Sennheiser HS 2 User Manual

HS 2

Microphones | Back-Electret Condenser Microphone

General Description

The HS 2 is an omni-directional headset microphone using an MKE 2 Gold
capsule and fitted with a steel wire cable and a special 3-pin connector
for Sennheiser 3000 and 5000 Series bodypack transmit ters. The small
capsule and gooseneck assembly can be optimally positioned for both
vocal and speech applications. Also available as HS 2-1 in beige.

Cat. No. 005336

Technical Data

Pick-up pattern .......................................................omni-directional

Frequency response ....................................20 – 20,000 Hz ± 3 dB

Sensitivity

(free field, no load) (1 kHz) .................................. 5 mV/Pa ± 3 dB

Nominal impedance ....................................................................1 kΩ

Min. terminating impedance..................................................4.7 kΩ

Equivalent noise level

A-weighted (DIN IEC 651)........................................................ 26 dB

CCIR-weighted (CCIR 468-3).................................................... 39 dB

Max. SPL (1 kHz)...............................................142 dB (THD = 1 %)

Power supply.................................................................. 18 kΩ/7.5 V

Connector .................................................3-pin audio connector for

SK 50/SK 250/SK 5012

Cable length.................................................................................1.6 m

Capsule diameter................................................................ Ø 4.8 mm

Weight ............................................................................. approx. 34 g

Features

j

Frequency response optimised fpr close talking applications

j

Lightweight design

j

Flexible gooseneck for optimally positioning the microphone capsule

j

Umbrella Diaphragm™ protects the mic against sweat

Product Variants

j

HS 2-1: as HS 2, but beige

j

HS 2-5: as HS 2, but with open-ended cable