MULTIFLEX® REACH |
|
MULTIFLEX STORAGE |
|
|
|
Press the MultiFLEX Lock Release button to lower the angle of the wand to increase your reach.
To store, press the MultiFLEX Lock Release button and fold the handheld vacuum forward.
To vacuum, press the release button and lift up the handheld vacuum, until the wand locks in place.
MultiFLEX
Lock Release
EMPTYING THE DUST CUP
1. To empty the dust cup, |
2. Position the dust |
first disconnect the |
cup over a trash |
handheld vacuum from |
bin and slide the |
the wand by pressing |
CleanTouch™ Dirt |
the Wand Release |
Ejector forward. |
button and pulling |
|
up on the handheld |
|
vacuum. |
|
CleanTouch
Dirt Ejector
Wand Release
Button
Please make sure to read the enclosed Shark® Owner’s Guide prior to using your vacuum.
ROCKET® PRO
CORDLESS MULTIFLEX® VACUUM
QUICK
START
GUIDE
For questions, visit us online at sharkclean.com/support
Register your vacuum at registeryourshark.com
|
|
|
|
|
|
|
|
|
|
|
|
© 2020 SharkNinja Operating LLC. MULTIFLEX, SHARK, and ROCKET are registered trademarks of SharkNinja |
|
||||
Operating LLC. CLEANTOUCH and DIRT ENGAGE are trademarks of SharkNinja Operating LLC. |
IZ163H |
||||
|
|
|
IZ163H_QSG_E_MP_Mv2 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
WHAT’S INSIDE: |
ASSEMBLY |
A Handheld Vacuum |
|
B Dirt Engage™ Floor Nozzle |
A |
|
CMultiFLEX® Wand
DPet Multi-Tool
ECrevice Tool
FCharger
G Li-Ion Battery (Pre-Installed)
H HEPA Post-Motor Filter (Pre-Installed)
D E F
C
2
(Click)
G H
B |
1 |
|
|
|
(Click) |
For complete maintenance instructions, see the enclosed Owner's Guide. For additional parts and accessories, visit sharkaccessories.com.
For additional batteries and charging accessories, visit sharkclean.com/batteries.
POWER SETTINGS
OFF |
BARE FLOOR |
CARPET SETTING |
BOOST MODE |
|
SETTING |
||||
|
|
|
||
Slide switch to the |
Bare Floor/Area Rugs |
Carpet |
For an added boost in |
|
top to turn off power. |
Slide switch to the |
Slide switch to the |
power, pull the Trigger |
|
To begin vacuuming |
middle. The brushroll |
bottom. The brushroll |
on the handheld |
|
in Standard Mode, |
spins slowly to clean |
spins faster to pick up |
vacuum. Release it |
|
slide switch to the |
bare floors and small |
debris below the surface |
to return to standard |
|
appropriate setting. |
area rugs. |
of your carpets. |
power. |
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the trigger to go into Boost mode.
NOTE: Select Carpet setting for stuck-on dirt and debris.
CHARGING
Easily Insert or Remove the Li-Ion Battery
To insert, slide the Battery into the slot in the back of the handheld vacuum. To remove, press and hold the
Battery Release Button then slide out the battery.
IN THE |
OUT OF |
BATTERY RELEASE |
BATTERY |
INDICATOR |
|||
VACUUM |
THE VACUUM |
BUTTON |
LIGHTS |
LI-ION BATTERY
In Use
Full |
Mid |
Low |
Nearly |
No |
Charge |
Charge |
Charge |
Empty |
Charge |
Charging |
|
|
|
|
Low |
Mid |
Nearly |
Full |
|
Charge |
Charge |
Full |
Charge |
|
NOTE: Full charge takes approximately 3 hours.
NOTE: The battery comes partially charged. Charge fully before first use.
Battery Runtime
MODE |
MINUTES |
|
Hand Vac |
40 |
|
Bare Floor/ |
25 |
|
Standard Mode |
||
|
||
Carpet Mode/ |
20 |
|
Standard Mode |
||
|
||
Boost Mode |
10 |
|
(Hand Vac) |
||
|
© 2020 SharkNinja Operating LLC.