Page 1
SLPUMP50
Electric SUP Air Pump Compressor
Portable SUP Air Inflator & Deflator
(for SUP Stand-Up Paddle-Boards & Pool Inflatables)
Page 2
I. Product Introduction
II. List of Accessories
CATALOGUE
II. LIST OF ACCESSORIES
Please make sure that the following accessories are in the box
before using it, if any missing, please contact with the local
service agents
III. Details of Accessories
IV. Safety Instructions
V. USB Charging Output Operation
VI. Charging using the cigarette lighter plug/adapter
VII. Ination Operation
VIII. Deation Operation
IX. Precautions
X. Fault Handling
XI. Maintenance and Storage
XII. Suggestions
I. PRODUCT INTRODUCTION
This product, SLPUMP50 is an intelligent DC electric pump with
the preset pressure LCD screen, which can be used for inatable
tent, SUP, etc. Thanks to the intelligent pressure system, for
example, if a pressure value is preset, when the pressure reaches
the preset pressure value, the pump will automatically stop
inating.
This product also can deation, and when the inatable product
is not used, you can use the air pump to empty the air inside for
folding and storage.
Air pump Hose User Manual
III. DETAILS OF ACCESSORIES
1. Ination inlet
2. Deation outlet
3. DC plug
4. Pressure value LCD screen
5. USB 1A, 2A charging
output port
6. Charging input port
7. LED light button
8. Pressure unit toggle button
9. ON/OFF button
10. Decompressing button
11. Pressurizing button
12. Hose
13. Air tap
14. Charger
15. DC plug storage place
16. Flexible conduit adaptor
17. LED light
12
5
000 0
7
8
17
1
16
2
Charger
4
6
100%
PSI BAR
..
9
10
11
13
14
15
3
www.SereneLifeHome.com
2
www.SereneLifeHome.com
3
Page 3
IV. SAFETY INSTRUCTIONS
In order to reduce the risk of injury, please keep children
away from it. Always supervise children and incapacitated
person contacting or using this air pump.
• Children shall be kept far away from this product and wire.
• This product is not applicable for the person with declining
physical strength, sensory ability or mental capacity, the person
lack of skill and the mentally retarded person, unless they are
under the protection of their guardians, supervised and directed
at the same time.
• Before moving, maintaining, repairing or adjusting this product,
please rst pull out the DC plug from the socket.
• Please do not bury the wire in the soil, and it should be placed
in a safe zone where it won't be damaged by mower or other
equipment.
• If the power wire is damaged, the power wire must be changed
by the manufacturer or its service agent or the similar authorized
personnel, in case of any risk.
• If you are standing in a place with water or your hands are wet,
please don't plug or pull the DC plug.
• Before inating, please pay attention to check the maximum
bearable pressure of the inatable product, because the air bag
may be damaged upon exceeding the maximum bearable
pressure.
• Before using, please check the cigarette lighter socket to make
sure that there is no rust or residue inside. The cigarette lighter
socket with poor electric conduction may cause overheating
• It is strictly forbidden to place the product in a high-humidity
environment, otherwise the internal circuit of the product might
be short-circuited, causing serious damage to the product.
www.SereneLifeHome.com
4
• Do not throw this product into re which may result in explosion,
battery leakage or other dangers.
• Do not disassemble or break the product randomly for fear of
damaging the product.
• Avoid keeping or using this product under strong sunlight.
Prolonged sun exposure will damage the performance of the
product, resulting in overheat and line problems.
• Do not use or store this product in an environment where the
temperature is too low or too high, which might trigger
automatic protection of the product and cut o the charging of
the digital product.
• Please use this product in a relatively safe environment, and
keep it away from ammable/explosive liquids, gases or
explosives.
• Before charging this product, please verify that the specications
of the adapter match the product. Incompatible adapters
might cause damage to the product or cause risky overload.
