Sennheiser Electronic M3IETW2L, M3IETW2R Users manual

M3IETW2 Compliance Information

201-180684

◭ẽ◊ Ⰶ䅽◊ ᥵㋕㋱◊㦲♹ⱥẵ㊹㱵㳺⸥⸡ⷩ㲡㇮♹ⱥ᥵᥵ ㍡㎵㋕ ㍡㎵ᢲ㑖ᢲ

Battery:

Frequency band: 2400 – 2483.5 MHz

Transmit power: 10 mW (max)

Country/Region

USA

Canada

Right earbud

M3IETW2 R

FCC ID: DMOM3IETW2R FCC ID: DMOM3IETW2L

IC: 2099A-M3IETW2R IC: 2099A-M3IETW2L –

Left earbud M3IETW2 L

CAN ICES-3(B)/NMB-3(B)

Charging case

M3IETW2 C

–

Europe

Australia/ New Zealand

R-R-SE9-M3IETW2

South Korea

China

CMIIT ID: xxxxxxxxxx CMIIT ID: xxxxxxxxxx –

Japan

Taiwan

Singapore

General IPX4* –

M3IETW2 R, M3IETW2 L, M3IETW2 C Sennheiser electronic GmbH & Co. KG

Sennheiser electronic GmbH & Co. KG

201-190814

xxxxxxxxxxxxx

Complies with

IMDA Standards

DB100582

201-190815

xxxxxxxxxxxxx

XU100367-18038A or

XU101576-18001A

–

* Protection rating according to International Protection Marking (IP code), IEC standard 60529. The earbuds were tested under controlled laboratory conditions. The earbuds are splash resistant for non-water sports and exercise. Splash resistance might decrease as a result of normal use. Do not charge wet earbuds. The charging case is not splash resistant. For more information, please refer to the instruction manual.

Statements regarding FCC and Industry Canada

FCC Supplier's Declaration of Conformity (SDoC)

Sennheiser Elect ronic Corporation

We,

One Enterprise Drive • Old Lyme • CT 06371 • USA Tel: +1 (860) 434 9190 Fax: + 1 (860) 434 1759

declare the above device comply with the requirements of Federal Communications Commission.

This device complies with Part 15 of the FCC rules. Operation is subjected to the following two conditions:

1) This device may not cause harmful interference, and

2) This device undesired operation.

Responsible Party: Michael Lieske

This device complies with Part 15 of the FCC rules, RSS-247 of Industry Canada. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules, RSS-247 of Industry Canada. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/T V technician for help.

Changes or modiﬁcations made to this equipment not expressly approved by Sennheiser electronic Corp. may void FCC authorization to operate this equipment.

Déclaration requise par la FCC et l’Industrie Canada

Cet appareil est conforme à la Partie 15 des réglementations de la FCC et aux normes CNR-247 d’Industrie Canada. L’utilisation de l’appareil doit respecter les deux conditions suivantes : (1) L’appareil ne doit pas produire d’interférences nuisibles, et, (2) il doit accepter toutes interférences reçues, y compris celles qui pourraient avoir des effets non désirés sur son fonctionnement.

CAN ICES-3(B)/NMB-3(B)

RF Radiation Exposure Information

The product complies with the rules of FCC and Industry Canada (RSS-102) for the portable RF exposure limit set forth for an uncontrolled environment and is safe for intended operation as described in this manual. This product is not subjected to FCC routine RF exposure evaluation per Section 2.1093 and RSS102 of Industry Canada. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Use of other accessories not veriﬁed by the manufacturer may not ensure the compliance.

SENNHEISER Model No:

must accept any interference received, including interference that may cause

M3IETW2 R M3IETW2 L M3IETW2 C

Informations sur l’exposition aux radiations RF

Le produit est conforme aux règles de la FCC et d’Industrie Canada (CNR-102) en ce qui concerne la limite d’exposition portable RF déﬁnie pour un environnement non contrôlé et est sans danger pour le fonctionnement prévu, tel que décrit dans ce manuel. Ce produit n’est pas soumis à l’évaluation de routine de l’exposition aux RF par la FCC conformément à la section 2.1093 et à la norme CNR-102 d’Industrie Canada. Une réduction supplémentaire de l’exposition aux RF peut être obtenue si le produit peut être maintenu aussi loin que possible du corps de l’utilisateur ou si l’appareil est réglé sur une puissance de sortie inférieure, si cette fonction est disponible.

Cet émetteur ne doit pas être installé ou utilisé en conjonction avec une autre antenne ou un autre émetteur. L’utilisation d’autres accessoires non vériﬁés par le fabricant ne peut pas garantir la conformité.

Taiwan

經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。

低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

Việt nam

Kể từ ngày 1 tháng 12 năm 2012, các sản phẩm được sản xuất bởi Sennheiser tuân thủ Thông tư 30/2011/TT-BCT quy định về giới hạn cho phép đối với một số chất độc hại trong các sản phẩm điện và điện tử.

China RoHS

部件名称

(Part Name)

金属部件

(Metal Parts)

电路模块 (Circuit Modules)

充電盒

(Charging Case)

本表格依据 SJ/T 11364 的规定编制。

o：表示该有害物质在该部件所有均质材料中的含量均在GB/T 26572规定的限量要求以下。 x：表示该有害物质至少在该部件的某一均质材料中的含量超出GB/T 26572规定的限量要求。

铅

(Pb)汞 (Hg)镉 (Cd)

x o o o o o

有害物质

六价铬

(CrVI)

多溴联苯

(PBB)

多溴二苯醚

(PBDE)

Sennheiser electronic GmbH & Co. KG

Am Labor 1, 30900 Wedemark, Germany www.sennheiser.com

Publ. 12/19, 587177/A01