Shark Lift-Away Owner's Manual

®
LIFT-AWAY
LA300 Series • Série • Serie
ADV
OWNER’S GUIDE GUIDE DE L’UTILISATEUR GUÍA DEL PROPIETARIO
IMPORTANT SAFETY INSTRUCTIONS
FOR HOUSEHOLD USE ONLY • PLEASE READ CAREFULLY BEFORE USE If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. DO NOT force into outlet or try to modify to fit.
WARNING
To reduce the risk of fire, electric shock, injury, or property damage:
GENERAL WARNINGS
1. Your vacuum cleaner may consist of
a motorized nozzle, wand, hose, and/ or vacuum pod. This device contains electrical connections, electrical wiring, and moving parts that potentially present risk to the user.
2. Use only identical replacement parts.
3. Carefully observe and follow the
instructions provided below to avoid improper use of the appliance. DO NOT use the vacuum for any purpose other than those described in this manual.
4. Before use, carefully inspect all parts for any damage. DO NOT use if any parts are damaged.
5. The use of an extension cord is NOT recommended.
6. This vacuum cleaner contains no serviceable parts.
USE WARNINGS
7. This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children.
8. Keep the appliance and its cord out of reach of children. DO NOT allow the appliance to be used by children. DO NOT allow to be used as a toy. Close supervision is necessary when used near children.
9. Always turn off the vacuum cleaner
before connecting or disconnecting any motorized nozzles or other accessories.
10. DO NOT handle plug or vacuum
cleaner with wet hands.
11. DO NOT use without filters in place.
12. Only use Shark® branded filters and
accessories.
13. DO NOT damage the power cord: a) DO NOT pull or carry vacuum
cleaner by the cord or use the cord as a handle.
b) DO NOT unplug by pulling on cord.
Grasp the plug, not the cord.
c) DO NOT run the vacuum cleaner
over the power cord, close a door on the cord, pull the cord around sharp corners, or leave the cord near heated surfaces.
14. DO NOT put any objects into nozzle or accessory openings. DO NOT use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow.
15. DO NOT use if nozzle or accessory airflow is restricted. If the air paths or the motorized floor nozzle become blocked, turn the vacuum cleaner off and unplug from electrical outlet. Remove all obstructions before you plug in and turn on the unit again.
16. Keep nozzle and all vacuum openings away from hair, face, fingers, uncovered feet, or loose clothing.
17. DO NOT use if vacuum cleaner is not
working as it should, or has been dropped, damaged, left outdoors, or dropped into water.
18. Use extra care when cleaning
onstairs.
19. DO NOT leave the vacuum cleaner
unattended while plugged in.
20. When powered on, keep the
vacuum carpet surface damaging the carpet fibers.
21. DO NOT place vacuum cleaner on
unstable surfaces such as chairs or tables.
22. Your Shark® vacuum may not be
designed to stand up on its own. When taking a break from cleaning, you may need to lean it against furniture or a wall, or lay it flat on the floor. Using the vacuum for an application where the unit lacks stability may result in personalinjury.
23. DO NOT use to pick up: a) Liquids b) Large objects c) Hard or sharp objects
d) Large quantities of dust (drywall
e) Smoking or burning objects (hot
f) Flammable or combustible
g) Toxic materials (chlorine bleach,
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
cleaner moving over the
at all times to avoid
(glass, nails, screws, or coins)
dust, fireplace ash, or embers). DO NOT use as an attachment to power tools for dust collection.
coals, cigarette butts, or matches)
materials (lighter fluid, gasoline, or kerosene)
ammonia, or drain cleaner)
24. DO NOT use in the following areas: a) Poorly lit areas b) Wet or damp surfaces c) Outdoor areas d) Spaces that are enclosed and may
contain explosive or toxic fumes or vapors (lighter fluid, gasoline, kerosene, paint, paint thinners, mothproofing substances, or flammable dust)
25. Turn off all controls before plugging
in or unplugging the vacuum.
