Sentry360 IS-DM260-R, IS-DM260 Quick Manual

ActiveX Controls and Plug-ins Settings Internet Security Level

Step 1: Start the Internet Explorer (IE).
Step 2: Select <Tools> from the main menu of the

browser. Then Click <Internet Options>.

Step 3: Click the <Security> tab and select “Internet”,

and click <Custom level> to change ActiveX
settings.

Step 4: Set “ActiveX controls and plug-ins” items to

<Prompt> or <Enable>.

Step 1: Start the IE.
Step 2: Select <Tools> from the main menu of the

browser. Then Click <Internet Options>.

Step 3: Click the <Security> tab and select “Internet.”
Step 4: Down the page, press “Default Level” and click

“OK” to confirm the setting. Close the browser
window, and open a new one later for
accessing the IP Dome Camera

IS-DM260/260-R Quick Guide

The quick guide is for quick installing and connecting the IS-DM260. For details, please refer to the camera’s user
manual.

PoE Connection

Please follow the instructions below to complete the Ethernet connection of IS-DM260.

Indoor Camera
Connect the one end of the PoE cable to the Ethernet port on the camera, and the other end to Power Sourcing
Equipment (PSE) like hubs or routers.

NOTE: Check the status of the link indicator and activity indicator LEDs; if the LEDs are unlit, please check
LAN connection.

Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.

Rugged Camera
For the Rugged IS-DM260, connect its Ethernet cable to a M12/RJ-45 waterproof switch. Please refer to the IS­DM260’s user manual for further details.

Before Login to the IS-DM260 A client

program will be automatically installed on your PC when connecting to the IS-DM260. Before accessing to the IS­DM260, please ensure downloading the ActiveX control is allowed by either changing the ActiveX controls and plug­ins or setting Internet’s security level to default. For further details, please refer to the IP
Dome Camera’s user manual.

IS-DM260 Login The IS-

DM260’s default IP address is: 192.168.0.250. Therefore, to access the IS-DM260 for the first time, set the PC’s IP
address as: 192.168.0.XXX; for example:

IP Address: 192.168.0.100
Subnet Mask: 255.255.255.0

Login ID & Password

•

Key in the IS-DM260’s IP address in the URL bar of the Web browser window and press “Enter.”

•

Enter the default user name (Admin) and password (1234) in the prompt request dialogue. Note that user name is
case sensitive.

Install the ActiveX control

•

After connecting to the IS-DM260, the request for installing the ActiveX control will appear just below the
URL bar.

•

Right Click on the information bar, and press “Install ActiveX Control…” to permit ActiveX control installation.

•

In the pop-up security warning window, click “Install” to start downloading DC Viewer software on the PC.

•

Press “Finish” when DC Viewer installation is complete.

Browser-based Viewer

The main page of the IS-DM260 user interface is as shown below. Please note that the function buttons will vary
depending on the camera model.

Full HD Multiple Streaming Compact IS-DM260

Quick

Guide

Ver1.1

00P5NX103ZXSEA1