Taiwan
MB Pro 1 MB Pro 2 BTD 800 USB
經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計
之特性及功能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善至無干擾時方
得繼續使用。前項合法通信,指依電信法規定作業之無綫電通信。低功率射頻電機須忍受合法通信或工業、科學及醫
療用電波輻射性電機設備之干擾。
CCAI12LP3060T5
CH 20 MB |
CH 20 MB USB
Japan
R 201-125772
CMIIT ID: 2013DJ5588
China
MB Pro 1 | MB Pro 2 | BTD 800 USB | CH 20 MB USB | CH 20 MB
In compliance with:
MB Pro 1 MB Pro 2 BTD 800 USB
USA
Canada
Europe
Australia/
New Zealand
Singapore
Korea
FCC ID: DMOCBSSHF FCC ID: DMOCBSSHF FCC ID: DMOCBBSKE
IC: 2099A-MBHS IC: 2099A-MBHS IC: 2099D-BTD800
MSIP-CRM-SC9-MBPRO MSIP-CRM-SC9-MBPRO
사용자 정보:
해당 무선설비는 운용 중 전파혼신 가능성이 있음
해당 무선설비는 전 혼신 가능성이 있으므로 인명안전과 관련된 서비스는 할 수 없음
안전인증
(Certification No)
품명
(Product name)
모델명
(Model)
신청인
(Applicant)
제조자
(Manufacturer)
제조국
(Country of Origin)
제조년월
(Manufacturing date)
MSIP-CRM-SC9-MBPRO KCC-CRM-SC9-BTD800 MSIP-CRM-SC9-CH20MB
Bluetooth headset
(MB Pro 1)/(MB Pro 2)
MB Pro 1/ MB Pro 2 BTD 800 USB CH 20 MB USB
Sennheiser Communications A/S
Sennheiser Comunications A/S
중국 (China)
별도표기
KCC-CRM-SC9-BTD800
Bluetooth dongle Headset charger
CH 20 MB |
CH 20 MB USB
MSIP-CRM-SC9-CH20MB
MB Pro 1 | MB Pro 2 | BTD 800 USB | CH 20 MB USB | CH 20 MB
Statements regarding FCC and Industry Canada/
Déclaration requise par la FCC et l’Industrie Canada
FCC Declaration of Conformity (DoC)
SENNHEISER
Model No:
Sennheiser Electronic Corporation
We,
One Enterprise Drive • Old Lyme •
CT 06371 • USA
Tel: +1 (860) 434 9190, ext. 144
Fax : + 1 (860) 434 1759
declare the above device c omply with t he requirements of Federal Communications Commission.
This device complies with Part 15 subpart b of the FCC rules. Operation is subjected to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause undesired operation.
Responsible Part y: Greg Beebe
BTD 800 USB | CH 20 MB USB | CH 20 MB
EN
This device complies with Part 15 subpart b of the FCC rules.
Operation is subjected to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause undesired operation.
FCC User Information:
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device of the FCC Rules,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for
help.
Changes or modifications made to this equipment not expressly approved by Sennheiser electronic Corp. may void FCC
authorization to operate this equipment.
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
RF Radiation Exposure Information
Since the radiated output power of this device is far below
the FCC radio frequency exposure limits, it is not subjected
to routine RF exposure evaluation as per Section 2.1093 of
the FCC rules. This device complies with the US and Industry
Canada portable device RF exposure limits set forth for an uncontrolled environment and is safe for intended operation as
described in the user manual.
FR
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Information sur l‘exposition aux radiofréquencesn
La puissance RF rayonnée de cet appareil étant de loin inférieure aux limites imposées par la FCC, il n’est pas soumis à
la réglementation sur l’exposition aux RF selon la section
2.1093 de la réglementation FCC. Cet appareil portatif est
conforme aux limites d‘exposition aux radiofréquences de la
FCC et d‘Industrie Canada, définies pour un environnement
non-contrôlé et il ne présente aucun danger au regard de son
utilisation prévue décrite dans la notice d‘emploi.
Sennheiser Communications A/S
Industriparken 27, DK-2750 Ballerup, Denmark, www.sennheiser.com, Printed in China, 10/13, A01