled the
handle towards you and select the “II Brush Roll On” position to agitate the carpet fibers for deeper cleaning performance.
IMPORTANT:
To protect your carpets, the Brush Roll will only turn on when you have pulled the handle back towards you and released the Floor Power Nozzle.
IMPORTANT:
Your Brush Roll Indicator Light will illuminate solid green when brush roll is on, or solid red if there is a blockage. This feature is designed to protect your Lifetime Belt that powers your Brush Roll. See Checking for Blockages on page 11.
NOTE: The height of your power
nozzle has been optimized for easy pushing and superior clean­ing on all floor types, so there is no need to make any height adjustments as you transition to different floor & carpet types.
1 4
OFF
Indicator Light
Bare Floors / Tools
Carpets
7www.sharkclean.com
English
Cleaning with the Vacuum Accessories
Before cleaning with your accessories:
Stand vacuum into upright position.
Secure Super Stretch Hose in the anti-tip hose hook to prevent tipping.
Select the “I On” position for suction only cleaning.
DO NOT pull vacuum cleaner
around by the hose.
DO NOT overextend the hose.
Vacuum Accessories
Your vacuum comes with a Super Stretch Hose and Cleaning Wand. Use one or the other to attach your cleaning accessories.
1 Using the Super Stretch Hose:
Stand the vacuum into upright
position.
Remove the hose from the
Cleaning Wand.
Push the selected tool into the
hose connector.
2 Using the Cleaning Wand:
Stand the vacuum into upright
position.
Remove the Cleaning Wand
(with hose attached) from the unit.
Push the selected tool into the
end of the Cleaning Wand.
2
3
4
5
6
1
3
4
5
6
3 Pet Hair Power Brush 4 Dusting Brush 5 Crevice Tool 6 24” Crevice Tool
Extreme Reach Cleaning Kit
Models NV22LCO and NV22LA come with an extra Cleaning Wand, extra Super Stretch Hose and the Hard Surface Brush.
Model NV22LE comes with an extra Cleaning Wand and extra Super Stretch Hose.
Increases your cleaning reach to over 27 feet!
To order additional parts and accessories, go to www.sharkclean.com or call 1-800-798-7398.
Extreme Reach
Cleaning Kit
8
TOLL FREE: 1-800-798 -7398
Emptying the Dust Cup Assembly
For best results empty the Dust Cup Assembly after each use; empty sev­eral times during prolonged usage.
Or empty the Dust Cup Assembly when it reaches the MAX fill line;
NEVER OVER-FILL THE DUST CUP.
Stand vacuum into upright position.
Turn vacuum off.
To empty the Dust Cup Assembly:
1 Grip carry handle and press
the Dust Cup release button to remove Dust Cup Assembly
2 Option A: for Quick Empty:
Insert Dust Cup Assembly deep inside trash receptacle to contain dust and debris.
Press the Dust Cup Door release
button; tap container gently to dislodge and release dust and debris.
Snap door in place. Important: If the Dust Cup
Door does not swing open after pressing the release button, push the door open using the bottom door tabs.
CAUTION:
Unplug the vacuum; failure to do so might result in electric shock.
3 Option B: For Allergy Sufferers:
Wrap a trash bag around the Dust Cup Assembly leaving space at the bottom for the door to swing open.
Locate the Dust Cup Door
release button within the trash bag and press to release as you shake the dust cup to empty dust and debris.
Snap the bottom door in place. Note: Option B can also be
performed outside of the home to further minimize releasing dust back into the air. Carry just the Dust Cup Assembly and trash bag outside.
Note: Some dust and debris
may remain in the top of your dust cup assembly on or near the metal screen. It is not necessary to completely remove this material before continuing to vacuum; Shark
®
advanced cyclonic action will sweep the metal screen clean once you begin to refill your dust cup.
1 2 3
Loading...
+ 22 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use