Sennheiser Electronic RR2000 User Manual

Co un try/

Region

Compliance Information

TR 2000 RR 2000 TR 5000 RR 5000 RR Flex

USA

Canada

Europe

FCC ID:DMOTR2000 FCC ID:DMORR2000 FCC ID:DMOTR5000 FCC ID:DMORR5000 FCC ID:DMORRFLEX

IC: 2099A-T R2000 IC:2099A -RR2000 IC:2099A-TR5000 IC:2099A-RR5000 IC :2099A-RRFLEX

CAN IC ES-3 (B)/N MB-3(B)

Australia/ New Zealand

Complies with

Singapore

Japan

IMDA Standards

DB100582

201-16324

Statements regarding FCC and Industry Canada

FCC Declaration of Conformity (DoC)

SENNHE ISER Model No:

Sennheiser Electronic Corporation

We,

One Enterprise Drive • Old Lyme • CT 06371 • US A Te l: +1 (860) 434 9190 Fax: +1 (860) 434 1759

declare the above device comply with the requirements of Federal Communications Commission.

This devi ce complies with Part 15 of the FCC rules. Operation is subject ed to the following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference that may cause undesired operation.

Responsible Party: Markus Warlitz

TR 2000, RR 2000, TR 5000, RR 5000, RR Flex

201-16324

This device complies with Part 15 of the FCC rules and RSS-247 of Industry Canada. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including inter ference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules and RSS-247 of Industry Canada. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications made to this equipment not expressly approved by Sennheiser electronic Corp. may void FCC authorization to operate this equipment.

CA N ICES -3 (B)/NMB-3(B)

Déclaration requise par la FCC et l’Industrie Canada

Clarity_SG_120x245_572438_Compliance_inf.indd 9 11/15/2016 11:26:22 AM

Compliance Information

Cet appareil est conforme à la Partie 15 des réglementations de la FCC et à la norme CNR-210 d’Industrie Canada. L’utilisation de l’appareil doit respecter les deux conditions suivantes : (1) L’appareil ne doit pas produire d’inter férences nuisibles, et, (2) il doit accepter toutes interférences reçues, y compris celles qui pourraient avoir des effets non désirés sur son fonctionnement.

CA N ICES -3 (B)/NMB-3(B)

RF Radiation Exposure Information

Since the radiated output power of this device is far below the FCC / IC radio frequency exposure limits, it is not subjected to routine RF exposure evaluation as per Section

2.1093 of the FCC rules and RSS-102 of Industry Canada.

This device meets FCC/ IC RF exposure guidelines for an uncontrolled environment. The transmitter of this device should be installed and operated at least 20 cm away from the user’s body. Use of other accessories not verified by the manufacturer may not ensure compliance with FCC / IC RF exposure guidelines.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

Information sur l’exposition aux rayonnements radio fréquence (RF)

La puissance RF rayonnée de cet appareil étant de loin inférieure aux limites imposées par la FCC / IC, il n’est pas soumis à la réglementation sur l’exposition aux RF selon la section 2.1093 de la réglementation FCC et CNR-102 de Industrie Canada.

Cet équipement est conforme aux limites d‘exposition aux rayonnements imposées par la FCC / IC pour un environ- nement non réglementé. L‘émetteur de cet équipement doit être installé et utilisé à une distance minimale de 20 cm du corps de l‘utilisateur. L‘utilisation d‘autres accessoires non homologués par le fabricant remet en cause la conformité des normes imposées par la FCC / IC.

Cet émetteur ne doit pas être positionné à proximité d‘une autre antenne ou d‘un autre émetteur, ni utilisé avec une autre antenne ou un autre émetteur.

EU Declaration of Conformity (Simplified)

Sennheiser electronic GmbH & Co. KG declares that the following device(s) are in compliance with Radio Equipment Directive (2014/53/EU):

• TR 2000 • TR 5000 • RR Flex

• RR 2000 • RR 5000

The full text of EU Declaration of Conformity is available at

www.sennheiser.com/download

Sennheiser electronic GmbH & Co. KG

Printed in China Publ. 11/16, 572438

Am Labor 1, 30900 Wedemark, Germany www.sennheiser.com

Clarity_SG_120x245_572438_Compliance_inf.indd 10 11/15/2016 11:26:22 AM