26. Unplug from electrical outlet
when not in use and before any maintenance or cleaning.
27. Hand wash with water only. Washing
with cleaning chemicals could damage the unit.
28. During cleaning or routine maintenance, DO NOT cut anything other than hair, fibers, or string wrapped around the brushroll.
29. Allow all filters to air-dry completely before replacing in the vacuum to prevent liquid from being drawn into electric parts.
30. Make sure the dust cup and all filters are in place after routine maintenance.
31. If provided, secure the power cord around the two cord hooks during storage.
SAVE THESE INSTRUCTIONS
sharkclean.comsharkclean.com
1
(Click)
ASSEMBLY ASSEMBLY
2
(Click)
Upper Cord Hook
Tool Storage Posts
3
(Click)
Lower Cord Hook
1. Insert Wand into pod
2. Insert Handle into wand.
3. Attach Hose to back of vacuum pod.
For proper operation, ensure all parts are firmly clicked into place.
POWER CORD
UPPER CORD HOOK CORD HOLDER
For cord access, rotate upper hook down and remove cord.
Use cord holder on the side of wand to hold cord in place while vacuuming.
sharkclean.comsharkclean.com
WHOLE-HOME CLEANING
WHOLE-HOME CLEANING
POWER/SURFACE SWITCH
Select surface setting:
O Power O I Hard Floor
For hard floors and small area rugs.
II Carpet
For carpets.
NOTE: Brushroll spins in all modes
SETTINGS
SUCTION CONTROL
The Suction Control Slider located on the handle allows you to adjust the suction depending on the floor type.
MIN: to reduce suction and increase maneuverability on carpets.
MAX: to increase suction on hard floors.
BRUSHROLL INDICATOR LIGHT
CLEANING MODES
UPRIGHT MODE LIFT AWAY MODE
To engage Brushroll, step on floor nozzle and tilt handle back firmly.
Step on the pedal on the floor nozzle to lift o the pod.
Wand
Release
INDICATOR LIGHT
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN? Solid Green: The brushroll is spinning and working as intended. Solid Red: There is a jam in the brushroll area. Turn o and unplug the vacuum and remove any
blockages in the nozzle. Flashing Red: The motorized floor nozzle is overheating. Turn the vacuum o and wait a
minimum of 60 minutes for the unit to cool down.
ABOVE-FLOOR—HANDLE
Press the Handle Release button and pull up on the handle to detach it from the wand.
ACCESSORIES—HANDLE
ABOVE-FLOOR—WAND
Press the Wand Release button and pull up on the wand to detach it from the pod.
ACCESSORIES—WAND
Attach an optional cleaning accessory to handle or wand.
NOTE: All accessories are compatible with both the wand and the handle. Included accessories will vary by model.
sharkclean.comsharkclean.com
EMPTYING THE DUST CUP
CLEANING THE FILTERS
IMPORTANT: Unplug the power cord before performing any maintenance.
To remove Dust Cup, pull up on the release button located on the side of dust cup handle. Tilt dust cup forward, then lift to remove.
Hold the dust cup over the receptacle and press the release button to open bottom of dust cup.
Regularly rinse the filters to maintain your vacuum's suction power.
Rinse filters with cold water only. Allow all filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electronic parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam
Felt
Post-Motor HEPA Filter
RINSE HEPA FILTER
EVERY YEAR
RINSE PRE-MOTOR FILTERS
EVERY MONTH
Remove Dust Cup, then lift out Filters.
Filter Door
To remove the HEPA Filter, first pull the tab on the bottom of the filter door, then lift o the door. Press the tab on the side of the HEPA filter and pull out the filter.
To reinstall the door, align the top first, then press in the bottom until it clicks into place.
To remove collected debris from Lint Screen, lift the tab at the top of the dust cup to open the lid. Remove debris from lint screen toclean.
