SHANTOU 86193 User Manual

FLIPO COLOR MAGIC CAR
OWNER’S MANUAL

Model No: TOY-COLSCAN

Transmitter

Remote Control Battery Installation.

1. Remove the screw holding the battery compartment door and
slide open the battery compartment cover.

2. Insert 2 x AA battery according to the polarity information located in the compartment;
make sure the (+) and (-) poles of the battery are positioned correctly.

3. Replace the battery compartment door

Car Battery Charging

1. Switch the car to “OFF”.

2. Connect the round jack of the charger to the charging slot at the bottom of the car.

3. Plug the charger into a wall outlet.

4. Charge the battery for approximately 2-3 hours.

5. After charging, unplug charger from wall outlet and car.

6. The battery pack will feel warm after charging, which is normal.

7. Recharging the battery after about 10-15mins of usage.

Color Scan Instructions

1.) When first turned on, the cars led’s will flash through a multi-color sequence. If you take
no further action the car will continue to cycle through this multi-color sequence.

2.) You can also select a color you wish your car to illuminate. Most colors can be replicated
by the car. Dark colors and earth tones, such as black, brown, navy blue, tan, or brick red,
cannot be reproduced. A color chart is included with your car for convenience. The chart
contains color suggestions that can be used with your Color Scan Car. You may also use
other colors of your choice if they are a solid block of color and can be laid out evenly on
a flat surface.

3.) To select a color: turn your car to the ON position. The car will first cycle through its multi-color
flashing sequence. Next, locate both your oval shaped scan window on the rear of the car and
the Color Select Button on the side of the car. The color you wish to replicate should be placed
on a stable flat surface. Place the Scan Window on the color you would like to reproduce, and
then press the Color Select Button one time – your car should now be flashing in the color you
have chosen.

4.) If the car does not change to the color you have selected is too dark to be reproduced by the
Color Scan Car.

- Not suitable for children under 8 years due to detachable small parts.

- Installation of the battery should ALWAYS be done by an adult.

- Keep fingers, hair and loose clothing away from the vehicle’s tires and the wheels.

- Don't pick up the vehicle while in motion.

- Don’t put your vehicle or transmitter near any source of heat.

- Don’t operate your vehicle in dangerous places.

- Do not mix old and new batteries

- Do not mix alkaline, standard(carbon-zinc), or
rechargeable(nickel-cadmium) batteries.

- Car batttery is rechargeable, no replaceable.

• Ages: For 8 years old and above

• Please read the instructions carefully
before beginning to play

• Adult guidance is strongly recommended

!

WARNING

1. The car can be turned ON by moving the activation switch to “ON” position.

2. Drive the car by operating the sticks of the transmitter

FORWARD

ROLLOVER STUNTS

WHEELIE STUNT WITH FRONT WHEELS ROTATING

4

.

The effective range is approximately up to 26 feet.

PROBLEM

The switch of the car or controller
has not been turned on

The (+) and (-) ends of the battery are
positioned in the wrong direction

The car moves slowly or is
unable to perform stunts

The car cannot be controlled
or moves erratically

The batteries in the controller are too weak.

The batteries in the controller are too weak.

There is another device using a similar
frequency nearby or the car has moved
out of range

Replace “AA” batteries with new ones

Recharge car's batteries

Replace “AA” batteries with new ones

Change locations or move nearer to
the effective range of less than 26 feet.

30 DAYS LIMITED WARRANTY

FLIPO GROUP warrants to the original purchaser, when used in North America only, that this
product shall be free of defects in material and workmanship. This warranty applies within 30 days
of the original purchase with normal home use. This warranty does not apply for commerical use of
this product. Use outside of North America is not covered by this warranty.

During the warranty period, we will at our option, repair or replace this product without charge,
which shall be the consumer’s sole remedy. ALL RETURNS must be accompanied by a Return
Authorization Number, which is issued by the Customer Service Department of Flipo Group.
Please contact Customer Service BEFORE returning any item. Once you have obtained a Return
Authorization Number, the product must be returned with a clear copy of the proof of purchase,
showing place and date of purchase, postage and insurance prepaid to:

Flipo Group
613 First Street
La Salle, IL 61301

Email: [e-mail]
Website: www.flipo.com
Tel: [phone]

This warranty does not cover installation, adjustments in the home, nor damage due to accidents,
misuse, abuse, fire or other acts of God, incorrect line voltage, damage to other equipment caused
by improper installation, unauthorized or improper modification. This warranty gives you specific
legal rights and you may also have other rights that vary from state to state.

If you should have questions about your product’s operation, battery installation,
trouble shooting or just want to learn some interesting functions, please visit
www.flipotv.com. Individual product videos can be found at either the page for
your product located in the Toys Department or at the How To page.

**THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED
OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS.**

2012 Flipo Group Limited

www.flipo.com

FCC INFORMATION

This device complies with part 15 of the FCC Rule. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

received, including interference that may cause undesired operation.received, including interference that may cause undesired operation.

FCC ID: P3286193

NOTE:
Changes or Modifications not expressly approved by the party responsible could void the user’s authority to operate

this device.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Printed in China