Page 1
SVC 1040SL
Copyright © 2017, Fast ČR, a.s.
EN Bagless Vacuum Cleaner
- 1 -
04/2017
Page 2
EN
Bagless Vacuum Cleaner
Important safety instructions
READ CAREFULLY AND STORE FOR FUTURE USE.
■ This vacuum cleaner may be used by children 8 years of age and older and by
persons with physical or mental impairments or by inexperienced persons, if
they are properly supervised or have been informed about how to use this
vacuum cleaner in a safe manner and understand the potential dangers.
Children must not play with the vacuum cleaner. Cleaning and maintenance
performed by the user must not be performed by unsupervised children.
Keep the vacuum cleaner and its accessories out of reach of children that are
younger than 8 years of age.
■ This vacuum cleaner is designed for use in households, offices and similar types of
areas. Do not use in industrial surroundings.
■ Do not expose the vacuum cleaner to direct sunlight and do not place it near an
open fire or appliances that are asource of heat.
■ Before connecting the power cord to apower socket, check that the technical
details on the vacuum cleaner’srating label match the electrical voltage in the
socket.
■ Make sure the power cord is not touching ahot surface or sharp objects.
■ Do not submerge the vacuum cleaner under water or any other liquid and do not
rinse it under running water.
■ Before turning on the vacuum cleaner, make sure that the motor filter, micro-filter
and the outflow EPA filter are installed in their place.
■ When the vacuum cleaner is running, ensure that the air outlets and the suction
opening are not blocked.
■ Do not use the vacuum cleaner to vacuum the following items:
– smouldering cigarettes, burning items, matches or embers;
– water and other liquids;
– flammable or volatile materials;
– sharp items, e.g. broken glass, needles, pins, etc.;
– flour, wall plaster, cement and other building materials;
– larger pieces of paper or plastic bags, which can easily block the suction opening.
■ Vacuuming of some types of floors or floor surfaces can create a electrostatic
discharge, which presents no danger to the user.
■ Do not place the suction nozzle or tube against any parts of the face.
■ Always turn off the vacuum cleaner and disconnect it from the power socket when
leaving it without supervision, after finishing using it and before cleaning it.
Copyright © 2017, Fast ČR, a.s.
- 2 -
04/2017
Page 3
■ Disconnect the power cord from the power socket by pulling on the plug, never
pulling on the cord. Otherwise, this could damage the power cord or the socket.
Hold the power cord in your hand when winding it up.
■ If the power cord is damaged, have it replaced at aprofessional service centre. It is
forbidden to use the vacuum cleaner if it has adamaged power cord.
■ Do not use the vacuum cleaner if it is not working correctly, if it has been damaged
or has been submerged in water. Do not repair the vacuum cleaner yourself or
make any adjustments to it. Have all repairs performed at an authorised service
centre. By tampering with the appliance, you risk voiding your legal rights arising
from unsatisfactory performance or quality warranty.
Copyright © 2017, Fast ČR, a.s.
- 3 -
04/2017
Page 4
1
2
3
A
9
4
5
6
7
8
15
16
10
11
12
13
14
17
18
22
23
21
19
20
25
26
Copyright © 2017, Fast ČR, a.s.
- 4 -
24
27
04/2017
Page 5
B
C
1 2
Copyright © 2017, Fast ČR, a.s.
- 5 -
04/2017
Page 6
Bagless Vacuum Cleaner
EN
User'smanual
■ Prior to using this appliance, please read the user’smanual thoroughly, even
in cases, when one has already familiarised themselves with previous use of
similar types of appliances. Only use the appliance in the manner described in
this user’smanual. Keep this user’smanual in asafe place where it can be easily
retrieved for future use.
■ We recommend saving the original cardboard box, packaging material,
purchase receipt and responsibility statement of the vendor or warranty card
for at least the duration of the legal liability for unsatisfactory performance
or quality. In the event of transportation, we recommend that you pack the
appliance in the original box from the manufacturer.
DESCRIPTION OF THE VACUUM CLEANER AND ITS ACCESSORIES
A1 Handle
A2 Lid
the micro-filter is located under
the lid.
A3 Lid open clip
A4 On/Off button of the vacuum
cleaner
A5 Full dust container indicator
A6 Rubber-coated side travel wheel
A7 Removable 1.3-litre dust
container
A8 Flexible hose connection hole
A9 Lock-in clip
serves to secure the dust
container in the vacuum cleaner.
A10 Automatic power cord winding
button
A11 Groove for the horizontal
parking position
A12 Power cord
A13 Removable grill of the outflow
INTENDED USE OF THE ACCESSORIES
■ The universal floor nozzle with an extensible brush A23 is intended for all floor
types. Extend the brush when vacuuming smooth hard floors, and retract it
when vacuuming carpets. Use flap A24 to extend and retract the brush.
