Sercomm SZBSW01 User Manual

SZ-BSW01 ZigBee Binary Switch Installation Guide

SZ-BSW01 can provide "smart" lighting remote control with its embedded radio frequency (RF) technology that is compatible with ZigBee enabled devices. This device is designed to give you one-touch control of your home's lighting.

In a ZigBee network, each device is designed to act as a router. These routers will re-transmit the RF signal from one device to another until the signal is received by the final destination. Using RF technology ensures SerComm to provide great signal through all the obstacles and radio dead spots. The plug-in Lamp Module of SZ-BSW01 is compatible with any ZigBee enabled network, regardless of the manufacturer and can also be used with o t her de vi ces wi t h the ZigBee l ogo.

CAUTION: Remember to have common sense while using the remote control, especially when scheduling unattended devices. There can be some unexpected consequenc es if used without care. For example, if an empty coffee pot is remotely turned on, and your coffee pot could be damaged from overheating. Or if an electric heater is turned on by remote control while clothing is draped over it, it may result a fire. DO NOT USE the remote for controlling the high power heating appliances such as portable heaters. This device will not control lighting used with electronic low-voltage and high frequenc y power supp ly transformers, nor high pressure discharge lamps (HID lighting), which include mercury-vapor, sodium vapor and metal halide lamps. DO NOT change location after unit is enrolled in ZigBee network.

Specification

Rado Frequency 2.4GHz RF Communication Range

LED Indicator Red / Greed LED x 1 Power Source

Output Max Current 10A Dimensions (H x W x D) 55 mm x 55 mm x 38 mm (2.15” x 2.15” x 1.48”) Operation Temperature 0° - 50°C (32° - 122°F) Storage Temperature -20° - 70°C (-4° - 158°F)

Open Aire：100M (Max)

Input：120 VAC, 0.5A, 50-60 Hz

Package Contents

Warnings and Cautions

 To be installed and/or used in accordance with appropriate electrical codes and regulations.  If you are unsure about any part of these instructions, please consult a qualified electrician.

 To reduce the risk of overheating and possible damage to other equipments, do not install for controlling a motor-operated

appliance, fluorescent lighting fixture, or a transformer supplied appliance.

 Unplug unit when servicing the connected lighting fixtures.  Save this instruction sheet. It contains important technical data along with testing and troubleshooting information, which will

be useful for future reference.

LEDs

Power (Red/Green)

On (Red) - When ON/OFF button is pressed to ON. Blinking (Green):

 The LED will blink for 10 seconds when join/leave function is being processed.  The LED will be on for 1 seconds when join/leave function is succeeded and then off

Installation

NOTE: In order to use SZ-BSW01 in a ZigBee network, the device must be Included into the network by using a Primary Programmer/Remote. Please refer to the Remote Control instruction sheet for complete information.

1. Put the lamp’s plug into SZ-BSW01.

2. Attach the SZ-BSW01 into wall receptacle. Make sure the receptacle is working properly. If it is controlled by a wall switch,

which must be set to ON all the times.

WARNING: For use with up to 1000 Watts incandescent lights.

+ 2 hidden pages