SHANTOU IAEB109 User Manual

FCC WARNINGS

This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:

‐ Reorient or relocate the receiving antenna.
‐ Increase the separation between the equipment and receiver.
‐ Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

‐Consult the dealer or an experienced radio/TV technician for help

important announcement
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.

ADDITIONAL WARNINGS

•
this unit to rain or moisture.

• WARNING : Where the mains plug or appliance coupler is
used as the disconnect device, such disconnect device shall
remain readily operable.

• Lithium batteries, like all rechargeable batteries, are
recyclable and should be recycled or disposed of according to
state and local guidelines. They should never be disposed of in
normal household waste and they should never be incinerated,
as they might explode. Contact your local government for
disposal or recycling practices in your area.

• This product meets and complies with all Federal regulations.

• To avoid hearing damage, make sure that the volume on
your music player is turned down before connecting your
earbuds. After placing earbuds in/on your ears, gradually turn
up the volume until you reach a comfortable listening level.

WARNING : This product can expose you to
chemicals including lead, which is known to the State
of California to cause cancer and birth defects or other
reproductive harm. For more i nformation go to www.
P65Warnings.ca.gov.

International Support

To download this User’s Guide in English, Spanish,
or French, or to get answers to frequently asked
questions, visit the support section at:

www.iLiveElectr onics.com

Para descargar este Manual del Usuario en Inglés,
Español y Francés, o para obtener respuestas a
preguntas frecuentes, visite la sección de apoyo en:

www.iLiveElectr onics.com

Pour télécharger ce guide de l’utilisateur en Anglais,
Espagnol ou Français, ou pour obtenir des réponses
à des questions fréquemment posées, consultez
rubrique d’assistance sur:

www.iLiveElectr onics.com

la

Contact Information

Website: www.iLiveElectronics.com

Email Support: [e-mail]

Email Par ts: [e-mail]

Phone Support: 1-888-999-4215

Warranty

For Warranty Information and the most
up-to-date version of this User’s Guide, go to:

www.iLiveElectr onics.com.

Made
Green

Protect for Today

Sustain for Tomorrow

Copyright © 2019 Digital Products International (DPI, Inc.)

All other trademarks appearing herein are the property

of their respective owners.

Wireless Stereo Headset

User’s Guide for Model IAEB109-2327-01

Features

• Bluetooth Wireless 5.0: range 49 feet

• Foldable memory neck band holds any shape

• Voice prompts announce earbud operations

• Built-in microphone

• Neck band controls

• Micro-USB port for battery recharge

• Built-in rechargeable battery

• Battery life: approx. 6 hrs at 100% volume

Includes

• 3 pairs of eartips - small / medium / large

• Micro-USB to USB charging cable

• User’s guide

Overview & Controls

LED Indicato r Light

& Microphone

Volume / Skip

Press to ch ange the

volume level.

Press and h old to change

the audio t rack.

Power / Pair / Play / Pause

/Speakerphone

Press and h old to power ON/OFF.

Press to play/p ause audio or

answer/end a phon e call.

Charging the Battery

Initial charge time is approximately 2 hours. Charge
fully before use.

• Pull back the cover on the Micro-USB charging
port and connect it to the USB port of a powered
on computer or USB power adaptor (not included)
to charge.

Power Status Indicator Light

Power ON Flashing blue light

Low Battery Flashing red light

Charging Solid Red light

Finished Charging Solid Blue light

Bluetooth Connection

1. This unit features automatic device pairing and
is ready to pair as soon as it powers on. Power on
the headset by pressing and holding the Power
button, then a voice will announce, “Power ON.”
The headset is ready to pair.

2. To connect to the headset, open the Bluetooth
Settings menu on your smartphone or tablet and
select IAEB109 from the list. If need be, refer to
the user manual for your device for more specic
instructions on Bluetooth pairing.

3. When successfully connected, a voice will
announce, “Bluetooth connected.” Use your
smartphone or tablet to select and play media.
Use the controls on your device or the headset to
play, pause, or skip audio, and adjust the volume.

4. After initial pairing, the headset will automatically
connect to the last device used whenever
powered on. To pair to another device, begin with
the unit powered OFF, then press and hold the
Power/Pair button on the headset and connect
to it using the new device.

Playing Audio Wirelessly

1. After connecting Bluetooth, use the controls on
the connected device to select and play audio.

2. Use the controls on the unit or the connected
Bluetooth device to play, pause, or skip audio,
and adjust the volume level.

Using the Speakerphone

1. To accept a call, press the Speakerphone button
or use the controls on the connected phone.

2. To end a call, press the Speakerphone button or
use the controls on the connected phone.

Troubleshooting

If the earbuds should become unpaired or will not
connect normally, open your device’s Bluetooth
Settings Menu and follow these steps.

• Disconnect, then reconnect to the earbuds.

• If the problem persists, delete the earbuds from

the list of available devices (“Forget This Device”).

• Turn Bluetooth OFF then ON again, and repeat the

Bluetooth Connection steps.