serene living S6064 Instruction & Operation Manual

S6064 Shadow Heat & Beat

Infrared Bluetooth App

Outdoor Heaters

Instructions &

Operation Manual

S6064 Shadow Heat & Beat

Safety Information:

This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities, or

lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.

When using any electrical appliance, safety precautions should always
be observed. Read these instructions carefully, and retain for future
reference.

When used by, or near, young children or infirm persons, supervision is necessary ­young children should be supervised to ensure that they donot play with the appliance.

Use this appliance only with the voltage specified on rating label.

Do NOT use this appliance other than for its intended use.

Do NOT touch hot surfaces or moving parts.

Do NOT cover the grilles or place any object or material up against

the unit, as this may block entry or exhaust of air.

Do NOT probe any opening.

To ensure trouble free performance it is recommended that on a regular basis the unit be
isolated from the power supply and a vacuum cleaner used to remove dust from the inlet
and outlet grilles.

Caution:

When the heater is operated ensure the heater is not obstructed in
any way. Ensure the heater can operate safely, should the heater switch on when the
ambient temperature drops, or a timer activates the heater.

 Do NOT allow the supply cord to come into contact with heated

surfaces during operation.

 Regulations require that electrical work be carried out by authorised

persons. For your own safety and that of others, ensure this is done.

 If the supply cord becomes damaged, it must be replaced by a

qualified person, in order to avoid a hazard

•

•6

•7•7

For additional protection the installation of a residual current device
(RCD) is recommended. ( Refer to local electrical regulations)

Remove all packaging material (including anti-vibration pads on the lamp) and check the
appliance, supply cord and the plug for signs of damage.

Pay attention to the mounting place and all mounting material. Ensure they are suitable
and stable enough for mounting and holding the appliance on your chosen surface.

Before mounting, the minimum safe mounting distances and tilt angles shown in the
figures must be strictly followed.

1.The distance between the bottom edge of the appliance and the floor must be at least 1.8 M.

2. There should be a distance of at least 0.2 M between the appliance and ceilings, roofs or other covers.

3. There should be a distance of at least 0.5 M at each side between the appliance and walls etc..

4 .Recommended degree to mounting surface is 45°. See figure 2.

5. The max. swing degree is 90°

Fix the mounting bracket on the wall first. Ensuring that the area of installation is

secure and firm.

Adjust the desired angle of radiation and tighten all screws. Check regularly as the
screws’ may loosen due to vibrations caused by wind or building movement.

Plug or hard wire into your power source.

Check to ensure that the heater is working.

Figure 1: Mounting bracket (wall bracket) and raw plugs Figure 2: Minimum distances to floor, ceiling and wall.
provided. Connection from the wall to the infrared heater.

45mm

45mm

45mm

0.2m

0.5m

1.8mm

Installation

•

Installation cont.

Specifications:

Specification S6064 Heat & Beat

Voltage (V) 220-240

Power consumption (W) 2000W

Dimensions W H D mm 740 x 130 x 175

Weight (kg) 3.9

Infrared receiving Angle 60°±5°

Control distance (m) 6

Figure 3: Mounting bracket (wall bracket) and raw plugs

provided. Connection from the wall to the infrared heater.

•45
°

Speaker 2x3 watts weather resistant