Shark DuoClean IONFlex 2X Quick Start Manual

Please make sure to read the enclosed Shark® Owner’s Guide prior to using your vacuum.
Wand
Release
MULTIFLEX STORAGEMULTIFLEX™ REACH
Press the MultiFLEX Lock Release button to lower the angle of the wand to increase your reach.
EMPTYING THE DUST CUP
1. To empty dust
cup, first remove the handvac from the wand by pressing the Wand Release button and pulling up on the handvac.
MultiFLEX
Lock Release
Carry Handle
Press the MultiFLEX Lock Release button and hold it down while folding the handvac forward, until the unit locks in storage mode.
To vacuum, press the MultiFLEX Lock Release button while lifting up the handvac, until the wand locks in place.
2. Position dust cup over a trash bin, then open the bottom of the dust cup by pressing the Dust Cup Release button on the side.
IONFLEX
CORD-FREE ULTRA-LIGHT
QUICK START GUIDE
Use this Quick Start Guide to start using your new vacuum’s great features.
2X
Wand Rel ease
Button
@sharkcleaning
©2018 S harkNinja Operating LLC. SHARK is a registered tra demark of S harkNinja Operating LLC. DU OCLEA N, MULTIFLEX, IONFLEX, and SMART RESPONSE are trademarks of SharkNinja Op erating LLC .
Dust Cu p
Release Button
IF251C_XXXXXX
Register your vacuum at
registeryourshark.com
IF251C
WHAT’S INSIDE:
A
Handheld Vacuum
B
Motorized Floor Nozzle
C
MultiFLEX™ Wand
D
Dusting Brush
AS SE MB LY
A
SMART RESPONSE™ TECHNOLOGY
Press the Surface Settings button to switch floor types. Press the Suction Settings button to intelligently switch between EXTEND RUNTIME and MAX POWER.
Surface Settings Power Button Suction Settings
CARPET
For high pile carpets.
EXTEND RUNTIME
For everyday cleaning.
E
Anti-Allergen Duster Crevice Tool
F
Anti-Allergen Dust Brush
G
Wide Upholstery Tool
H
ION Power Pack (x2)
I
ION Power Pack Charger
J
ION Power Pack Charging Dock
FE GD
IH J
FLOOR
For bare floors and area rugs.
heavy-duty cleaning.
MAX POWER
Maximum power for
3
(Click)
NOTE: Fo r deep clea ning per ASTM F 608 (embedded di rt in carpets) pleas e select CARPET and M AX POWER settings.
C
In Use
2
(Click)
Full Charge
Mid Charge
Charging
Low Charge
NOTE: Full charge t akes approximately 3. 5 hours .
Mid Charge
1
B
(Click)
ION POWER PACK
Low Charge
Nearly Full
Nearly Empty
Full Charge
No Charge
VERSATILE CHARGING
Battery Indicator
Lights
NOTE: I ON Power Pack
comes with a partial charge. Fully charge prior to fi rst use and then compl etely discharge to condi tion the pack.
For complete maintenance instructions, see the enclosed Owner's Guide.
For additional parts and accessories, visit sharkaccessories.com.
For additional batteries and charging accessories, visit sharkclean.com/batteries.
IN A CHARGING DOCKOUT OF THE VACUUMIN THE VACUU M
Easily Insert or Remove the ION Power Pack
To insert, slide the ION Power Pack into the slot in behind the dust cup.
To remove, pinch the release tab then slide out the ION Power Pack.
Loading...