SFaudio SFF50 User Manual

SFaudio

Professional Stage Haze Effect

SFF50

User Manual

EN - Instruction Manual

www.sfaudio.es

INTRODUCTION:

SFaudio

SFF-50 Haze Machine is a 1000W newly designed professional long-life haze machine.

It offers perfect haze effects: even, very dry, mist, speady very fastly. It is 100% no dropping,
very ideal for theatre, stage, high-grade club, etc.

1. Controlled by precise micro-computer:
A: Precise temperature control.
B: 1-100% adjustable fan speed.
C: 1-100% adjustable haze output.

2. Fluid-less protection: It will stop working when fluid is running out.

3. Self-cleaning function: The heater will be cleaned by air pump technology after use.

4. Extremely low fluid consumption: Economy and high efficiency.

5. Easy operation with LCD Display

PACKAGE CONTENTS:

Please check the contents to ensure that the product has been received in good Condition.

1. LF-4 Haze machine x 1pcs

2. User manual x1pcs

3. Power cord x1pcs

If you find any accessory is missing or the machine has arrived with any problems, please
contact your local dealer at once. Do not try to fix this item yourself or you will lose the
warranty. Please keep the original package and invoice for any possible replacement or returned
demand.

RECOMMENDED FLUID:

For the SFF-50 haze machine we strongly recommend the following SFAUDIO heavy fog fluid
which has been specifically formulated to perform best with any heater based haze machines.

To guarantee trouble-free operation the special “SFF-50 Haze-Fluid“ must be used.

Use of other liquids will void the manufacturer‘s warranty and can be dangerous to your health.

SET UP:

1. Unpack the haze machine.

2. Unscrew the top cap of the tank and remove to fill with the recommended haze fluid.

3. Replace the bottle and screw the cap securely ensuring the pipe is fed down to

the bottom of the bottle so a consistent flow of fluid is supplied to the machine.

4. Connect the remote control.

5. Connect the IEC mains plug and power up

6. Heat up time is usually between 2-3 minutes. Please ensure no button is pressed during

the heat up time. When the machine is ready the LED light on the machine and remote
control will illuminate.

7. After heat up, please refer to page 10“Operation for SFF-50”.

CAUTION! TO PREVENT MORTAL ELECTRICAL RISK AND LONG LIFE OPERATION:

SFaudio

For your safety, please kindly pay attention to all of the warnings listed below:

1. Always plug in the power plug last and disconnect from the mains when the device is

not in use or before cleaning.

2. Do not install and operate the device in rain or extreme heat, moisture or dusty

environments.

3. This device is for indoor use only and in a dry environment.

4. Do not switch on immediately but wait until it reaches to room temperature if the

device has been exposed to drastic temperature fluctuations.

5. Do not shake the device and avoid brute force when installing or operating.

6. Do not use the device during thunderstorms and please disconnect the power.

7. Do not use solvents or aggressive detergent to clean the device. Use a soft and clean

cloth.

8. Do not modify the device or the connected power cord without authorisation.

CONNECT WITH POWER SUPPLY – THE GROUND WIRE MUST BE CONNECTED:

Use the plug to connect to the main power supply as follows:

Wire Connection W i r e C o n n e c t i o n

Brown Live L

Blue Neutral N

Yellow /Cyan Earth

QUICK TROUBLE SHOOTING

If the unit is not functioning properly:

1. Check if main power is on.

2. Check the fuse hasn’t blown.

3. Check the unit isn’t in DMX mode.

4. Check there is fluid in the tank and the pipe is pushed down to the bottom of the

bottle.

5. If there is blockage use distilled water or haze machine cleaning fluid.