φ148.4(W)x160.8(H) m/m
φ148.4(W)x160.8(H) m/m
FS-DM-DOME
DOME INSTALLATION
INSTRUCTIONS
1. CHARACTER
Sentry 360 Camera Dome Case can use indoor and outdoor, and enable to more easy installation the
camera. Also let the camera can take by 360° without barriers. The camera dome case has been
produced using die-castings in highest quality aluminum materials, UV powder coating and high
definition, high transmittance riot PC transparent cover. This case can be matched to a straight pipe or
bend pipe bracket.
2. SPECIFICATIONS
Model
Use Indoor / Outdoor use
Options Blower (B) / Heater (H) / PoE Board
Input Voltage DC48V PSE
Power Consumption 9.6W
Operational Range IP DOME Temperature: : -15℃~+50℃ Humidity:: 0~95%
Heater Blower Switch On Heater : ON 4℃±3 ℃
Size
Weight IP DOME: 1.8 KG, DOME : 1.6 KG,
Material
Water Proof IP66
Accessory
FS-DM-DOME
Mode
IP DOME
DOME
Body：Aluminum（ADC-12） Window PC transparent cover
5mm Wrench（1ea）. Plastic expansion-(4ea). M4 steel screw -（4ea）
φ130.5(W)x155.3(H) m/m
φ130.5(W)x155.3(H) m/m
3. DRAWINGS/CONTENTS
4. INSTALLATION INSTRUCTIONS
(a) Locate vandal screws (b) Remove screws
(c) Remove vandal proof lid
POE Ports
Conduit Hole
Optional DC
Locking Screw
Blower
(d) Secure camera to lock (e) Slide camera inside, lock into place
Finished installation of camera into dome housing.
Quick Reference Notes
- Open Dome cover with included ranch.
- Unscrew Camera plate.
- Install Camera Plate on Camera Body.
- Plug in all necessary cables.
- Install Camera with Camera Plate into the Dome Case and Camera holder Arm.
- Plug in Power.
- Close the cover and tighten the screws.
5. POE INFORMATION
- IEEE802.3af Fully Compliant
- Compatible with IEEE802.3af PD
- PD(Powered Device) Detection, Classification
- In-rush Current Limit, Over-current Protection
- Auto-restart Fault Management
- Easy Installation
- Optional Monitoring with LED
- Input Voltage : +38~57 VDC
- Output Voltage : DC 12±0.5V ( Max 10W )
- B75User Port Power : DC 12 ± B730.5V ( Max 5W )
Fan : DC 12V ( 1W ) (Blowing all time)
Heater : DC 12V ( 2W ) Under +15℃ (±5℃).
Located on the back of the camera are
4 (four) punch outs. Screws can be
used to either surface mount the
dome, or to attach to one of our
adapters.
6. OPTIONAL POWER INFORMATION
+
RJ45 Terminal Layout
Terminal Layout Pin Input Output
1
2
3
4
5
6
7
8
Tx+
-
Tx
Rx
Power_A
Power_A
-
Rx
Power_B
Power_B
Tx+
Tx-
Rx+
Power_A
Power_A
Rx-
Power_B
Power_B
7. ACCESSORIES
FS-DM-WALL FS-DM-CEILING FS-DM-CORNER FS-DM-POLE
*** ACCESSORY IMAGES/APPEARANCES SUBJECT TO CHANGE ***
Loading...