SHARK CH950UKT User manual

CORDLESS HANDVAC

CH950UKT

IMPORTANT SAFETY INSTRUCTIONS – FOR HOUSEHOLD USE ONLY

READ CAREFULLY BEFORE USE – SAVE THESE INSTRUCTIONS

WARNING

To reduce the risk of injury, fire, electric shock, and property damage resulting from improper use of the appliance, carefully observe the following instructions. This unit contains electrical connections and moving parts that potentially

present risk to the user.

POWER SUPPLY, CHARGING DOCK, AND VACUUM CONTAIN ELECTRICAL CONNECTIONS:

1There are NO serviceable parts.

2DO NOT use to vacuum any liquids.

3DO NOT immerse in water or other liquids.

4If vacuum is damaged, discontinue use.

5To avoid fire, explosion, or injury, inspect vacuum and charging dock for any damage before use. DO NOT use damaged vacuum or charging dock.

6DO NOT use outdoors or on wet surfaces. Use only on dry surfaces.

7If vacuum cleaner is not working as it should, or has been dropped, damaged, left outdoors, or immersed in water, return it to SharkNinja for examination, repair, or adjustment.

8DO NOT handle charger or vacuum cleaner with wet hands.

9DO NOT leave vacuum cleaner unattended while powered on.

10Keep vacuum away from heated surfaces.

11Always turn off vacuum before connecting charging dock.

12Use only Shark® chargers and batteries. Other types of batteries may burst, causing injury and damage.

13Use charging dock on flat and stable surfaces only.

14DO NOT incinerate appliance, even if it is severely damaged, as lithium-ion battery may explode in a fire.

GENERAL USE

15DO NOT carry the charger by the cord or pull to disconnect from a socket; instead grasp the plug and pull to disconnect.

16Keep charger cord away from heated surfaces.

17Use only as described in this manual.

18Keep your work area well lit.

19To avoid unintentional starting, always turn off the vacuum cleaner before picking it up or carrying it, and before attaching or detaching the charger, dust cup, filter, or any accessories.

20DO NOT put any objects into openings.

21DO NOT use if any opening is blocked; keep free of dust, lint, hair, or anything that may reduce airflow.

22IMPORTANT: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

23DO NOT use without dust cup and filter in place.

24DO NOT use if airflow is restricted; if the air paths become blocked, turn off the vacuum cleaner. Clear all obstructions and power on again.

25Keep nozzle away from hair, face, fingers, uncovered feet, or loose clothing.

26Only use manufacturer’s recommended attachments.

27DO NOT charge at temperatures below 10°C (50°F) or above 40°C (104°F). Charging improperly or at temperatures outside of the specified range may damage the battery and increase the risk of fire.

28Store the appliance indoors. DO NOT use or store it below 3°C (37.4°F). Ensure the appliance is at room temperature before operating.

DUST CUP/FILTERS/ACCESSORIES

Before turning on the vacuum:

29Make sure dust cup and filter are in place after routine maintenance.

30Make sure accessories are free of blockages and keep openings away from face and body.

31Use only Shark® brand filters and accessories. Using other brands will void warranty.

GENERAL CLEANING

32DO NOT vacuum up hard or sharp objects such as glass, nails, screws, or coins that could damage the vacuum cleaner.

33DO NOT vacuum up drywall dust, fireplace ash, or embers.

34DO NOT use as an attachment to power tools for dust collection.

35DO NOT vacuum up smoking or burning objects such as hot coals, cigarette butts, or matches.

36DO NOT vacuum up flammable or combustible materials (e.g., lighter fluid, gasoline, or kerosene) or use vacuum in areas where they may be present.

37DO NOT vacuum up toxic solutions (e.g., chlorine bleach, ammonia, or drain cleaner).

38DO NOT use in an enclosed space where vapours are present from paint, paint thinner, moth-proofing substances, flammable dust, or other explosive or toxic materials.

39DO NOT immerse vacuum cleaner in water or other liquids.

40Use extra care when cleaning on stairs.

LITHIUM-ION BATTERY

41The battery is the power source for the appliance. DO NOT carry the appliance with your finger on the power button. DO NOT charge appliance with the power on.

42Use only E-TEK Electronic Manufactory Ltd ZD012A133075BS charger or Dongguan Dongkun Power Technology Co. Ltd DK12-133075A-B charger. Use of an incorrect charger may result in no charging, and/or unsafe conditions.

