Server 07500 Owner’s Manual

01751-REVA�080414�ENGLISH

MODEL:

SERVER EXTREMETM PUMP
07518
07821

PUMP CLEANING

BEFORE FIRST USE AND AFTER USE DAILY OR
REGULARLY, DISASSEMBLE AND CLEAN PARTS.
FOR SAFE AND PROPER CARE, AND TO PREVENT
CORROSION, OF PARTS, IT IS IMPORTANT TO
CLEAN, RINSE, SANITIZE, AND DRY PARTS DAILY OR
REGULARLY. FAILURE TO COMPLY WITH ANY OF THESE
INSTRUCTIONS MAY VOID UNIT WARRANTY.

1 FLUSH AND RINSE ALL INSIDE AND OUTSIDE

SURFACES OF PUMP THOROUGHLY WITH HOT
WATER.

• Place lower end of pump into container of
hot water and operate pump until all (if any)
remaining product is expelled and only hot water

ows from discharge tube. Then remove pump

from container of water to disassemble.

2 DISASSEMBLE PUMP. SEE PUMP DISASSEMBLY.
3 WASH CLEAN ALL PARTS WITH DISHWASHING

DETERGENT AND HOT WATER.

• Clean all conned areas with any supplied

brush(es).

• Do not use scrapers, steel pads, steel wool, or
other cleaning tools that can scratch surfaces.

• Mildly abrasive NYLON or brass brush may be
used to remove any stubborn food or mineral
deposits on interior surfaces of unit.

• Do not use abrasive cleansers.

• Do not use caustic cleansers.

• Do not use cleansing agents with high

concentrations of acid, alkaline or chlorine.

• Do not use ammonia based cleansers.

4 FULLY RINSE ALL WASHED PARTS THOROUGHLY

WITH CLEAR WATER.

• To prevent corrosion on parts, it is important to
thoroughly and fully rinse washed parts.

5 SANITIZE ALL PARTS FOLLOWING LOCAL

SANITIZATION REQUIREMENTS. ALL PARTS IN
CONTACT WITH FOOD MUST BE SANITIZED.

• Allow parts to fully air dry after sanitization.

• Dishwasher safe.

GENERAL SERVICE, REPAIR,
OR RETURNS

Before sending any item to Server Products for service,
repair, or return, contact Server Products customer
service to request a Return Authorization Number.
Merchandise must be sent to Server Products with this
number.

Merchandise being returned for credit must be in new
and unused condition and not more than 90 days old
and will be subject to a 20% (percent) restocking
charge. Electrical parts (thermostats, heating elements,
etc.) are not returnable.

Server Products maintains a fully staffed service
department with highly skilled factory trained personnel.
Service is extremely prompt. Under normal
circumstances, a repaired unit is shipped out the day
after it is received. Labor charges are reasonable.

SERVICE

Contact your dealer or Server Products Inc.
customer service department for the following:

ORDERING REPLACEMENT PARTS

Be prepared to give this information:

• Model Letters/Name/Numbers

• Part Numbers- P/N

• Series Numbers/Letters

• Part Description

This information and other important data is stamped
on the lid or cylinder of pumps or on the bottom or
back side of every unit.

SERVER PRODUCTS
LIMITED WARRANTY

All Server Products equipment is backed by a
two-year limited warranty against defects in materials
and workmanship. For complete warranty information
go to: www.server-products.com

TROUBLESHOOTING

Possible Problems:

• Pump dispenses little or no product.

• Portion control is not consistent.

Possible Solutions:

• Clean pump.

• Ensure product pouch is not empty.

• Ensure product pouch is installed correctly.

• Ensure roller is properly installed on lever.

• Ensure ap inside pump dome and pinch valve are

properly positioned when assembling pump.

• Ensure pump is installed into retaining slot on
inside front wall of unit.

 Server Products Inc.

3601 Pleasant Hill Road
Richfield, WI 53076 USA



262.628.5600



800.558.8722



262.628.5110



[e-mail]



www.server-products.com