To reinstall, place the bottom of dust cup onto the pod and then tilt until it clicks into place.
sharkclean.comsharkclean.com
MAINTENANCE
NOZZLE MAINTENANCE
CHECKING FOR BLOCKAGES
DEBRIS WRAPPED
AROUND BRUSHROLL
Clean o any debris on the bristles. Carefully use scissors within the brushroll groove to cut away any hair or debris wrapped around the brushroll.
NOZZLE BLOCKAGES
Check the opening at the top of the nozzle for any blockages.
DUST CUP BLOCKAGES
Detach dust cup from vacuum pod. Empty dust cup, remove debris from lint screen, and check for blockages.
HOSE BLOCKAGES
Detach hose from handle by pressing on the release button at the top of the hose. Detach the hose from the pod, and check openings for blockages.
WAND BLOCKAGES
Detach wand from pod and handle, and check both ends for blockages.
HANDLE BLOCKAGES
Detach handle from wand and check openings for blockages.
sharkclean.comsharkclean.com
AVAILABLE ACCESSORIES TROUBLESHOOTING
Crevice Tool
A
This slender tool oers extended reach to access corners, baseboards, tight spaces, and ceilings.
B
Upholstery Tool
Picks up hair, dust, and large debris from mattresses, couches, curtains, lampshades, and other delicate upholstered surfaces.
Dusting Brush
C
This brush dusts and cleans delicate surfaces. Great for use on fans, blinds, lampshades, and keyboards.
Duster Crevice Tool
D
Two cleaning tools in one. The crevice tool gives you extended reach to clean in tight spaces, while the soft brush is ideal for dusting delicate surfaces.
Pet Multi-Tool
E
A single convertible tool for cleaning tough pet messes two ways: use the sti bristle brush to clean stuck-on debris, or take o the bristles to reveal an upholstery tool perfect for removing stubborn pet hair and large piles of debris.
A
C
E F
B
Check filters to see if they need cleaning. Follow instructions for rinsing and air-drying the
filters before reinstalling them in the vacuum.
Dust cup may be full; empty dust cup.
Check handle, hose, hose connections, nozzle, wand, pod, and accessories for blockages.
Clear any blockages found.
If any string, hair, or carpet fibers are wrapped around the brushroll, carefully cut debris with
scissors and remove from brushroll. See Nozzle Maintenance section for more information.
Vacuum lifts area rugs.
Make sure Power/Surface switch is set to Hard Floor (setting I).
Vacuum is not picking up debris. No suction or light suction.
D
Ensure the suction control slider on the handle is set to MIN.
Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn edges.
Brushroll does not spin in carpet cleaning mode.
If the Brushroll Indicator Light turns red, immediately turn o and unplug the vacuum.
Remove pod from floor nozzle and clear any blockages. Reconnect nozzle, plug in vacuum, and turn on power.
With the power on, recline the handle, which will automatically turn on the brushroll.
• If this problem persists on thick carpets, move the suction control slider to MIN.
Vacuum turns o on its own or indicator light flashes red.
If your vacuum overheats, the thermostat will automatically turn the suction motor o. Perform the following steps to restart thethermostat:
1. Turn vacuum o and unplug it.
2. Empty dust cup and clean filters (see Emptying the Dust Cup and Cleaning the Filters).
3. Check for blockages in hose, nozzle, accessories, and inlet openings.
4. Allow unit to cool for a minimum of 60 minutes.
5. Plug in vacuum and restart with the Power/Surface switch.
Pet Power Brush
F
The turbine brush loosens and removes
G
pet hair and debris from carpets, and powerfully deep-cleans dander out of upholstery and other surfaces.
Self-Cleaning Pet Power Brush
G
Tackles pet hair and ground-in dirt from above-floor areas like carpeted stairs and upholstery, while actively removing hair wrap as it cleans.
NOTE: Not all accessories come with all units. For a list of the accessories included with this model, see the top inside flap of the box. To order additional accessories, visit sharkaccessories.com.
For all other issues, please visit sharkclean.com/support.
sharkclean.comsharkclean.com
Loading...
+ 16 hidden pages