Page 1
Bluetooth® Audio Transmitter Compliance Information
Frequency band: 2400 – 2483.5 MHz
Transmit power: 10 mW (max)
Country/Region BT T100
USA
Canada
Europe
Australia/New Zealand
Singapore
China
Korea
Japan
Taiwan
FCC ID: DMOBTT100
IC: 2099A-BTT100
CAN ICES-3 (B)/NMB-3(B)
Complies with
IMDA Standards
DB100582
CMIIT ID: 2018DJXXXX
15
R-CRM-SE9- BTT100
모델명: BT T100
상호명: Sennheiser electronic GmbH & Co. KG
기자재명칭: 무선데이터통신시스템용 무선기기
제조자: Sennheiser electronic GmbH & Co. KG
제조국: 중국
"해당 무선설비는 운용 중 전파혼신 가능성이 있음"
R 201-18XXXX
CCAI18LPXXXXXX
Statements regarding FCC and Industry
Canada
FCC Supplier's Declaration of Conformity (SDoC)
Sennheiser Elect ronic Corporation
We,
One Enterprise Drive • Old Lyme •
CT 06371 • USA
Tel: +1 (860) 434 9190
Fax: + 1 (860) 434 1759
declare the above device comply with the requirements of Federal Communications Commission.
This device complies with Part 15 of the FCC rules. Operation is s ubjected to
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause
undesired operation.
Responsible Party: Michael Lieske
This device complies with Part 15 of the FCC rules and RSS-247 of
Industry Canada. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This
device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules and
RSS-247 of Industry Canada. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio commu-
SENNHEISER
Model No:
BT T100
the following two conditions:
nications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications made to this equipment not expressly approved by Sennheiser electronic Corp. may void FCC authorization
to operate this equipment.
Déclaration requise par la FCC et l’Industrie Canada
Cet appareil est conforme à la Partie 15 des réglementations de la
FCC et à la norme CNR-247 d’Industrie Canada. L’utilisation de l’appareil doit respecter les deux conditions suivantes : (1) L’appareil ne
doit pas produire d’interférences nuisibles, et, (2) il doit accepter
toutes interférences reçues, y compris celles qui pourraient avoir
des effets non désirés sur son fonctionnement.
CAN ICES-3 (B)/NMB-3(B)
Page 2
RF Radiation Exposure Information
Since the radiated output power of this device is far below the FCC
/ IC radio frequency exposure limits, it is not subjected to routine
RF exposure evaluation as per Section 2.1093 of the FCC rules and
RSS-102 of Industry Canada.
This device meets FCC/ IC RF exposure guidelines for an uncontrolled environment. The transmitter of this device should be installed
and operated at least 20 cm away from the user’s body. Use of other
accessories not verified by the manufacturer may not ensure compliance with FCC / IC RF exposure guidelines.
This transmitter must not be co-located or operated in conjunction
with any other antenna or transmitter.
Information sur l’exposition aux radiofréquences
La puissance RF rayonnée de cet appareil étant de loin inférieure
aux limites imposées par la FCC / IC, il n’est pas soumis à la réglementation sur l’exposition aux RF selon la section 2.1093 de la
réglementation FCC et CNR-102 de Industrie Canada.
Cet équipement est conforme aux limites d‘exposition aux rayonnements imposées par la FCC / IC pour un environnement non réglementé. L‘émetteur de cet équipement doit être installé et utilisé
For Taiwan:
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得
擅自變更頻率、加大功率或變更原設計之特性及功能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現
象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依
電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科
學及醫療用電波輻射性電機設備之干擾。
For Korea:
사용자 정보:
1) 해당 무선설비는 운용 중 전파혼신 가능성이 있음
2) 해당 무선설비는 전파혼신 가능성이 있으므로 인명안전과 관련된 서비
스는 할 수 없음
For Vietnam:
As from December 1, 2012, products manufactured by Sennheiser
comply with Circular 30/2011/TT-BCT regulating the permitted
limits for certain hazardous substances in electronic and electric
products.
à une distance minimale de 20 cm du corps de l‘utilisateur. L‘utilisation d‘autres accessoires non homologués par le fabricant remet en
cause la conformité des normes imposées par la FCC / IC.
Cet émetteur ne doit pas être positionné à proximité d‘une autre
antenne ou d‘un autre émetteur, ni utilisé avec une autre antenne
ou un autre émetteur.
China RoHS
有害物质
部件名称 (Part Name)
电路模块 (Circuit Modules) x o o o o o
电缆及电缆组件 (Cables & Cable Assemblies) x o o o o o
本表格依据 SJ/T 11364 的规定编制。
o： 表示该有害物质在该部件所有均质材料中的含量均在GB/T 26572规定的限量要求以下。
x： 表示该有害物质至少在该部件的某一均质材料中的含量超出GB/T 26572规定的限量要求。
铅 (Pb) 汞 (Hg) 镉 (Cd) 六价铬 (CrVI) 多溴联苯 (PBB)
多溴二苯醚
(PBDE)
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by Sennheiser electronic GmbH & Co. KG is
under license.
Sennheiser electronic GmbH & Co. KG
Am Labor 1, 30900 Wedemark, Germany
www.sennheiser.com
Printed in China, Publ. 04/18, 580104/A01
Loading...