Shark NAVIGATOR LIFT-AWAY PRO Quick Start Manual
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your vacuum.
®
LIFT-AWAY
QUICK START GUIDE
WHAT’S INSIDE UPRIGHT VACUUM
A Handle
B Stretch Hose
C Portable Lift-Away
D Motorized Floor Brush
E Extension Wand
F Dusting Brush
G Acessory Holder
H Crevice Tool
I Pet Power Brush
J Extension Wand
ASSEMBLY
™
PRO
A
F
G
1 Attach floor nozzle (D) into the bottom of the
B
H
canister (C).
2 Insert extension wand (E) into the back of the
canister, slide on the accessory holder (G) and place
the on-board tools (F, H ).
3 Insert handle (A) into the top of the extension wand
and connect the hose (B) to the back of the canister.
E
PORTABLE LIFT-AWAY
I
C
J
K
D
1 Press handle release button to detach handle (or
handle with extension wand).
2 Press red nozzle release button (K), place foot on
nozzle and pull the canister up.
3 Attach desired tools to clean.
USE AND CARE
IM PO RTA NT: Loss of suction may occur if
foam filters are not cleaned every 3 months.
Rinse and allow to air dry completely. Also,
tap loose dirt o filter between washes
as needed. Foam filters may appear dirty
after use - this is normal. Please refer to the
instruction booklet the for instructions on
cleaning the filters.
BRUSHROLL
BRUSHROLL ON
Engage the motorized
floor brush to vacuum
carpets and rugs.
BARE FLOOR
Use to vacuum in LiftAway™ mode, to vacuum
bare floors, or to use tools
(straight suction only).
OFF
To engage the brushroll, press
the floor nozzle down with
your foot and tilt the handle
back towards you.
INDICATOR LIGHT
SUCTION CONTROL
This vacuum has huge suction power. The suction can
be adjusted to make the vacuum easier to push and
pull on certain types of carpets as needed.
Adjust the amount of suction by rotating the suction
release collar on the handle counterclockwise to
reduce the suction or clockwise for maximum suction.
EMPTYING THE DUSTCUP
1 Pull up the latches on the sides of the dust cup
to release.
2 Hold the dust cup over a trash receptacle and
press the bottom door release button.
3 If needed, turn the dust cup upside down over
the trash and press the top door release button.
CLEANING FILTERS
1 With the dust cup removed, pull
the 2 filters out from the top of the
motor base.
2 Rinse the filters thoroughly in
lukewarm water until the water runs
The motorized brush indicator light will illuminate
Green when motorized floor brush is on. If there is a
blockage or jam, the light will turn Red.
UV541CCO_QSG_EN_REV_Mv1
For questions or to register your product visit us online at sharkclean.com ©2018 Shark Operating LLC
clear.
3 Squeeze out excess water and let
air-dry for at least 24 hours before
inserting back into the vacuum.
Loading...