• When the product is not in use, please put it in a dry and
ventilated place, and prevent it from colliding with metal
objects for fear of short circuit. Please pay attention to heat
dissipation and ventilation during use, so as to avoid danger
due to excessive temperature.
• If the product is swelling or leakage is found, please stop
using this product.
• Do not disassemble the device without authorization.
This product does not contain spare parts that can be
disassembled/maintained by the user.
• Do not cover or obstruct the product with paper or other
objects for fear of aecting heat dissipation and cooling of the
product.
www.SereneLifeHome.com
5
Page 4
• In order to avoid injury or property damage, unplug the power
cord when not using the product.
• If leakage occurs and the liquid splashes into the eyes
accidentally, do not rub your eyes but rinse your eyes with clean
water immediately instead. If the symptom is serious, please
consult your doctor.
• Before using, please check the cigarette lighter socket to make
sure that there is no rust or residue inside. The cigarette lighter
socket with poor electric conduction may cause overheating of
the product or power source, which will damage the product.
• The purpose of using this product is limited to the description
in the User Manual.
V. USB CHARGING OUTPUT OPERATION
In stand-by or power-on state, connect one end of the data cable
to the mobile phone, and the other end to the USB 1A or 2A
output port of this product to charge the digital product, as
shown in Figure 1.
Figure 1
www.SereneLifeHome.com
6
VI. CHARGING USING THE CIGARETTE LIGHTER PLUG/ADAPTER
In the stand-by or power-on state, take out the cigarette lighter
plug and insert it into the DC12V cigarette lighter socket of the
car or ship to charge or power the product, as shown in Figures 2
and 3.
Figure 3Figure 2
VII. INFLATION OPERATION
• Press and hold the switch for 3 seconds to enter standby state.
• Connect the end with exible conduit adaptor（5）of the hose
with the air pump ination inlet (5), and twist clockwise to
tighten it, as Figure 5.
• Connect the other end of the hose with the air nozzle that
matches the air bag, and insert the ination valve of the air bag.
Turn it clockwise to x it as shown in Figure 6.
• Press the pressure unit switching button and select the
unit you need.
• Press the pressure increase button or pressure reduction
button to set the desired pressure value. The pressure
range is from 0 to 16 PSI (1 PSI = 0.0689 bar = 6.89KPA).
Upon the completion of the above steps, press the power on/o
button to start ination.
• In the process of ination, you can press the pressure increase
button or the pressure reduction button to increase
or decrease the pressure value.
www.SereneLifeHome.com
7
Page 5
• Press the pressure unit switching button to switch
between the units, and press the power on/o button
to stop.
Figure 6Figure 5
• When the pressure reaches the set value, the air pump will stop
working automatically.
• Upon the completion of ination, it will turn o automatically
without other operations within 2 minutes.
• After pulling out the DC plug, please take down the hose from
the air pump and air bag and store it.
• Notice: The factory set pressure value of the air pump is 10PSI
(10PSI=0.689BAR), and at the time of the secondary use, the set
pressure value for the last time use will be displayed by default.
• Notice: After powered on, if there is no operation within 2
minutes, the air pump will enter standby mode, and the
machine can be initiated by pressing the power switch button.
VIII. DEFLATION OPERATION
• Remove the hose from the ination inlet. Connect the end with
exible conduit adaptor (6)of the hose with the air pump
deation outlet (7), and twist clockwise to tighten it, as Figure
3, and the other end shall still be to the airbag.
• Press the button of the power switch of air pump, and start the
deation until all the gas is discharged, then the power can be
turned o to stop the deation.
www.SereneLifeHome.com
8
Figure 7
IX. PRECAUTIONS
• As this product has a lithium battery, it can work using the
battery, or the plug of the product can be inserted into the
cigarette lighter socket on the car for use.
• The applied power source must be the 12V DC power source (as
Figure 8).
• Do not block the ination inlet (1) and Deation outlet (2), and
ensure that the ination inlet (1) and Deation outlet (2) shall
remain smooth at all times.
