SHANTOU FN806 User Manual
REZO
FPV CAMERA DRONE
®
Instruction Manual
Manuel d’utilisation
EN
NOTICE
All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon
Hobby, LLC. For up-to-date product literature, visit horizonhobby.com and click on the support tab for this product.
Meaning of Special Language
The following terms are used throughout the product literature to indicate various levels of potential harm when
operating this product:
WARNING: Procedures, which if not properly followed, create the probability of property damage, collateral damage,
and serious injury OR create a high probability of superfi cial injury.
CAUTION: Procedures, which if not properly followed, create the probability of physical property damage AND a possibility of serious injury.
NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage AND a little or no
possibility of injury.
WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before
operating. Failure to operate the product correctly can result in damage to the product, personal property and
cause serious injury.
This is a sophisticated hobby product. It must be operated with caution and common sense and requires some basic
mechanical ability. Failure to operate this Product in a safe and responsible manner could result in injury or damage
to the product or other property. This product is not intended for use by children without direct adult supervision. Do
not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon
Hobby, LLC. This manual contains instructions for safety, operation and maintenance. It is essential to read and follow
all the instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid
damage or serious injury.
Age Recommendation: Not for children under 14 years. This is not a toy.
Operating Safety Precautions
• As the user of this product, you are responsible for operating it safely, not endangering yourself and others, or damaging the
product or the property of others.
• Operate your product in open spaces away from people and property.
• Never operate your product with damaged electrical components.
• Keep the transmitter powered on while model is powered on.
• Let parts cool after use before touching, motors will get hot in use.
• Remove batteries after use, as applicable.
General Product Safety Precautions
• Keep all batteries, chemicals, small parts and anything electrical out of the reach of children.
• Avoid water exposure to this product. Keep parts dry.
• Keep moving parts clean.
Charging Warnings
WARNING: Failure to comply with the following warnings could result in product malfunction, electrical issues,
excessive heat, FIRE, and ultimately injury and property damage.
• NEVER LEAVE CHARGING BATTERIES UNATTENDED.
• NEVER CHARGE BATTERIES OVERNIGHT.
• Never charge damaged batteries. If the battery begins to swell during charging or use, discontinue immediately.
• Always use the included charger. Disconnect the quadcopter after charging.
• Charge batteries away from fl ammable materials in a well-ventelated area.
• Never charge, transport, or store batteries in hot, cold, or very sunny places (recommended between 40–120°F or
5–49°C).
2
Box Contents
Main Rotor
EN
Transmitter
SD Card
Photo / Video
On/Off Switch /
Charging Port
Battery Charging
Charging Port
USB
Port
Charger LED
CHARGING (OFF)
READY (Solid Red)
1. Connect the charging cable to the quadcopter, paying close attention to the on the port.
2. Connect the charging cable to a powered USB.
3. The battery will charge in approximately 30 minutes.
The LED sequence for the USB charger is
OFF = charging,
Solid Red = charge is complete.
ON / OFF
SD Card Reader
USB Charging Cable
Propellers (4)
CAUTION: Incorrectly plugging the charging cable into the quadcopter charging port can damage the product.
Transmitter
Rate
Auto take off
Auto land
Take picture
Take video
On / Off Switch
3
Flip
Pitch Trim
Roll Trim
EN
Start Up
To start your quadcopter, follow this starting sequence:
1. Power on the transmitter. The transmitter beeps.
2. With the quadcopter on a level surface, power on the quadcopter. The
quadcopter LEDs fl ash.
3. Fully raise the THROTTLE stick. The transmitter emits one short beep.
4. Fully lower the THROTTLE stick. The transmitter emits one long beep.
5. After the beep, binding is successful. The quadcopter LEDs stay solid.
NOTICE: The quadcopter’s ying range is 30m. If you y beyond this
range, the transmitter signal will be lost.
Operation and Control
Some drifting during ight is normal. The quadcopter may become unresponsive at the end of the battery life. To recharge the
battery, follow the Battery Charging instructions.
Motor Start
To fl y your quadcopter, press the THROTTLE stick to the left-bottom and the CONTROL stick to the
right-bottom. The motor starts. Or you can press the Right button once to fl y the quadcopter.
Motor Stop
To stop your quadcopter, press the THROTTLE stick to the right-bottom and the CONTROL stick to the
left-bottom.
Auto Takeoff / AutoLand
Press the Left button once, and the quadcopter will take off automatically.
Press the Left button once, and the quadcopter will land automatically.
Flight Control
NOTICE: When the quadcopter is ying toward the user, control direction is reversed.
NOTICE: In the event of a crash, the quadcopter motors will stop automatically to prevent motor damage.
NOTICE: If the LED lights on the quadcopter ash continuously, when NOT lming video, it indicates low battery and may
not y properly or perform ips.
4
Double Rates
The quadcopter has 2 operation modes: beginner and advanced:
Press the RATE button to enter the setting mode.
• The transmitter beeps once, indicating beginner mode (sensitivity 30%).
• The transmitter beeps three times, indicating advanced mode (sensitivity 70%).
Higher sensitivity means a faster quadcopter! Lower sensitivity means a slower
quadcopter.
Trimming
Drift Forward Trim Backward
Drift Backward Trim Forward
EN
Drift Right Trim Left
Drift Left Trim Right
Troubleshooting Guide
Problem Possible Cause Solution
Quad drifts or changes
altitude on its own
Quad fl ips over upon takeoff
Sensor is out of calibration
Propellers are not installed
correctly
Turn the power OFF
then back ON for
the transmitter
Check propeller direction and condition
5
Loading...