November 1997 1/10
R
Rev. 1.0
ST6215L/25L
LOW VOLTAGE 8-BIT ROM MCUs WITH
A/D CONVERTER AND 28 PINS
■
2.4 to 3.9V Supply Operating Range
■ 4 MHz Maximum Clock Frequency
■
0to+70°C Operating Temperature Range
■
Run, Wait and Stop Modes
■
5 Interrupt Vectors
■ Look-up Table capability in Program Memory
■
Data Storage in Program Memory:
User selectable size
■
Data RAM: 64bytes
■ 20 I/O pins, fully programmable as:
– Input with pull-up resistor
– Input without pull-up resistor
– Input with interrupt generation
– Open-drain or push-pull output
– Analog Input
■
8 I/O lines can sink up to 12mA to drive LEDs
■
8-bit Timer/Counter with 7-bit programmable
prescaler
■ Digital Watchdog
■
8-bit A/D Converter with 16 analog inputs
■
On-chip Clock oscillator can be driven byQuartz
Crystal Ceramic resonator or RC network
■ Power-on Reset
■
One external Non-Maskable Interrupt
■
ST626x-EMU2 Emulation and Development
System (connects to an MS-DOS PC via an
RS232 serial line)
DEVICE SUMMARY
PDIP28
PSO28
DEVICE
ROM
(Bytes)
ST6215L 1836
ST6225L 3884
1
2/10
ST6215L/25L
1 GENERAL DESCRIPTION
1.1 INTRODUCTION
The ST6215L/25L are low voltage mask programmed ROM version of ST62T15C,T25C OTP
devices.
They offer the same functionality as OTP devices,
selecting as ROM options the options defined in
the programmable option byte of the OTP version,
with the exception of the LVD Reset that is not
available.
Figure 1. Programming wave form
1.2 ROM READOUT PROTECTION
If the ROM READOUT PROTECTION option is
selected, a protection fuse can be blown to prevent any access to the program memory content.
In case the user wants to blow this fuse, high voltage must be applied on the TEST pin.
Figure 2. Programming Circuit
Note: ZPD15 is used for overvoltage protection
VR02001
0.5s min
15
10
5
14V typ
100 s max
t
t
4mA typ
100mA
150 s typ
max
TEST
TEST
VR02003
PROTECT
ZPD15
5V
V
SS
V
DD
TEST
47 F
m
100nF
100nF
15V
14V
1
3/10
ST6215L/25L
ST6215L/25L MICROCONTROLLER OPTION LIST
Customer . . . ..........................
Address .............................
.............................
Contact . . . ..........................
PhoneNo .............................
Reference . . . ..........................
SGS-THOMSON Microelectronics references
Device: [ ] ST6215L [ ] ST6225L
Package: [ ] Dual in Line Plastic[ ] Small Outline Plastic with conditionning:
[ ] Standard (Stick)
[ ] Tape & Reel
Temperature Range: [ ] 0°Cto+70°C
Special Marking: [ ] No [ ] Yes ”_ _ _ _ _ _ _ _ _ _ _ ”
Authorized characters are letters, digits, ’.’, ’-’, ’/’ and spaces only.
Maximum character count: DIP28: 10
SO28: 8
Oscillator Source Selection: [ ] Crystal Quartz/Ceramic resonator
[ ] RC Network
Watchdog Selection: [ ] Software Activation
[ ] Hardware Activation
ROM Readout Protection: [ ] Disabled (Fuse cannot be blown)
[ ] Enabled (Fuse can be blown by the customer)
Note: No part is delivered with protected ROM.
The fuse must be blown for protection to be effective.
External STOP Mode Control[ ] Enabled [ ] Disabled
TIMER pin pull-up [ ] Enabled [ ] Disabled
NMI pin pull-up [ ] Enabled [ ] Disabled
Comments :
Supply Operating Range in the application:
Oscillator Fequency in the application:
Notes . . . ..........................
Signature . . . ..........................
Date .............................
1