Sercomm SZWTD01 User Manual

SZ-WTD01 ZigBee Water Sensor Installation Guide

Specification

Frequency 2.4GHz Battery Type DC 3V, CR2032x2 Application Basements, laundry rooms, bathrooms, kitchens etc Water Sensor Cable Length 3M (10 ft) Operating Temperature Storage Temperature Battery Life 2 years RF Range

Dimension Main Unit: 65 mm x 30 mm x 13 mm (2.60" x 1.18" x 0.51")

0° C to 50° C (32° - 122°F)

-20° C to 70° C (-4° - 158°F)

Open Air：100M

Detector Unit: 45 mm x 15 mm x 10 mm (1.77" x 0.59" x 0.39")

Package Contents

Intallation

1. Insert a flat screwdriver into the notch of the casing. Twist carefully to open the front cover.

2. Install the supplied CR2032 batteries properly.

Note: Please observe the battery polarity to ensure the correct connections while installing the batteries. Use only the CR2032 batteries for replacement.

3. Attach the front cover to the device.

4. Hold the sensor near the top of the door, close to the opening edge of the door. This is the mounting location for the sensor.

5. Use either one of the following methods to install the sensor:

• Remove the back plate of the sensor; use this as the mounting bracket. Use the screwdriver to

secure the back plate to the wall with the screws provided.

• Use provided adhesive on the sensor. Attach the sensor to the door. Press firmly and hold in place

for a few seconds.

Operation

• Join Function

SZ-DWS01 v1.0

01/11/12

+ 2 hidden pages