43Use appliance only with included lithium-ion battery. Use of any other battery may create a risk of injury and fire.

44Under abusive conditions, liquid may be ejected from the battery. Avoid contact with liquid, as it may cause irritation or burns. If contact occurs, flush with water. If liquid contacts eyes, seek medical help.

45Store the appliance indoors. To maintain battery life, DO NOT use or store battery at temperatures below 3°C (37.4°F) or above 40°C (104°F).

46DO NOT expose appliance to fire or temperature above 130°C (266°F) as it may cause explosion.

47There are NO serviceable parts. To ensure safety, DO NOT modify or attempt to repair the appliance.

GETTING TO KNOW YOUR VACUUM

A Nozzle		H	Charging Adapter
B	Dust Cup	I	Motorised Pet Tool
C	Dust Cup Release Button	J	Crevice Tool
D Washable Filters + Filter		K Dusting Brush
	Frame

ECharging Indicator Light

FOn/Off Switch

GVacuum Body

A	H
B
	I
C

D

J

G

E

F

K

CHARGING YOUR SHARK® VACUUM
1	1.	Insert the charging
		adapter plug into
		the port on the
		handle.
2	2.	Plug the charging
		adapter into a
		socket. The charging
		indicator light will
		blink. Light will
		go out when fully
		charged.
	NOTE: Lithium-
	ion battery takes
	approximately 4 hours
	to charge completely.

USING YOUR SHARK® VACUUM

1

2

3

4

1.Press power button.

2.Run the nozzle over the surface to be cleaned.

3.To empty dust cup, hold your vacuum over a bin.

4.Press the easy empty button to release the debris.

NOTE: For maintenance, see reverse side.

ACCESSORIES

ATTACHING AND REMOVING

1

2

1.To attach an accessory, align it with the nozzle, then slide it on.

2.To remove an accessory, slide it straight off the nozzle.

		TROUBLESHOOTING
	Problem	Solution
	The vacuum	Battery needs to be recharged. Lithium-ion battery takes approximately
	will not	4 hours to charge completely.
	operate	Try using a different socket to charge.
		The metal contact pins on the motorised brush are not in contact with
	Motorised	the connector slots on the vacuum. Remove the motorised brush and
	brush will	reinsert firmly into the air-intake nozzle.
	not work	The motorised brush is blocked. Carefully remove all lint, hair, or other
		debris from the motorised brush.
	Vacuum will	Dust cup is full. Empty the dust cup.
	not pick up	Filters need cleaning or replacement. Clean or replace the filters.
	or suction is
		Vacuum needs to be recharged.
	weak
		Empty the dust cup.
	Dust is	The filters are not installed correctly. Remove filters, then reinstall them.
	escaping from	A filter has a hole or a puncture and needs to be replaced.
	the vacuum	An obstruction may be blocking the dust cup lid, keeping it from closing
		correctly. Clear any obstructions and ensure the lid is completely closed.

		BATTERY INDICATOR
No Light	Low		Press the power button. If the unit doesn't turn on, then
	Battery		the battery power is too low. Please charge before use.
Slow Flashing	Vacuum		To charge the vacuum, connect charging cord to unit and
Light (while			plug into the socket. The light will fade in and out slowly
	Charging
plugged in)			as the vacuum charges.
Fast Flashing	Low		If the light flashes quickly while the unit is in use, the
Light (in use)	Battery		battery power is low. Recharge the unit.
Solid Light	Fully		When the vacuum is fully charged, the indicator light will
			illuminate steadily, then turn off. (It takes approximately
	Charged
			4 hours for a full charge).
Five Flashes	Not		If the wrong charger is used, the light will blink five times
(after
	Charging		and then stop. Use the included charger.
plugging in)

MAINTENANCE

CLEANING THE DUST CUP

1

3

5

2

4

6

1.Press the dust cup release button and pull out the dust cup.

2.Carefully remove the filter frame.

3.To open and empty the dust cup, hold it over the bin, then press the easy empty button (complete instructions on reverse side).

4.Hand-wash the filters in cold water and let them air-dry for at least 24 hours before reinstalling. Air-dry only. DO NOT use a hair dryer or clothes dryer.

5.To clean the interior of the dust cup, rinse it with water. Place it on its side with the lid open to air-dry for at least 24 hours before reinstalling.

6.When filters are dry, reinsert them into the filter frame (foam first), reinstall the filter frame into the dust cup, then reattach the dust cup.

