Serengeti Motorsports Badger E 450 Owner's Manual

Read Instructions Before Using Your New Badger E 450

NOTICE!

NOTICE!

NOTICE!NOTICE!

Before using your new Badger E 450 Mini Bike the first time,

Charge the battery a minimum of 8 hours

Always recharge the battery before the power indicator shows no power.

Failure to follow these instructions nullifies any warranty, whether stated or implied.

Before operating your Badger E 450 Mini Bike

Warning!

This product does not conform to Federal Motor Vehicles Standards and

is not intended for operation on public streets, roads or highways. Serious injury

can result from the unsafe operations of this vehicle.

This product is not designed to be jumped. If jumped, even from the curb,

the Mini Bike Frame could break causing serious injury or death.

If jumped, the warranty is void.

Do not operate this product in traffic, on wet, frozen, oily or

unpaved surfaces or under the influence of drugs and/or alcohol.

Avoid uneven surfaces, potholes, surface cracks and obstacles.

It is recommended that the rider wear leather gloves, kneepads

and leather boots. Always wear a DOT approved helmet.

Never carry passengers on your Badger E 450 Mini Bike.

Minimum age is 16 years.

Check your state and local laws governing the use

Universal Product Concepts, Inc. is not responsible for your

failure to comply with state and local ordinances

relating to the use of the Badger E 450 Mini Bike.

Weight Limit 150 lbs

of motorized vehicles in your area.

Failure to follow these operation instructions

can result in serious injury or death.

CHARGING THE BADGER E 450 MINI BIKE BATTERY

1. To avoid damage to the battery when charging, use only the charger provided with
your Badger E 450 Mini Bike. Mini Bike should be off when charging.

2. Plug the supplied 24V battery charger into a 110V AC power source. Use only 110V AC
outlet when charging the Badger E 450 Mini Bike battery.

3. The CHARGER INDICATOR LIGHT will illuminate confirming that power is connected.

4. Plug the POWER INPUT CORD to the charging port on your Badger E 450 Mini Bike,
located on battery box.

5. When the battery is fully charged, Indicator Light will turn Green.

6. Disconnect the Input Cord from the Charging Port.

7. Disconnect the charger from the 110V power source.

8. Never leave the battery charger connected to the 110V power source when not
charging the battery. This will shorten the life of the charger.

9. When storing your Badger E 450 Mini Bike, the battery should be charged monthly.

Warning!

FAILURE TO KEEP THE BADGER E 450 MINI BIKE BATTERY CHARGED WILL CAUSE

TOTAL BATTERY FAILURE. DO NOT ALLOW BATTERY TO FULLY DISCHARGE.

BATTERY DISPOSAL

When maintained properly, the Lead Acid Battery in this product has a normal life of

many years. When the battery expires, it should be removed from the Badger E 450 Mini

Bike and recycled. Please contact your local solid waste authority for recycling

information in your area.

NOTICE: AFTER REMOVAL. COVER BATTERY TERMINALS WITH ELECTRICAL TAPE TO PRE-

VENT SPARK HAZARD FROM SHORTING OF THE TERMINALS.

BATTERY BOX REMOVAL AND ASSEMBLY

1. Unplug the cord from socket, and turn the key to unlock the battery box.

2. Pull out the battery box along the rail & remove, the battery can now be charged

Ignition

On/Off

Key Switch

separately.

3. Push the battery box into the compartment along the rail, turn the key to lock the box

and plug the cord.

MINI BIKE SPECIFICATIONS

SPECIFICATIONS

Maximum Speed 16 MPH

Minimum Distance 10 Miles

Recharge Time 8 Hours

Load Capacity 150 lbs

Tires 145/70-6 Pneumatic

Dimensions 51.6 x 24.4 x 34.3in

Motor 450W

Transmission Chain Drive

Battery 12V 16Ahx2