Dear Customer,
Before using the appliance, the user should
read the following instructions carefully.
Connection to the mains supply
The appliance should only be connected to
an earthed socket installed in accordance
with the regulations. Make sure that the
supply voltage corresponds with the voltage
marked on the rating label of the appliance.
This product complies with all binding CE
labelling directives.
Important safety instructions
● Children are not aware of the dangers
that may occur when operating electrical
appliances. Therefore keep children
away from such appliances.
● Before the appliance is used, the main
body as well as any attachment fitted
should be checked thoroughly for any
defects. Should the appliance, for
instance, have been dropped onto a hard
surface, it must not be used any longer:
even invisible damage may have adverse
effects on the operational safety of the
appliance.
● During operation, the coffee maker must
be placed on a level, non-slip surface,
impervious to splashes and stains.
● Always switch off and remove the plug
from the wall socket
- in cases of malfunction,
- when it is not in use,
- during cleaning.
● Do not allow the appliance or its power
cord to touch hot surfaces or to come
4
Coffee maker
into contact with any heat sources.
● Coffee maker with hotplate: Caution: the
hot-plate becomes very hot during
operation n.
● To prevent the danger of hot water or
steam being emitted, always switch off
the coffee maker and allow sufficient
time for the appliance to cool down
before opening the lid or removing any
accessories or attachments.
● Take care that the power cord does not
trail over the front of the worktop and
does not touch the hot parts of this
appliance.
● Do not leave the appliance unattended
while it is switched on.
● This appliance is intended for domestic
use only and not for commercial
applications.
● No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
● In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repair
is needed, send the appliance to one of
our customer service departments.
Addresses can be found in the appendix
to this manual.
Features and accessories
Technical features and accessories depend
on the coffee maker model. Please follow
the descriptions and illustrations on the
packaging of your appliance.
Before using for the first time
Before making coffee for the first time, let
the appliance go through two or three
filtration cycles using the indicated
maximum amount of cold water, but without
using ground coffee. This should also be
done if the appliance has not been used for
an extended period of time, and after
descaling.
General information
-
The markings on the water gauge and/or
on the jug help you to measure the
amount of water needed to prepare the
required number of cups of coffee. If
your appliance comes with a double
graduation scale, the one on the left-hand
side corresponds to medium-sized cups
with a capacity of approx. 125 ml, the one
on the right-hand side to smaller-sized
coffee cups. Take care not to exceed the
indicated maximum number of cups.
● Always switch off and allow the coffee
maker to cool down for about 5 minutes
before it is switched don again.
● Warning! Be careful not to fill water into
the reservoir immediately after a brewing
cycle is complete as hot steam may
escape from the water nozzle.
To prepare filter coffee
-
Filling the water reservoir
Open the water reservoir lid. Fill the
reservoir with the required amount of fresh
cold water and close the lid.
-
Inserting the paper filter
Insert a size-4 paper filter, first folding down
the perforated sides of the filter.
-
Adding ground coffee
We recommend using fine ground filter
coffee, approximately 6 g = 1
1
/2- 2 tsp. per
medium-sized cup (125 ml).
-
Preparing the jug
Replace the jug back into the appliance.
Coffee maker with ”put on” filter holder:
Place the filter holder on top of the jug
before replacing the jug back into the
appliance.
Coffee maker with pivoted filter holder:
Place the jug lid or the drip-through lid onto
the jug before replacing the jug back into the
appliance.
-
Starting the filtering process
Plug in the appliance and switch on. The
filtering process begins.
-
Removing the jug
When the filtering process is complete, i.e.
all water has run through the filter holder
5
Loading...