Sennheiser Electronic M3AEBT Compliance sheet
M3AEBTXL Compliance Information
R-
◭ẽ◊
Ⰶ䅽◊
㋕㋱◊㦲♹ⱥẵ㊹㱵㳺⸥⸡ⷩ㲡♹ⱥ
㍡㎵㋕
㍡㎵ᢲ㑖ᢲ
䂹Ḿ♹ⱥⱩ⦉ㇹ㑖㍉㹑䆁⸥ᝅⱶ㊹㋍㊑
201-170824
PP Release 06/2018
Frequency band: 2400 – 2483.5 MHz
Transmit power: 10 mW (max)
Country/Region M3AEBTXL
USA
Canada
Europe
Australia/New Zealand
Singapore
South Korea
Japan
Taiwan
FCC ID: DMOM3AEBT
IC: 2099A-M3AEBT
CAN ICES-3 (B)/NMB-3(B)
Complies with
IMDA Standards
DB100582
YU10395-17003
CMM-SE9-M3AEBT
M3AEBT
Sennheiser electronic GmbH & Co. KG
Sennheiser electronic GmbH & Co. KG
R
CCAI17LP122BT9
China
Brazil
15
02136-18-07356
Mexico
IFT: RCPSECX17-2054-A2
Indonesia
56538/SDPPI/2018
CMIIT ID: 2018DJ1619
Este equipamento não tem direito à proteção contra interferência
prejudicial e não pode causar interferência em sistemas devidamente
autorizados
La operación de este equipo está sujeta a las siguientes dos condiciones:
1. Es posible que este equipo o dispositivo no cause interferencia perjudicial.
2. Este equipo o dispositivo debe aceptar cualquier interferencia. Incluyendo
la que pueda causar su operación no deseada.
2900
Statements regarding FCC and Industry
PP Release 06/2018
Canada
FCC Supplier's Declaration of Conformity (SDoC)
Sennheiser Electronic Corporation
We,
One Enterprise Drive • Old Lyme •
CT 06371 • USA
Tel: +1 (860) 434 9190
Fax: +1 (860) 434 1759
declare the above device comply with the requirements of Federal Communications Commission.
This device complies with Part 15 of the FCC rules. Operation is s ubjected to
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may c ause
undesired operation.
Responsible Party: Michael Lieske
This device complies with Part 15 of the FCC rules and RSS-247
of Industry Canada. Operation is subject to the following two
conditions: 1) This device may not cause harmful interference,
and 2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules and
RSS-247 of Industry Canada. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications made to this equipment not expressly
approved by Sennheiser electronic Corp. may void FCC authorization to operate this equipment.
Déclaration requise par la FCC et l’Industrie Canada
Cet appareil est conforme à la Partie 15 des réglementations de
la FCC et à la norme CNR-247 d’Industrie Canada. L’utilisation
de l’appareil doit respecter les deux conditions suivantes : (1)
L’appareil ne doit pas produire d’interférences nuisibles, et, (2)
il doit accepter toutes interférences reçues, y compris celles qui
pourraient avoir des effets non désirés sur son fonctionnement.
CAN ICES-3 (B)/NMB-3(B)
SENNHEISER
Model No:
CX SPORT
the following
two conditions:
RF Radiation Exposure Information
Since the radiated output power of this device is far below the
FCC / IC radio frequency exposure limits, it is not subjected to
routine RF exposure evaluation as per Section 2.1093 of the FCC
rules and RSS-102 of Industry Canada.
This device meets FCC/ IC RF exposure guidelines for an uncontrolled environment. Use of other accessories not verified by the
manufacturer may not ensure compliance with FCC / IC RF exposure guidelines.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
Information sur l’exposition aux radiofréquences
La puissance RF rayonnée de cet appareil étant de loin inférieure aux limites imposées par la FCC / IC, il n’est pas soumis à la
réglementation sur l’exposition aux RF selon la section 2.1093 de
la réglementation FCC et CNR-102 de Industrie Canada.
Cet équipement est conforme aux limites d‘exposition aux rayonnements imposées par la FCC / IC pour un environ- nement
non réglementé. L‘utilisation d‘autres accessoires non homologués par le fabricant remet en cause la conformité des normes
imposées par la FCC / IC.
Cet émetteur ne doit pas être positionné à proximité d‘une autre
antenne ou d‘un autre émetteur, ni utilisé avec une autre antenne
ou un autre émetteur.
Taiwan
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用
者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現
有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前
項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機
須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干
擾。
Korea
사용자 정보
1) 해당 무선설비는 운용 중 전파혼신 가능성이 있음
2) 해당 무선설비는 전파혼신 가능성이 있으므로 인명안전과 관련
된 서비스는 할 수 없음
Vietnam
As from December 1, 2012, products manufactured by Sennheiser comply with Circular 30/2011/TT-BCT regulating the permitted limits for certain hazardous substances in electronic and
electric products.
China RoHS
有害物质
部件名称 (Part Name)
金属部件 (Metal parts) x o o o o o
电路模块 (Circuit Modules) x o o o o o
电缆及电缆组件
Cable Assemblies)
本表格依据 SJ/T 11364 的规定编制。
o： 表示该有害物质在该部件所有均质材料中的含量均在GB/T 26572规定的限量要求
以下。
x： 表示该有害物质至少在该部件的某一均质材料中的含量超出GB/T 26572规定的限
量要求。
(Cables &
铅
(Pb)汞 (Hg)镉 (Cd)
x o o o o o
六价铬
(CrVI)
多溴
联苯
(PBB)
多溴二
苯醚
(PBDE)
Sennheiser electronic GmbH & Co. KG
Am Labor 1, 30900 Wedemark, Germany
www.sennheiser.com
Publ. 08/18, 76096/A01PP
Loading...