Page 1
!
!
BOTBOUNDARY®
STRIPS
SETTING UP YOUR HOME USING
BOTBOUNDARY STRIPS
FURNITURE DOORWAYS PET BOWLS
BotBoundary strips
SEE OTHER SIDE
FOR USAGE
INSTRUCTIONS
BotBoundary strips
Page 2
USAGE INSTRUCTIONS
1. You can cut BotBoundary® strips to shorten
them as needed. (18-inch minimum.) If
cutting a strip, make sure it’s still long enough
to cover the entire area you need to block
o. Gaps may cause bot boundaries to
malfunction.
2. Make sure each BotBoundary strip lies
completely flat against the floor, with
no overlapping. NOTE: DO NOT place
BotBoundary strips on top of one another.
3. For best results, place the strips between
fixed objects like furniture legs or door
frames, or make a closed loop around an
obstacle.
WARNING: For your robot’s cli sensors to work properly, all runners,
rugs, or carpets must be eight inches from any stairs (or it must be
continuous and extend over the edge of the stairs). If a runner, rug or
carpet edge that is less than eight inches from the stairs cannot be
moved, you must use a BotBoundary strip to block o the stairs.
WARNING: Do not place BotBoundary under carpeting or rugs.
WARNING: Do not place BotBoundary strips within 10ft of the dock
To purchase additional
BOTBOUNDARY STRIPS visit
sharkaccessories.com
RV1000AESeries_POPM_INSRT_BotCard_E_REV_Mv8
(18" Minimum)
BotBoundary strip
SEE OTHER SIDE FOR HOME PREP INFO
Loading...