Sercomm SZESW01 User Manual

SZ-ESW01 ZigBee Energy Switch Installation Guide

SZ-ESW01 is an electrical power measuring device, which with its embedded radio frequency (RF) technology that is compatible
with ZigBee enabled devices, regardless of the manufacturer and can also be used with other devi ces wi t h the ZigBee l ogo.

Furthermore, SZ-ESW01 can works as a signal repeater that will extend the wireless transmission range and increase the reliability
of your network. With a ZigBee compatible gateway and software program, you’ll also be able to monitor and inform the energy
usage of the connected appliance.

Specification

Radio Frequency 2.4GHz
RF Communication Range

LED Indicator Red / Greed LED x 1
Power Source 120 VAC
Max Load 15A
Dimensions (H x W x D) 91.7 mm x 57 mm x 40.7 mm (3.61” x 2.24” x 1.6”)
Operation Temperature 0° - 45°C (32° - 113°F)
Storage Temperature -20° - 70°C (-4° - 158°F)

Open Air：100M (Max)

Package Contents

Warnings and Cautions

• To be installed and/or used in accordance with appropriate electrical codes and regulations.

• If you are unsure about any part of these instructions, please consult a qualified electrician.

• To reduce the risk of overheating, do not install near heat sources, such as fires, boilers or heating vents.

• Do not locate the device facing direct sunlight or humid place.

• Save this instruction sheet. It contains important technical data, which will be useful for future reference.

1

LEDs

Power (Red/Green)

On (Red) - When ON/OFF button is pressed to ON.
Blinking (Green):

• The LED will blink for 10 seconds when join/leave function is being processed.

• The LED will be on for 2 second and then off when join/leave function is succeeded.

Installation

NOTE: In order to use SZ-ESW01 in a ZigBee network, the device must be joined into the network by using a ZigBee
Coordinator. Please refer to the ZigBee Coordinator instruction sheet for complete information.

1. Put the SZ-ESW01 into wall receptacle. Make sure the receptacle is working properly. If it is controlled by a wall switch,

which must be set to ON all the times.

2. Attach the appliance to the SZ-ESW01.

Operation

1. ON/OFF Button 2. Join/Leave Button

Auto Operation:

NOTE: For complete details on operating by the ZigBee Coordinator, please refer to the individual device’s instruction guide.
If a power interruption should occur while the device is ON, the appliance will be set to off when power is restored.

• ON: This command will turn on the appliance to the previous setting.

• OFF: This command will turn the appliance off.

MANUAL Operation:

• ON: Press the ON/OFF button of the device to turn the appliance on.
NOTE: The appliance will be turned ON regardless of the previous setting.

• OFF: Press the ON/OFF button to turn the appliance off.

2