Page 1
5a
5b
11
12
13
15
16
24
19
22
21
6
23
1
4
2
3
7
8
18
9
10
20
14
17
Page 2
Dear Customer
Before using the appliance, the user should
read the following instructions carefully.
Connection to the mains supply
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the appliance. This product
complies with all binding CE labelling
directives.
Familiarisation
1. Hose
2. Hose grip
3. Secondary air-flow opening slide (tube)
4. Tube holding bracket
5. Dual-purpose tool
a. Crevice tool
b. Upholstery brush
6. Accessory compartment
7. Tube
8. Filter compartment release
9. Main power switch
10. Carrying handle
11. Multi-purpose tool
12. Filter compartment cover
13. Filter compartment for dust bag and
motor protection filter
14. Motor-protection filter
15. Dust bag
16. Filter holder
17. Hose connection
18. Dust bag full indicator
19. Suction power regulator
20. Power cord retract mechanism
21. Exhaust-air filter compartment
22. Exhaust-air filter compartment release
23. Power cord with plug
24. Rating label (on underside of unit)
Important safety instructions
● Before the appliance is used, the main
body including the power cord as well as
any attachment fitted should be checked
thoroughly for any defects. Should the
appliance, for instance, have been
dropped onto a hard surface, it must no
longer be used: even invisible damage
may have adverse effects on the
operational safety of the appliance.
● The power cord should be regularly
examined for any signs of damage. In the
event of such damage being found, the
appliance must no longer be used.
● Always switch off and remove the plug
from the wall socket after use, and also
- in case of any malfunction and,
- during cleaning.
● Never use the vacuum cleaner to pick up
- sharp or pointed objects such as glass
splinters,
- hot ashes, cigarette stubs or chemical
matter,
- stone dust, plaster, cement or any
similar fine dust particles,
- foam, water or other liquids.
● This appliance is not intended for use by
any person with reduced physical,
sensory or mental capabilities, or lacking
experience and knowledge, unless they
have been given supervision or
instruction concerning the use of the
appliance by a person responsible for
their safety.
● Children are not aware of the dangers
that may occur when operating electrical
appliances. Therefore keep such
appliances away from children.
● Always check the dust bag for any signs
of damage before connecting the
appliance to the power supply. Do not
operate the vacuum cleaner
- if no dust bag is inserted or if the dust
bag is damaged,
- if the dust bag full indicator shows that
the dust bag has reached its maximum
capacity.
● The vacuum cleaner must not be used on
persons or animals. A considerable risk
exists especially where ears and eyes are
concerned. Keep the nozzle away from
the head at all times.
5
Cylinder Cleaner
Page 3
● When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
● No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
● This appliance is intended for domestic
use only and is not designed for medical
or commercial applications.
● In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The addresses can be found in the
appendix to this manual.
Before using for the first time
-
Remove the appliance from its
packaging.
-
Remove any exterior and interior
packaging materials and make sure that
the dust bag, the motor-protection and
exhaust air filters are correctly inserted.
Thermal safety cut-out
This vacuum cleaner is equipped with an
integral thermal safety cut-out, which
automatically switches the appliance off in
case of overheating (e.g. due to blockage in
the tube or filter). Should this occur, remove
the plug from the wall socket and let the
appliance cool down for a minimum of one
hour. The vacuum cleaner may then be used
again after the blockage has been removed.
Operation
-
Put the vacuum cleaner in its horizontal
operating position.
-
Insert the hose into the hose connection.
-
Connect the tube to the hose grip.
-
Attach any of the nozzles provided to the
end of the tube. If the full tube length is
not required (e.g. when using the
upholstery tool), the nozzle may be
attached directly to the hose grip.
-
Pull out the power cord from its storage
to the necessary length (but not beyond
the red mark) and insert the plug into a
suitable wall socket.
-
The vacuum cleaner is equipped with a
very powerful motor. In order to prevent
a fuse within your home electrical
installation from being triggered at
switch-on, always set the power regulator
to its lowest setting before the appliance
is switched on.
-
The electronic suction regulator allows
the suction power to be infinitely
adjusted to your needs.
-
In addition, the suction power can be
decreased further by opening the
secondary air-flow opening slide in the
hose grip.
-
Always start with a low setting when
cleaning soft objects such as curtains.
