Sennheiser Electronic M2IEBT User Manual

Print specs:

M2 IEBT Compliance Information

Country/Region Compliance

Paper grammage: 60 gsm Guide delivery: Folded

Print colours: K (1C) Paper quality: woodfree

Open size: C5 (162 x 229 mm) Close size: C7 (81 x 114 mm)

Release date: Dec. 1, 2016 (MP)

USA

Canada

Europe

Australia/New Zealand

IC: 2099A-M2IEBT

CAN ICES-3 (B)/NMB-3(B)

Singapore

Statements regarding FCC and Industry Canada

FCC Declaration of Conformity (DoC)

Sennheiser Electronic Corporation

We,

One Enterprise Drive • Old Lyme •
CT 06371 • USA
Tel: [phone]
Fax: [phone]

declare the above device comply with the requirements of Federal Communications Commission.

This device complies with Part 15 of the FCC rules. Operation is subjected to the following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference that may cause undesired operation.

Responsible Party: Markus Warlitz

This device complies with Part 15 of the FCC rules and RSS-247 of In­dustry Canada. Operation is subject to the following two conditions: 1)
This device may not cause harmful interference, and 2) This device must
accept any interference received, including interference that may cause
undesired operation.

This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules and RSS­247 of Industry Canada. These limits are designed to provide reasona­ble protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications made to this equipment not expressly appro­ved by Sennheiser electronic Corp. may void FCC authorization to ope­rate this equipment.

SENNHEISER
Model No:

M2 IEBT

FCC ID: DMOM2IEBT

Complies with

IMDA Standards

DB100582

Déclaration requise par la FCC et l’Industrie Canada

Cet appareil est conforme à la Partie 15 des réglementations de la FCC
et à la norme CNR-247 d’Industrie Canada. L’utilisation de l’appareil doit
respecter les deux conditions suivantes : (1) L’appareil ne doit pas pro­duire d’interférences nuisibles, et, (2) il doit accepter toutes interféren­ces reçues, y compris celles qui pourraient avoir des effets non désirés
sur son fonctionnement.

CAN ICES-3 (B)/NMB-3(B)

RF Radiation Exposure Information

Since the radiated output power of this device is far below the FCC / IC
radio frequency exposure limits, it is not subjected to routine RF expo­sure evaluation as per Section 2.1093 of the FCC rules and RSS-102 of
Industry Canada.

This device meets FCC/ IC RF exposure guidelines for an uncontrolled en­vironment. Use of other accessories not verified by the manufacturer
may not ensure compliance with FCC / IC RF exposure guidelines.

This transmitter must not be co-located or operated in conjunction with
any other antenna or transmitter.

Information sur l’exposition aux radiofréquences

La puissance RF rayonnée de cet appareil étant de loin inférieure aux
limites imposées par la FCC / IC, il n’est pas soumis à la réglementation
sur l’exposition aux RF selon la section 2.1093 de la réglementation FCC
et CNR-102 de Industrie Canada.

Cet équipement est conforme aux limites d‘exposition aux rayonne­ments imposées par la FCC / IC pour un environ- nement non réglementé.
L‘utilisation d‘autres accessoires non homologués par le fabricant remet
en cause la conformité des normes imposées par la FCC / IC.

Cet émetteur ne doit pas être positionné à proximité d‘une autre an­tenne ou d‘un autre émetteur, ni utilisé avec une autre antenne ou un
autre émetteur.

EU Declaration of Conformity (Simplified)

Sennheiser electronic GmbH & Co. KG declares that the following device or
devices are in compliance with Radio Equipment Directive (2014/53/EU):

• M2 IEBT

The full text of EU Declaration of Conformity is available at

www.sennheiser.com/download

M2IEBT_C5_572334_Incompliance_sheet.indd 1 11/29/2016 4:45:45 PM

Sennheiser electronic GmbH & Co. KG

Am Labor 1, 30900 Wedemark, Germany
www.sennheiser.com

Printed in China, Publ. 12/16, 572334/A01

M2IEBT_C5_572334_Incompliance_sheet.indd 2 11/29/2016 4:45:45 PM