Shark Navigator Pet Pro ZU60 Quick Start Manual
Remove dust cup to access foam
and felt filters. Next, press down
top of filter door. Tilt filter door
and lift out. Press tab at top of
HEPA filter and pull away from the
base of the vacuum.
To reinstall, insert HEPA filter into
unit and replace the filter door.
Wash filters every 3 months to keep the suction strong.
Rinse filters with water only and allow to air-dry completely.
Tap loose dirt from foam filters as needed between washes.
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
AS SE M BLY
A
Vacuum
B
Handle & Hose
C
Wand
D
Hose Holder
E
5.5” Crevice Tool
F
Upholstery Tool
WHAT’S INSIDE EMPTYING THE DUST CUP
MAINTENANCE
QUICK START GUIDE
Empty the dust cup af ter each use.
clean
A
B
C
F
D
E
Brushroll access
Unlock Open Cover Clear Intake
Use a coin to turn locks, then lift
cover open. Clear the debris intake.
Shark’s Zero-M™ self-cleaning brushroll delivers non-stop
hair removal. Remove any blockages or objects stuck on or
around the brushroll.
If any hair is wrapped around brushroll, extending cleaning
time will help it clear.
(Click)
(Click)
(Click)
(Click)
NOTE: For proper operation, ensure all parts
are firmly CLICKED into place.
Pos t-Moto r
Filter
Cover
latch
Foam
Felt
Navigator™ Pet Pro
2 WAYS TO CLEAN
FLOOR CLEANING
ABOVE-FLOOR CLEANING
For questions or to register your product, contact us at 1-800-798-7398 or visit us online at sharkclean.com
@sharkcleaning
OR
HARD FLOOR
Press switch to I for
hard floor surfaces.
CARPET
Press switch to II
for low and high pile
carpet cleaning.
SUCTION CONTROL
Adjust your suction depending
on your floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on bare floors.
Attach desired
cleaning accessory
to handle or wand.
For additional parts and accessories visit sharkaccessories.com
OR
To clean above-floor areas, remove the
handle from the wand. For even more
reach, remove the wand from the pod.
1
1 2
2 3
To engage brushroll, step on floor
nozzle and tilt handle back.
ZU60_ QSG _ MP_ Mv3
Loading...