Sennheiser Electronic HDR165, TR165 User Manual

0560

RS 165 HDR 165

The compliance marks for your headphone system are printed under the ear pads of the headphones and on the bottom surface of the transmitter. To remove or replace the ear pads, please refer to the appropriate instruction manual.

Country/Region RS 165 RS 175 RS 185 RS 195

USA

RS 175 HDR 175

FCC ID: DMOTR165 FCC ID: DMOHDR165

RS 185 HDR 185

RS 195 Compliance Information

FCC ID: DMOTR175 FCC ID: DMOHDR175

FCC ID: DMOTR185 FCC ID: DMOHDR185

FCC ID: DMOTR195 FCC ID: DMOHDR195

IC: 2099A-TR165

Canada

Europe

Australia/ New Zealand

Singapore

Sennheiser electronic GmbH & Co. KG

Am Labor 1, 30900 Wedemark, Germany www.sennheiser.com

Printed in China, Publ. 01/15, 551733/A01

RS5_In_compliance_130x130_Sheet_551733_Taiwan.indd 1 10/17/2014 4:27:58 PM

IC: 2099A-HDR165

CAN ICES-3 (B)/NMB-3(B)

IC: 2099A-TR175 IC: 2099A-HDR175

IC: 2099A-TR185 IC: 2099A-HDR185

IC: 2099A-TR195 IC: 2099A-HDR195

Statements regarding FCC and Industry Canada

FCC Declaration of Conformity (DoC)

We,

Sennheiser Electronic Corporation

One Enterprise Drive • Old Lyme • CT 06371 • USA Tel: +1 (860) 434 9190 Fax: +1 (860) 434 1759

declare the above device comply with the requirements of Federal Communications Commission.

This device complies with Part 15 of the FCC rules. Operation is subjected to the following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference that may cause undesired operation.

Responsible Party:

Greg Beebe

SENNHEISER Model No:

TR 165, HDR 165, TR 175, HDR 175, TR 185, HDR 185, TR 195, HDR 195

This device complies with Part 15 of the FCC rules and RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules and RSS-210 of Industry Canada. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications made to this equipment not expressly approved by Sennheiser electronic Corp. may void FCC authorization to operate this equipment.

CAN ICES-3 (B)/NMB-3(B)

RS5_In_compliance_130x130_Sheet_551733_Taiwan.indd 2 10/17/2014 4:27:58 PM

RF Radiation Exposure Information

Since the radiated output power of this device is far below the FCC radio frequency exposure limits, it is not subjected to routine RF exposure evaluation as per Section 2.1093 of the FCC rules.

This device meets FCC RF exposure guidelines for an uncontrolled environment. The transmitter of this device should be installed and operated at least 20 cm away from the user’s body. Use of other accessories not verified by the manufacturer may not ensure compliance with FCC RF exposure guidelines.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

Information sur l’exposition aux rayonnements radio fréquence (RF)

La puissance RF rayonnée de cet appareil étant de loin inférieure aux limites imposées par la FCC, il n’est pas soumis à la réglementation sur l’exposition aux RF selon la section 2.1093 de la réglementation FCC.

Cet équipement est conforme aux limites d‘exposition aux rayonnements imposées par la FCC pour un environnement non réglementé. L‘émetteur de cet équipement doit être installé et utilisé à une distance minimale de 20 cm du corps de l‘utilisateur. L‘utilisation d‘autres accessoires non homologués par le fabricant remet en cause la conformité des normes imposées par la FCC.

Cet émetteur ne doit pas être positionné à proximité d‘une autre antenne ou d‘un autre émetteur, ni utilisé avec une autre antenne ou un autre émetteur.

經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。

低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。