DO NOT wash any parts or accessories in a dishwasher. NOTE: For replacement filters please visit sharkclean.co.uk

REGISTER YOUR PURCHASE

sharkclean.co.uk/register-guarantee

Scan QR code using mobile device

TECHNICAL SPECIFICATIONS

Battery Voltage: 10.8V	E-TEK ZD012A133075BS
Motor Watts: 100W	DS/DK DK12-133075A-B

TWO-YEAR LIMITED GUARANTEE

When a consumer buys a product in the UK, they get the benefit of legal rights relating to the quality of the product (your “statutory rights”). You can enforce these rights against your retailer. However, at Shark we are so confident about the quality of our products that we give you an additional manufacturer's guarantee of up to two years (1 year as standard plus 1 year when you register). These terms and conditions relate to our manufacturer's guarantee only - your statutory rights are unaffected.

Every Shark machine comes with a free parts and labour guarantee. Our customer service helpline (0800 862 0453) is open from 9.00am to 6.00pm Monday - Friday. It's free to call, and you'll be put straight through to a Shark representative. You'll also find online support at www.sharkclean.co.uk.

How do I register my extended Shark® guarantee?

You can register your guarantee online within 28 days of purchase. To save time, you'll need the following information about your machine:

•Model Number

•Serial Number (only if available)

•Date you received the machine (from your in-store receipt or delivery note) To register online, please visit www.sharkclean.co.uk/register-guarantee

IMPORTANT

•The manufacturer's guarantee covers your product for 12 months (or for 2 years, if registered) starting on the date of delivery.

•Please keep your receipt at all times. Should you need to use your guarantee (standard 1 year or further 1 year extended) we will need your receipt to verify the information you have supplied to us is correct. The inability to produce a valid receipt may invalidate your guarantee.

How long are new Shark machines guaranteed for?

Our confidence in our design and quality control means that your new Shark vacuum cleaner is guaranteed for a total of two years (12 months plus an extended guarantee of 1 year).

What is covered by the free Shark guarantee?

Repair or replacement of your Shark machine (at Shark's discretion to decide whether to replace or repair) including all parts and labour. A Shark guarantee is in addition to your legal rights as a consumer.

What is not covered by the free Shark guarantee?

1Blockages - For details of how to unblock your vacuum cleaner, please refer to the Instructions.

2Normal wear and tear of parts which require regular maintenance and/or replacement to ensure the proper functioning of your unit.

3Accidental damage, faults caused by negligent use or care, misuse, neglect, careless operation or handling of the vacuum cleaner which is not in accordance with the Shark Instructions supplied with your machine.

4Use of the vacuum cleaner for anything other than normal domestic household purposes.

5Use of parts not assembled or installed in accordance with the operating instructions.

6Use of parts and accessories which are not Shark spares.

7Faulty installation (except where installed by Shark).

Where can I buy genuine Shark spares and accessories?

Shark spares and accessories are developed by the same engineers who developed your Shark vacuum. You'll find a full range of Shark spares, replacement parts and accessories for all Shark machines at www.sharkclean.co.uk.

Please remember that using non-Shark spares may invalidate your manufacturer's guarantee. However, your statutory rights are unaffected.

BATTERY REMOVAL AND DISPOSAL

This product uses a rechargeable and reusable lithium-ion battery. When the battery no longer holds a charge, it should be removed from the vacuum and recycled. DO NOT incinerate or compost the battery.

When your lithium-ion battery needs to be replaced, dispose of it or recycle it in accordance with local ordinances or regulations. In some areas, it is illegal to place spent lithium-ion batteries in the bin or in a municipal solid waste stream. Return spent battery to an authorized recycling center or to retailer for recycling. Contact your local recycling center for information on where to drop off the spent battery.

LITHIUM-ION BATTERY

MUST BE RECYCLED OR

DISPOSED OF PROPERLY

RECORD THIS INFORMATION

Model Number:

Date of Purchase:

(Keep receipt)

Store of Purchase:

© 2020 SharkNinja Operating LLC.

Euro-Pro Europe Limited, 3150 Century Way, Thorpe Park, Leeds, LS15 8ZB, UK [phone]

sharkclean.co.uk

SHARK is a registered trademark of SharkNinja Operating LLC. Printed in China.

Illustrations may differ from actual product.

CH950UKT_Series_IB_E_MP_200717_Mv2