Page 1
Professional Active Mic Booster
Page 2
PO Box 720 | Mount Marion, NY 12456 | (845) 246-1915 | www.sescom.com
100% Employee Owned Division of Tower Products Incorporated
Product Data
Features:
Increase Your Mic's Gain by 22 dB
The Signal Circuitry is Isolated From the Power
Circuitry, so that your Mic Signal Comes
Through Pure and Clear
Discrete JFET Transistors Provide an Open
and Lively Sound with Plenty of Character
Features Industry Standard Neutrik Connectors
Rugged Aluminum Enclosure
Hand Assembled in the USA
Sescom SES-WRAITH Professional Active Mic
Booster
Specifications:
Gain: +22dB
Total Harmonic Distortion: .66% @ 1khz,
-40dBu input (Mic Level)
Noise Floor: -112dBu, A-weighted
Dynamic Range: 92dB
Frequency Response: 20hz - 20khz, +/-1 db
Input Impedance: 10 kOhms
Output Impedance: 60 Ohms
Phantom Loading Current: 2.6ma
Page 3
PO Box 720 | Mount Marion, NY 12456 | (845) 246-1915 | www.sescom.com
100% Employee Owned Division of Tower Products Incorporated
PO Box 720 | Mount Marion, NY 12456 | (845) 246-1915 | www.sescom.com
100% Employee Owned Division of Tower Products Incorporated
Product Data
Summon the Wraith! A 22dB phantom-powered
mic booster.
The Sescom Wraith uses discrete JFET circuitry
to give a clean, clear, noise-free boost to your
ribbon or dynamic microphones. These passive
microphones sound great, but they often require
more gain than a lot of mic preamps can give.
Even when that gain is available, it often comes
with an increased noise floor.
The Wraith not only relies on an already-clean
phantom power supply, the engineers at Sescom
went to great lengths to isolate the signal
circuitry from the power circuitry, so that your
mic signal comes through pure and clear.
The discrete JFET transistors provide an open
and lively sound with plenty of character. You
may find that your mic not only has a stronger
signal with less noise, but a more engaging tone.
Page 4
PO Box 720 | Mount Marion, NY 12456 | (845) 246-1915 | www.sescom.com
100% Employee Owned Division of Tower Products Incorporated
PO Box 720 | Mount Marion, NY 12456 | (845) 246-1915 | www.sescom.com
100% Employee Owned Division of Tower Products Incorporated
Product Data
Connection Diagram:
To use the Wraith, simply insert it in the signal
chain between your microphone and your mic
preamp. Using XLR cables, connect one cable from
your mic to the Wraith and another cable from the
Wraith to your preamp's mic input. Turn on
phantom power, set your gain to taste and you'll be
ready to record.
Please note that phantom power does not pass to the mic side of the Wraith, so your mic will not see
the phantom power supply. If you want to use a condenser microphone with the Wraith, you will
need an inline phantom power supply, like the Sescom SES-IL-PPI phantom power inserter.
Loading...