Page 1
Installation Instruction for Shadow SH 950
Double Side Upright Bass Pickup
Content:Content:
2 Upright Bass Transducer with 6.5 mm (1/4”)
2 Upright Bass Transducer with 6.5 mm (1/4”)
output socket and mounting adhesive,
output socket and mounting adhesive,
Copper Foil Tape,
Copper Foil Tape,
Cable Holder
Cable Holder
1. Test fit sensors into the slot between the wing and foot.
1. Test fit sensors into the slot between the wing and foot.
Pickup should fit tightly for best output (see fig 1).
Pickup should fit tightly for best output (see fig 1).
2. If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.2. If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.
Fig. 1Fig. 1
Sensor
Kupferfolie
Fig. 2Fig. 2
3. Install the sensors into the bridge slots.
3. Install the sensors into the bridge slots.
4. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.
4. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.
5. Connect to appropriate amplifier with instrument cable.
5. Connect to appropriate amplifier with instrument cable.
Note:
Note:
Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend
Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend
an amplifier with low impedance input.
an amplifier with low impedance input.
Loading...