Set-N-Serv WCM-BT-4 Specifications
DROP-IN SERVING EQUIPMENT
COLD PAN
Refrigerated, Air-Flow System
Self-Contained with Defrost System
Item No.
Quantity
c
WCM-BT-3
c
WCM-BT-4
c
WCM-BT-5
c
WCM-BT-6
DESCRIPTION:
The WCM-BT series cold pan is the most efficient refrigerated cold food display available
anywhere. The traditional cold-wall system is
replaced by a forced air evaporator, enabling
precise temperature control and maximum cold
transfer to your food product. The drop-in pan
can be installed in virtually any counter and can
be provided as fully self-contained - just plug it
in and turn it on.
The pan is fully insulated for maximum efficiency and energy savings, and is provided with a
factory applied gasket so that is can be installed
in the finest wood fixtures without marring the
counter top. The pan is constructed of stainless
steel and is provided with a 3/4” stainless steel
drain. The forced air evaporator drains into a
condensate evaporator.
WCMBT-4 SHOWN
FEATURES:
g
Forced air evaporator blower system for
maximum efficiency in cooling - more
consistent food product temperature
g
Automatic Defrost System
g
Fully insulated for energy savings
g
Factory applied gasket - makes installation a
snap and seals units to the counter top, thus
eliminating seepage
g
Stainless steel adapter bars
g
UL recognized
a subsidiary of Mercury Aircraft
1135 NW 159 Dr., Miami, Florida 33169
Tel: (305) 625-2451 or (800) 762-7565 • Fax: (305) 623-0475
SS-17
COLD PAN
Refrigerated, Air-Flow System Self-Contained with Defrost System
MODEL “A” PAN SIZE
WCM-BT-3 43-1/2 19-7/8” X 39-1/4” X 14”
c
c
WCM-BT-4 57-1/4 19-7/8” X 53” X 14”
WCM-BT-5 71 19-7/8” X 66-3/4” X 14”
c
WCM-BT-6 84-3/4 19-7/8” X 80-1/2” X 14”
c
A
4”
2
20 1/8”
ELECTRICAL
CHARACTERISTICS
6.8 amps. - 120V
1/4 HP
9.2 amps. - 120V
1/3 HP
9.2 amps. - 120V
1/3 HP
9.2 amps. - 120V
1/2 HP
4”
8”
16”
10 3/4”
6”
B
CUT-OUT
REQUIRED
22-1/4” X 41-3/4” 215
22-1/4” X 55-1/2” 260
22-1/4” X 69-1/4” 290
22-1/4” X 83” 320
emovable separator
R
channels
21 1/2”
6”
SHIP WT.
(lbs.)
Evaporator
21 5/8”
4”
1
B
WCM-BT-3 5 7/8”
WCM-BT-4 4”
WCM-BT-5 6 7/8”
WCM-BT-6 5 7/8”
Plan View
Elevation
End View
SPECIFICATIONS:
TOP: Constructed of 18 gauge, type 304 stainless
steel, die stamped with a raised perimeter bead.
There shall be a solid vinyl gasket under the beaded
edge to form a seal to the counter top, thus preventing seepage or marring of the counter top. Embossed
mounting lugs are provided along the inner surface of
the top to hold the removable adapter bars in place. A
full set of adapter bars is provided.
LINER: The inner liner shall be 18 gauge, type 304
stainless steel with 3” recessed top, one piece construction, all welded, ground and polished to a uniform finish. All corners are coved with a minimum
1/4" radius. The liner has copper tubing firmly soldered to the exterior bottom and all sides. A 3/4" dia.
drain with strainer, 4" PVC nipple, and valve is provided.
INSULATION: The pan is fully insulated with high
density polystyrene, 1" thick on all sides, 2" thick on
the bottom and enclosed with a 22 gauge galvanized
steel outer lines. The entire unit is removable without the use of tools.
REFRIGERATION SYSTEM:
The compressor hous-
ing shall be fabricated from 14 gauge galvanized and
bolted to the base of the unit. A fully self-contained
condensing unit is provided with a hermetically
sealed compressor and a thermostat control. The
system is also provided with a forced air evaporator
for even temperature throughout the pan, and
drains into a condensate evaporator pre-wired in the
unit. The system is fully charged with CFC free
refrigerant and ready to operate.
NOTE: Proper ventilation must be provided in counter.
ELECTRICAL: (WF series only) The unit will be
wired for 15 amps., 120 volt, single phase operation
with an on/off thermostat switch and pilot light. A 6'
long, 3-wire cord and plug (NEMA 5-15P) will be
provided.
Specifications subject to change without notice.
ACCESSORIES:
c
5-year compressor warranty
c
Remote compressor
c
* Center compressor
c
Remote switch
Note: Units with these accessories * are not currently UL listed
SS-18
a subsidiary of Mercury Aircraft
1135 NW 159 Dr., Miami, Florida 33169
Tel: (305) 625-2451 or (800) 762-7565 • Fax: (305) 623-0475
01/10-SC
Loading...