● Always ensure that the power cord is not
routed around or runs over corners or
edges, and that it cannot be jammed in a
door.
-
During operation, the hose may be used
to pull the unit along behind you.
However, when carrying the unit, always
use the carrying handle.
● To prevent the power cord from being
pulled with excessive force, always
change to the next suitable wall socket
when cleaning larger areas.
-
Switch off the appliance after use and
remove the plug from the wall socket.
-
To retract the power cord automatically
into its storage, press the foot switch of
the retract mechanism.
Accessories
The dual-purpose tool is located in the
accessories compartment.
Multi-purpose tool
The multi-purpose tool is especially suitable
for cleaning large areas.
Upholstery brush
Fold out the brush element of the dual-
6
Page 4
purpose tool in the direction indicated by the
arrow until it locks into place.
This brush tool is suitable for cleaning
uneven areas such as upholstered surfaces,
picture frames, rows of books etc.
Crevice tool
The crevice tool is designed to clean difficultto-reach areas such as grooves, niches,
corners and crevices.
Changing dust bag or filters
● Before any filter is changed, always
switch the appliance off and remove the
plug from the wall socket.
The vacuum cleaner uses replaceable filters.
When replacing the motor or exhaust-air
filter, it may be necessary to cut the filters to
size with a pair of scissors.
The indicator shows when the dust bag
needs changing: as soon as it is permanently
illuminated, the dust bag has reached its
capacity. The appliance must be switched off
before the bag is replaced.
A noticeable decrease in vacuuming power
also indicates that the dust bag has reached
its capacity.
Changing the dust bag
-
Remove the hose from the unit by
pressing the two buttons at the end of the
hose.
-
Press the filter compartment release and
open the compartment.
-
Remove the filter holder with the dust
bag attached by lifting it out.
-
Pull the full dust bag from the filter
holder.
-
Fit the cardboard frame of the new dust
bag into the filter holder.
-
Insert the filter holder with the new bag
into the filter compartment.
-
Close the cover of the filter compartment
by pressing down lightly until it is heard
locking into place.
Changing the motor-protection filter
The motor-protection filter is located at the
rear of the filter compartment. Should the
filter be visibly dirty, replacement is
recommended at the same time as the dust
bag is changed.
-
Remove the old motor-protection filter
from its holding bracket.
-
Insert a new motor-protection filter into
the bracket.
Changing the exhaust-air filter
The exhaust-air filter is located in the
exhaust-air filter compartment. Should the
filter be visibly dirty, replacement is
recommended.
-
Press the release button to open the
exhaust-air filter compartment.
-
Remove the cover and lift out the
exhaust-air filter holder.
-
Change the exhaust-air filter.
-
Replace the filter holder into the filter
compartment with its grid facing
outwards.
-
Close the cover of the filter compartment
by pressing down lightly until it is heard
locking into place.
Cleaning and care
● Before cleaning the appliance, ensure it is
switched off and disconnected from the
power supply.
● To avoid the risk of electric shock, do not
clean the appliance with water and do
not immerse it in water.
-
The housing of the unit and the
accessories may be cleaned with a dry or
slightly damp lint-free cloth.
-
Do not use abrasives or harsh cleaning
solutions.
Replacement filters
Replacement filter sets may be obtained
through the SEVERIN Service, quoting
article no. SB 9099.
Suitable replacement filters type Swirl®
Y98® are also available at most dealers.
Swirl® and Y98® are registered trademarks of a
company of the Melitta Group.
7
Page 5
8
Disposal
Do not dispose of old or defective
appliances in domestic garbage;
this should only be done through
public collection points.
Guarantee
This product is guaranteed against defects in
materials and workmanship for a period of
two years from the date of purchase. Under
this guarantee the manufacturer undertakes
to repair or replace any parts found to be
defective, providing the product is returned
to one of our authorised service centres. This
guarantee is only valid if the appliance has
been used in accordance with the
instructions, and provided that it has not
been modified, repaired or interfered with
by any unauthorised person, or damaged
through misuse.
This guarantee naturally does not cover
wear and tear, nor breakables such as glass
and ceramic items, bulbs etc. If the product
fails to operate and needs to be returned,
pack it carefully, enclosing your name and
address and the reason for return. If within
the guarantee period, please also provide the
guarantee card and proof of purchase.
Loading...