■ The crevice nozzle A25 makes vacuuming corners and hard to reach places
much easier; the brush nozzle A26 can be used for various types of furniture
and nozzle A27 serves to gently vacuum upholstered furniture.
PREPARING FOR USE
■ Make sure that the dust container A7, motor filter A17, micro-filter A20 and the
outflow EPA filter A14 are properly installed in the vacuum cleaner
■ Slide the end of the flexible hose A21 fully into the hole A8. The hose A21 is
secured in place when an audible click is made.
Note:
Prior to disassembly, it is necessary to press the latches on the hose end
A21 while simultaneously pulling it out of the hole A8.
■ Attach the telescopic tube A22 on to the handle of the flexible hose A21. Slide
the clip on the telescopic tube A22 in the direction of the arrow marked on the
extension locking clip on the telescopic tube A22. After unlocking the locking
clip, set the length of the tube A22 by sliding its extensible part in or out. When
the clip is released, it will lock in at the set length.
■ Connect the floor nozzle A23 to the free end of the telescopic tube A22.
■ The crevice nozzle A25, brush nozzle A26 and upholstery nozzle A27 can be
attached directly to the handle of the flexible hose A21 or to the telescopic
tube A22.
USING THE VACUUM CLEANER
■ Pull on the power plug to wind out the required length of the power cord A12
and connect it to apower socket.
Attention:
The yellow mark on the power cord A12 indicates the approaching end
of its length, and the red mark indicates the complete end of its length.
Do not attempt to pull the power cord A12 past this mark.
■ To start the vacuum cleaner, press button A4. Suction power can be set using
the mechanical flap on the handle of the flexible hose A21.
■ The rubber-coated wheels protect floating floors against scratching and ensure
smooth motion of the vacuum cleaner on the floor.
EPA filter
A14 Washable outflow EPA filter
is placed behind the grill.
A15 Front swivel travel wheel
A16 Rear travel wheel
A17 Motor filter
A18 Dust container open clip
A19 Sealing ring
A20 Micro-filter
A21 Flexible hose with mechanical
suction power control in the
handle
A22 Telescopic metal tube
A23 Floor nozzle with an extensible
brush
A24 Flap for extending and retracting
the brush
A25 Crevice nozzle
A26 Brush nozzle
A27 Upholstery nozzle
■ When you have finished using the vacuum cleaner, turn it off by pressing button
A4 and disconnect the power cord A12 from the power socket. To wind the
power cord A12 back into the vacuum cleaner, press and hold button A10 until
its entire length is wound up. Gently hold the power cord A12 with one hand
while winding it up.
Note:
If the power cord A12 is not wound up completely, release button
A4, and pull the power cord A12 out of the vacuum cleaner by
approximately 50cm and then try to wind it up again.
PARKING POSITION OF THE VACUUM CLEANER
■ When not using the vacuum cleaner, you may put it in the parking position by
sliding the guide tab on the floor nozzle A23 into the groove A11, see fig. B.
■ Do not carry the vacuum cleaner from place to place if the hose is in the parked
position. The guide tab on the floor nozzle A23 could brake off.
MAINTENANCE AND CLEANING
■ Before cleaning it, always make sure that the vacuum cleaner is turned off and
disconnected from the power socket.
Emptying and cleaning the dust container
■ The red-coloured indicator A5 signals that it is necessary to empty out the dust
container A7.
■ Release the lock-in clip A9 and pull on the handle A1 to remove the dust
container A7 from the vacuum cleaner. Place it over adust bin and press the
dust container open clip A18, see figure C1. This will open the tilt-out bottom
and dump out the contents of the container A7. Gently tap on the sides of
the container A7 to release any accumulated dirt. For hygiene reasons, we
recommend emptying out the dust container A7 away from living areas.
■ Hold the container A7 with one hand and with your other hand turn the handle
A1 in the direction of the open padlock symbol that is marked on the container
A7. Remove the top part containing the cyclone unit from the dust container
A7, see figure C2. Wash the container A7 under lukewarm running water
and thoroughly wipe it dry.Assemble the container A7 and close its bottom.
Reinsert the assembled container A7 back into the vacuum cleaner and make
sure that it is properly secured in the vacuum cleaner.
Cleaning and replacing the motor filter, micro-filter and the outflow EPA
filter
■ Remove the dust container A7 from the vacuum cleaner. If the motor filter A17
is visibility soiled, tap it out or wash it under lukewarm running water and allow
it to dry naturally. Install the filter A17 and container A7 back into the vacuum
cleaner. In the event that the motor filter A17 is showing signs of wear or it is
heavily soiled, replace it with anew one.
