Serta 49347 Assembly Instructions Manual
Executive Chair
Assembly Instructions
Model 49347
Casters
Quantity: 5
Star Base
Quantity:1
Gas Lift with Telescoping Cover
Quantity: 1
Seat Plate
Quantity: 1
2
DC
BA
1” Screws
Quantity: 2
1-1/2” Screws
Quantity: 2
1-1/4” Screws
Quantity: 4
K
I
J
PARTS
1-1/2” Screws with
Spring Washers
Quantity: 4
H
D1
D2
Chair Assembly Instructions
Carefully unpack all parts and identify them against the parts list before attempting to assemble. To avoid scratching the
components, assemble the chair on a protected surface.
Note: The casters sold with this chair are intended for use on carpet and not recommended for use on tile or hard wood floors.
Using these casters on tile or wood flooring may cause floor surface damage, so please consider purchasing a chairmat to
protect your floor surfaces.
E1 E2
Seat Cushion
Quantity:1
Back Cushion
Quantity: 1
G
F
Left Arm
Quantity: 1
Right Arm
Quantity: 1
Allen Key M5
Quantity: 1
N
M1
L1
Quantity: 2
Arm Inserts
Quantity: 2
Arm Inserts
L2
M2
3
B
A
B
Step 1
Place the Star Base (B) upside down and insert 5 Casters (A) into
the holes on the Star Base (B).
Step 2
Turn the Star Base (B) over and insert the Gas Lift with
Telescoping Cover (C) through the center hole on top of Star
Base (B).
AA
C
4
Step 3
Attach Seat Plate (D) to the bottom of the Seat Cushion
(F) (with the front of the seat plate facing the front of
seat cushion). Attach by using 1-1/2” Screws (I) for the
front holes of the Seat Plate (D) and 1” Screws (H) for
the rear holes of the Seat Plate (D) and tighten screws.
*Note: Tighten the screws completely.
H
I
F
D
N
Loading...