INFLATABLE BOATS
®
IMPORTANT! Inate the boat chambers in the following order:
1. Inate the inside all-around safety chamber.
2. Inate the oor chamber(s).
3. Inate the bottom tunnel chambers. (These tubular chambers are
only found on Super Caravelle and Fish Hunter™ models.)
4. Inate the bustle chamber. (This support chamber positioned at
the stern is found only on the large Super Caravelle models.)
5. Inate the outside main chamber.
The chambers on the boat will be numbered to indicate order of
ination also. This order of ination will ensure the proper volume and
buoyancy of the safety chamber.
Note: To inate the mini double lock valve, which is used on some of
the Sevylor boat oors and seat bottoms, follow the same ination
instructions above, using the mini double lock valve adapter. The mini
Double Lock™ valve adapter is included with all Sevylor
®
pumps. The
adapter can be purchased from Customer Service by calling 1-800835-3278 (Part Number 5010000707).
CAUTION!
Water temperature and weather does affect the pressure in
inatable products. In cold weather your product will lose some
pressure due to the fact the air will contract. If this occurs, you
may want to add a little air to improve your products performance.
However, in hot weather, the air will expand. You must let some air
out to prevent your product from failing due to overpressure. You
should avoid exposing your product to extreme temperatures (hot
or cold).
DEFLATION INSTRUCTIONS
Deation instructions using
any
Sevylor
®
QuickPump™
unit:
Deation instructions using
the Sevylor® Dual Action
Hand Pump:
Remove adapter hose from inflation end and attach to opposite deflation
end of pump. Repeat same steps as inflation. This will draw the air out
quickly.
Remove adapter hose from inflation port and attach to deflation port
on pump handle. Repeat same steps as inflation. This will draw the air
out quickly.
4