
Thank you for purchasing a Shakespeare antenna product.
Shakespeare works hard to build reliability and durability into all
of its products for maximum customer satisfaction. Customer
comments are welcome. Before installing, please study the
diagram and check parts supplied against those listed.
Style TNC
Solder-type Connector
Supplied Parts
1 Connector Assembly
IMPORTANT! Please read all instructions before installing.
The Style “TNC” is a solder-type connector for installation
on coax cable. It provides a sturdy, weather-resistant connection
for marine electronics applications.
Tools required: Needlenose pliers, soldering iron
(40-watt min.), resin core solder, pocket knife, wire
cutters, 7/16” wrench or crescent wrench.
Installation Instructions
1. Slide Nut, Washer, and Gasket over the cable. Strip outer
jacket beginning ¼” from the end of the cable as shown in
Figures 1 and 2.
2. Comb out the shield braid and fold it back as shown in Figure
2. Remove the cable dielectric beginning 1/8” from the end.
Be careful not to nick the center conductor.
3. Fold the braid forward over the dielectric and taper toward
the center conductor. Slide Clamp over braid until it fits
squarely against the cable jacket. See Figure 3.
Figure 1
Figure 2
Figure 3
Nut Washer
Gasket
Nut Washer
Gasket
Nut Washer
1/4"
Gasket
1/4"
1/8"
Clamp
Center
Conductor
Clamp
Center Pin
4. Fold the braid over the clamp and distribute evenly. Trim off
any excess braid.
5. Slide the center pin over the center conductor and solder it.
See Figure 2. (Remove any excess solder from the outside of
the center conductor.)
6. Slide the entire assembly into the connector body, making
sure the center conductor seats securely into the front of the
connector and is flush with the end of the connector body.
Tighten the nut with a wrench to complete the installation.
See Figure 3.
The completed connector is illustrated in the cutaway view.
Gasket
Cutaway
View
Clamp
Shakespeare Composites & Electronics Division
19845 Highway 76, PO Box 733 · Newberry, SC 29108 · 803-276-5504 · Fax: 803-276-8940 · www.shakespeare-marine.com
©2000 Shakespeare Co. · Form I-TNC-5 J: rev. 07/02
A Company
35-90-1232-00