AM/FM 2 BAND DIGITAL DISPLAY
RADIO WITH DYNAMO FLASHLIGHT
& LED READING LAMP
INSTRUCTION MANUAL
INSTRUCTION MANUAL
AM/FM 2 BAND DIGITAL DISPLAY
RADIO WITH DYNAMO FLASHLIGHT
& LED READING LAMP
WARNINGS AND PRECAUTIONS
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
This symbol, located on back or bottom of the unit, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to persons.
This symbol, located on back or bottom of the unit, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
This symbol is intended to alert the user to the presence of impor tant operating and maintenance (servicing) instructions in the literature accompanying the appliance.
Any use of the controls or an adjustment to the procedures other than those specified herein may result in hazardous radiation.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). THERE ARE NO USER-SERVICEABLE PAR TS INSIDE. PLEASE REFER ANY SERVICING TO
QUALIFIED SERVICE PERSONNEL.
FCC Requirements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. however, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
inter ference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Special Note
When placing your unit on a lacquered or natural finish, protect your furniture with a cloth or other protective material.
TABLE OF CONTENTS
LOCATION OF FEATURES
CHARGING THE RECHARGEABLE BATTERY
DYNAMO POWER
AC ADAPTOR (NOT INCLUDED)
AUXILIARY BATTERIES (NOT INCLUDED)
SETTING THE TIME
LISTENING TO THE RADIO
SETTING THE ALARM TIME
WAKE TO RADIO OR ALARM CLOCK
USING THE FLASHLIGHT
EMERGING SIREN
REPLACING FLASHLIGHT-LANTERN BULB
REPLACING THE RECHARGEABLE BATTERY
USE LED READING LAMP
CARE AND MAINTENANCE
POWER DURATION
TROUBLESHOOTING GUIDE
1
2
2
2
3
4
5
6
6
7
7
8
8
9
10
10
10
LOCATION OF FEATURES
1.
FLASHLIGHT
2.
FLASHLIGHT/SIREN/OFF SWITCH
3.
ALARM
4.
SPEAKER
5.
LCD DISPLAY
6.
TIME SET BUTTON
7.
HOUR SET BUTTON
8.
POWER INDICATOR
9.
RECHARGE/BATTERY LOW INDICATOR
10.
ALARM SET BUTTON
20
21
22
23
24
25
26
18
19
21.
11.
MINUTE SET BUTTON
12.
RADIO/CLOCK BUTTON
13.
POWER SOURCE SWITCH
14.
BACK LIGHT BUTTON
15.
VOLUME KNOB
16.
TUNING KNOB
17.
READING LAMP
18.
MODE
19.
BAND SWITCH
20.
FM/WEATHER ANTENNA
HANDLE
22.
EAR PHONE JACK
23.
DC-IN JACK
24.
DC-OUT JACK
25.
BATTERY COMPARTMENT
26.
DYNAMO CRANKING HANDLE
- 1 -
CHARGING THE RECHARGEABLE BATTERY
DYNAMO POWER
AC ADAPTOR (NOT INCLUDED)
DC 6V/200mA
AC OUTLET
- 2 -
Note: Crank the dynamo
clockwise at a moderate
speed for about 3 minute.
This will provide a 1/5
charge.
Note: Keep the AC Adaptor
(Not Included) connected for
about 12 hours to fully charge.
You can also power an external
device such as a cell phone
(subject to device compatibility),
(Not Included), Connect the device
to the dynamo out jack and crank
the dynamo.
AUXILIARY BATTERIES (NOT INCLUDED)
Replace the 3 "AA" batteries with new ones when the low battery indicator
illuminates or sound become unstable or cannot be heard or the clock display no
longer functions.
3 X "AA" Battries
for Back-up
RED
LED
- 3 -
SETTING THE TIME
1
Time set
2
3
Note: In the Radio on mode,
press the radio/clock
button to alternate
between radio and
clock displays.
- 4 -
LISTENING TO THE RADIO
RECHARGEABLE BAT T.=BUILT-IN NiCAD BATTERY
BATT.=3 "AA" ALKALINE BATTERIES (NOT INCLUDED)
FM
Volume
TO IMPROVE RECEPTION
LISTENING WITH HEADPHONES (NOT INCLUDED)
- 5 -
SETTING THE ALARM TIME
1
4
WAKE TO RADIO OR ALARM CLOCK
TURN TO THE
DESIRED
STATION
SETTING
SOUND
LEVEL
Volume
2 3
Note: Press the Alarm button once - the buzz sound will stop
for today and turn on the same time tomorrow. Press the
Alarm button twice - the Alarm indicator will disappear and
5
WAKE TO RADIO
4
the alarm will not be heard tomorrow.
WAKE TO ALARM BUZZ
- 6 -
USING THE FLASHLIGHT
EMERGENCY SIREN-FLASHING LIGHT
- 7 -
REPLACING FLASH LIGHT BULB
Unscrew the front cover. Remove the bulb by turning counter
clockwise. Replace the light bulb with 3.6V/0.3A.
(White LED optional)
REPLACING THE RECHARGEABLE BATTERY
Rechargeable
Battery Pad
- 8 -
3 X "AA" Batteries
for Back-up
USE LED READING LIGHT
LIFT UP TO TURN ON LED
READING LAMP
- 9 -
CARE AND MAINTENANCE
GENERAL
Use a soft, clean cloth moistened with plain, luke-warm water to clean the exterior of the unit.
Never use solvents such as benzene or other strong chemical cleaners since these could damage the unit's finish.
It is important that no liquid reaches the inside of the unit.
POWER DURATION
GENERAL
RADIO
10 days with new alkaline batteries/ 8 hours with fully
charged built-in NiCad battery.
1 day with new alkaline batteries/ 1 hour with fully
charged built-in NiCad battery.
TROUBLE SHOOTING GUIDE
PROBLEM
No sound is heard. Power is not on.
VOLUME Control is set to minimum.
Station has not been tuned properly.
FM reception is weak.
AM reception is weak.
FLASHLIGHT
POSSIBLE CAUSE
GENERAL
- 10 -
BLINK/SIREN
2 days with new alkaline batteries/ 2 hours with fully
charged built-in NiCad battery.
SOLUTION
Select appropriate power source.
Adjust the VOLUME Control.
Tune station properly.
Extend the FM antenna.
Adjust the position of the unit.
PMMU-0038-0105
Loading...