Shark Anti-Hair Wrap Quick Start Guide

REACH ANYWHERE		STORE ANYWHERE

Please make sure to read the enclosed Shark® instructions prior to using your vacuum

Press the Flexology Lock Release button to lower the angle of the wand to increase your reach.

Press the Flexology Lock Release button and fold the handheld vacuum forward.

To vacuum, lift up the handheld vacuum, until the wand locks in place.

Flexology

Lock Release

Anti-Hair Wrap & DuoClean

Cordless Vacuum

EMPTYING THE DUST CUP

1. To empty dust cup,	2. Position dust cup
first disconnect the	over a trash
handheld vacuum	bin and slide
from the wand by	the lid release
pressing the Wand	button forward.
Release button and
pulling up on the
handheld vacuum.

Dust cup

Release Button

Wand Release

Button

@sharkcleaninguk

QUICK

START

GUIDE

Use this Quick Start Guide to start using your new vacuum’s great features.

For questions, visit us online at sharkclean.eu

©2019 SharkNinja Operating LLC. SHARK, DUOCLEAN and FLEXOLOGY	IZ201UK_IZ251UK_QSG_MP_190814_Mv1	IZ201UK and IZ251UK series
are registered trademarks of SharkNinja Operating LLC.

WHAT’S INSIDE:	ASSEMBLY
A Handheld Vacuum
B Motorised Floor Nozzle	A
C Flexology Wand
D Upholstery Tool

ECrevice Tool

FDusting Brush

G	Anti-Allergen Dusting Brush (Certain Models only)
H	Lithium-Ion Battery (2x Certain Models only)
I	Lithium-Ion Power Pack Charger
J	Dual Charging Dock (Certain Models only)
K	Motorised Pet Brush (Certain Models only)			C
	D	E	F

(Click)

G H I

J K

B	1
	1
	(Click)

For additional parts and accessories, visit sharkaccessories.eu

POWER SETTINGS

OFF

Slide switch to the top to turn off power. To begin vacuuming, slide switch to the appropriate setting.

HARD FLOOR

SETTING

The brush-roll spins slowly to clean hard floors and low-pile area rugs.

CARPET SETTING

The brush-roll spins faster to pick up debris below the surface

of your carpets.

BOOST MODE

For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.

LITHIUM-ION POWER PACK

In Use

Full	Mid	Low	Nearly	No
Charge	Charge	Charge	Empty	Charge
Charging
Low	Mid	Nearly	Full
Charge	Charge	Full	Charge

NOTE: Full charge takes approximately 3 hours.

Battery Indicator Lights

NOTE: The LITHIUM-ION Power Pack battery comes partially charged. Charge fully before first use, then run the battery down until it is completely out of power. This will condition the battery so the LED indicators will work properly.

CHARGING

IN THE VACUUM: FLEXOLOGY® WAND		OUT OF THE VACUUM

To put the vacuum in storage mode, press the Unlock	To remove the battery, squeeze the Battery
latch while folding the handheld vacuum forward	Release Button and slide backwards. Plug the
until the wand clicks and locks. Plug the charger into	charger into the charging port on the battery.
the charging port on the handheld vacuum.