■ Open the lid A2, remove the micro-filter A20 and tap out its contents or wash
it under aweak current of running lukewarm water and allow it to dry naturally.
Make sure that the micro-filter A20 is seated in the sealing ring A19 and put it
back in its place. Close the lid A2. In the event of heavy soiling or wear and tear,
replace the used micro-filter A20 with anew one.
■ Release and remove the grill A13. Remove the EPA filter A14 from the vacuum
cleaner. In the case of light soiling, tap it out. In the event of heavy soiling, wash
it under aweak current of running lukewarm water so that the water washes the
dirt out of the folds. Allow the EPA filter A14 to dry naturally, then reinsert it and
secure it in place with the grill A13. It is recommended to replace the EPA filter
with anew one after 6 months of use.
■ When filters are soiled, their effectiveness is reduced, so do not neglect their
cleaning and ensure their timely replacement.
Note:
For hygiene reasons, we recommend that you tap out the filters away
from living areas.
Attention:
Before putting the filters back into the vacuum cleaner, make sure that
they are completely dry.
Cleaning the flexible hose, telescopic tube, floor nozzle, crevice nozzle, brush
nozzle and upholstery nozzle.
■ If the accessories are soiled, take them out and clean away all dirt (dust, hair,
animal fur, etc.).
Cleaning the outer surface of the vacuum cleaner
■ Clean the outer surface using a dry or alightly dampened cloth. Then wipe it
thoroughly dry.
■ For cleaning the vacuum cleaner, do not use steel wool, abrasive cleaning
products, solvents etc.
■ Do not submerge the vacuum cleaner under water or any other liquid and do
not rinse it under running water.
Copyright © 2017, Fast ČR, a.s.
- 6 -
04/2017
Page 7
TECHNICAL SPECIFICATIONS
Rated voltage range ...................................................................................................220−240 V
Rated frequency..................................................................................................................... 50 Hz
Rated power input ...............................................................................................................700 W
Electrical shock protection class ............................................................................................... II
Noise level ..........................................................................................................................78 dB(A)
Dust container capacity .......................................................................................................... 1.3l
EPA filter efficiency class ............................................................................................................11
Length of the power cord .....................................................................................................5 m
Operational radius ....................................................................................................................8 m
Dimensions (length × width × height) .....................................................37 × 27 × 24 cm
Weight ..........................................................................................................................................5 kg
The declared noise emission level is 78 dB(A), which represents alevel Aof sound
power with respect to areference sound power of 1 pW.
Explanation of technical terminology
Safety class for electrical shock protection:
Class II – Electrical shock protection is provided by double or heavy-duty
insulation.
We reserve the right to change text and technical specifications.
PRODUCT INFORMATION SHEET
Name / trademark Sencor
Model identification number SVC 1040SL
Energy efficiency class* A
Annual power consumption (in kWh)** 28
Carpet cleaning efficiency class D
Hard floor cleaning efficiency class A
Vacuum cleaner dust emission class B
Level of acoustic power in dB(A) 78
Rated power input (W) 700
* Class A(highest efficienc y class, low power consumption) to Class G (lowest
efficiency class, high power consumption).
** Approximate annual power consumption in kWh per year based on 50 cleaning
cycles. Actual power consumption will depend on how the appliance is used.
The values are determined pursuant to (EU) No. 665/2013.
INSTRUCTIONS AND INFORMATION REGARDING THE
DISPOSAL OF USED PACKAGING MATERIALS
Dispose of used packaging material at a site designated for waste in your
municipality.
DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT
resources and prevents potential negative effects on the environment and human
health, which could result from improper waste disposal. Ask your local authorities
or collection facility for more details.
In accordance with national regulations penalties may be imposed for the
incorrect disposal of this type of waste.
For business entities in European Union states
If you want to dispose of electric or electronic appliances, ask your retailer or
supplier for the necessary information.
Disposal in other countries outside the European Union.
This symbol is valid in the European Union. If you wish to dispose of this product,
request the necessary information about the correct disposal method from the
local council or from your retailer.
This symbol on products or original documents means that used
electric or electronic products must not be added to ordinary
municipal waste. For proper disposal, renewal and recycling hand
over these appliances to determined collection points.
Alternatively, in some European Union states or other European
countries you may return your appliances to the local retailer when
buying an equivalent new appliance.
Correct disposal of this product helps save valuable natural
This product meets all the basic requirements of EU directives related
to it.
Copyright © 2017, Fast ČR, a.s.
- 7 -
04/2017
Loading...