Seura CL11 User Manual

CL.2 Clock Operation Guide

Turn on the CL.2 Clock with the specified DC 12V power adaptor, the clock will turn on the LED

display with one of following 2 types of display orientation.

A: Normal Display Orientation B: Reverse Display Orientation

1. Hour Adjustment Mode

Use SEURA remote, aim to the IR sensor on the CL.2 clock, keep pressing “OK” key on the remote

till the 2 digits representing hour to blink, to enter Hour Adjustment mode.

Note: Once Adjustment mode is activated, the frequency of LED segments blinking is 1Hz, if no

pressing on any key of Seura remote, the CL.2 clock will return to normal working mode.

Short press UP Arrow key, or Down Arrow key on the remote, the value of hour will increase or

decrease accordingly; pressing and hold on these 2 keys, the hour value will be changed

continuously.

2. Minute Adjustment Mode

Once Hour Adjustment mode is activated, short press “OK” key on the remote, the 3rd digit and

the 4th digit on the LED display will blink, press UP Arrow key, or Down Arrow key on the remote,

the value of minute will increase or decrease accordingly; pressing and hold on these 2 keys, the

hour value will be changed continuously.

3. Selection of 12-Hour or 24 Hour Mode

Once Minute Adjustment Mode is activated, short press “OK” key on the remote, “12” or “24”

will be displayed on the clock, use Up Arrow key or Down Arrow key on the remote to switch

between 12-Hour and 24-Hour system.

4. Selection of AUTO/ON Mode

Once 12-Hour/24-Hour selection mode is activated, short press “OK” key on the remote, “AUTO”

or “ON” will be displayed, if AUTO mode is used, it means that the LED display will be turned on

once the human motion is detected, if no motion is detected, the LED display will be turned off in

1 minute; if ON mode is used, it means that LED display will be turned on at all time. Press UP

Arrow key or Down Arrow key to switch between “AUTO” and ”ON”.

5. Orientation of Display

Once AUTO/ON selection is activated, short press “OK”, “UP” or “dN” will be displayed, press UP

Arrow key or Down Arrow key to switch between “UP” or”dN” mode; “UP” means that the

display orientation is normal, “dN” means the display orientation will be rotated 180 degrees.

Normal Display Orientation, the 2nd digit and the 3rd digit form “UP” as indication

Reverse Display Orientation, the 2nd digit and the 3rd digit form “dN” as indication.

6 Exit of Adjustment Mode

Once the Orientation selection mode is activated, short press “OK” key on the remote, the clock

will exit adjustment mode and return to normal working mode.

Caution:

This device can not be used in any way with perimeter protection systems.