• Observe the local waste treatment provisions, and it is not
allowed to throw the air pump away randomly.
• Don't use this product when the hose is damaged, and please
change the hose immediately.
• Don't pull out the hose when inating, because that the high
pressure may hurt the physical body.
• Don't make the air pump work for more than 30 minutes,
because that motor overheating may cause internal damage;
and the air pump shall be fully cooled for 30 minutes after
continuously working up to 30 minutes.
• Please don't use this air pump if any part is damaged, and contact
with the professional personnel to repair it.
• This product shall not be exposed to
the rain or immersed in water.
• In order to prevent risk, the ination
inlet shall not be forward to face or
body.
• Please don't not leave while inating.
Figure 8
www.SereneLifeHome.com
9
Page 6
X. FAULT HANDLING
Fault Inspection Solution
The air pump
won't start
normally
Slow or
abnormal
ination or
deation.
1. The power source is
not plugged properly.
2. Low battery charge
3. Overheating or over-
load causes motor stop.
1. Check whether the
hose is blocked or
cracked.
2. The joint between the
hose and air pump or
air bag is not installed
properly.
1. Make sure that the power wire
is plugged in the 12V DC socket.
2. Charging.
3. Cool the motor and restart it.
4. If the problem cannot be
solved, please contact local
service agents or similar
authorized personnel to
change the product.
1. Change the hose or make it
unblocked, and check whether
the hose is cracked.
2. Reinstall the hose.
3. If the problem cannot be solved,
please contact local service
agents or similar authorized
personnel to change the
product.
IX. MAINTENANCE AND STORAGE
After using, or if you want to move, maintain or adjust the
•
product, please rst pull out the DC plug from the socket.
• When idle, it shall be properly stored after being fully cooled.
• It shall not be exposed to the rain or immersed in water.
• Please store it in the dry and ventilated place.
XII. SUGGESTIONS
The warranty period of this product is one year, and it is
suggested to use the original accessories. For any fault not
caused by using the original accessories, it shall be out of the
warranty scope.
www.SereneLifeHome.com
10
www.SereneLifeHome.com
11
Page 7
SLPUMP50
Electric SUP Air Pump Compresso
Portable SUP Air Inator & Deator
(for SUP Stand-Up Paddle-Boards & Pool Inatables)
What’s in the Box:
• SUP Air Pump Inator
• Detachable Air Hose
Features:
• SUP Air Pump Inator Deator System
• Smart Inator Design with Air Pressure Preset
• Ability to Set a Target PSI Pressure Level
• Deation Mode Quickly Removes Air
• Simple Electric-Plugin Design
• Digital LCD Display Screen
• Touch Button Control Panel
• Adjustable PSI Air Pressure Settings
• Can be Powered via Integrated Car Cigarette Plug Power Cable
• Built-in Rechargeable Battery
• Button Activated LED Flashlight
• Housing Access Lid to Store Power Cable
• Convenient Carry Handle for Portability
• Maneuverable Long Flexible Air Hose
• Used for SUP Stand-Up Paddle-Boards & Backyard Pool
Inatables
• Wall Power Adapter
• Storage / Travel Bag
Technical Specs:
• Power Output: 110 Watt
• Selectable Pressure Units: PSI / Bar
• Adjustable Air Pressure: 0-16 PSI (Up to 1.10 Bar)
• Air Hose Length: 3.3 ft.
• Car Cig Power Cable Length: 9.8 ft.
• Charge Time: About 6 Hours
• Rechargeable Battery: 12V LI-ION, 6000mAh
• Power Supply:120V Wall Power Adapter / DC 12V
• Dimensions (L x W x H): 9.9’’ x6.9’’ x 5.2’’ -inches
Questions? Issues?
We are here to help!
Phone: (1) 718-535-1800
Email: support@pyleusa.com
www.SereneLifeHome.com
12
www.SereneLifeHome.com
13
Loading...