Sentry RMC10 Instruction Manual

USING THE RMC10 REMOTE WITH AN UNLISTED DEVICE.

MANUAL CODE SEARCH:

If your product does not respond after you have tried all the codes for your brand, or if
your brand is not listed, try searching for your code by following these steps:

1. Manually turn on the device (TV, VCR, etc.) to be controlled.

2. Press and hold the CODE SEARCH button until the red indicator stays on, then
release the CODE SEARCH button.

3. Press and quickly release the desired mode button (TV, VCR, etc.). The red Indicator
blinks off once.

4. Face the remote control directly to the device you want to control (TV, VCR etc).

5. Press the ON/OFF button repeatedly (up to 300 times) until the device to be
controlled changes channel. The red indicator blinks off with each button press.

6. Press and release ENTER to install the code.

Most users will store VCR codes under the VCR button, Cable codes under CABLE,
etc. If (for example) you want to store a VCR code under CABLE, first follow the
procedure for Direct Code Entry (previous page) and press CABLE in step 2 of Direct
Code Entry, then enter ANY VCR code in step 3 of Direct Code Entry. Then follow the
steps above for Code Search (or Brand Search, below). Note: If the device does not
have a CHANNEL UP button, use PLAY (VCR only) or POWER instead. Code Search
starts from the currently stored three digit number under that mode.

AUTO CODE SEARCH:

If your product does not respond after you have tried all the codes for your brand, or if
your brand is not listed, try searching for your code by following these steps.

1. Manually turn on the device (TV, VCR, etc.) to be controlled.

2 Press and hold the CODE SEARCH button until the red indicator stays on, then
release the CODE SEARCH button.

3. Press and quickly release the desired mode button (TV, VCR, etc.). The red indicator
blinks off once.

4. Face the remote control directly to the device you want to control (TV, VCR etc).

5. Press the ON/OFF button down till the Red Indicator Light stays on.

6. The red led indicator will keep on flashing till your device (TV, VCR etc) turns off.

7. Press and release enter to Install the code.

CODE RETRIEVAL:

1. Manually turn on the device (TV, VCR etc) to be controlled.

2. Press and hold the CODE SEARCH button until the red Indicator stays on, then
release the CODE SEARCH.

3. Press the device control (TV, VCR etc) you want to control.

4. Press the CODE SEARCH button again and the red indicator should blink once.

5. Follow the sequence of (0-9)and press once for each number button until the
Indicator flashes one time.

6. Repeat the procedure 5 till 3 correct codes are confirmed.

7. If the red indicator light flashes, than you have entered an incorrect number, and
please follow the sequence (0-9).

NOTE: IF YOUR UNLISTED DEVICE CONTINUES NOT TO RESPOND AFTER FOLLOWING
THESE INSTRUCTIONS, PLEASE CONTACT THE MANUFACTURE OF THE UNLISTED
DEVICE IN ORDER TO OBTAIN THE CORRECT CODES.