Page 1
Pedestal Fan
User's manual
EN
SFN 4040SL
Translation of the original manual
Prior to using this appliance, please read the user’smanual thoroughly, even in cases, when one has already
familiarised themselves with previous use of similar types of appliances. Only use the appliance in the manner
described in this user’smanual. Keep this user’smanual in asafe place where it can be easily retrieved for future use.
We recommend saving the original cardboard box, packaging material, purchase receipt and responsibility
statement of the vendor or warranty card for at least the duration of the legal liability for unsatisfactory performance
or quality. In the event of transportation, we recommend that you pack the appliance in the original box from the
manufacturer.
EN-1
2019 12/2019
Page 2
EN
CONTENTS
IMPORTANT SAFETY NOTICE ...................................................................................3
DESCRIPTION OF THE APPLIANCE .............................................................................8
BEFORE FIRST USE .............................................................................................8
ASSEMBLING AND DISASSEMBLING THE APPLIANCE ...........................................................8
OPERATING THE APPLIANCE ...................................................................................8
CLEANING AND MAINTENANCE ...............................................................................9
STORAGE ......................................................................................................9
TECHNICAL SPECIFICATIONS ..................................................................................9
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING MATERIALS ............10
DISPOSAL OF USED ELECTRICAL AND ELECTRONIC APPLIANCES .............................................10
SFN 4040SL
Pedestal Fan
EN-2
2019 12/2019
Page 3
Pedestal Fan
SFN 4040SL
IMPORTANT SAFETY NOTICE
READ CAREFULLY AND STORE FOR FUTURE USE.
▪ This appliance may be used by children 8 years of
age and older and by persons with physical or mental
impairments or by inexperienced persons, if they are
properly supervised or have been informed about how
to use the product in asafe manner and understand
the potential dangers.
▪ Children must not play with the appliance. Cleaning
and maintenance performed by the user must not be
performed by unsupervised children.
▪ In the event that the power cord is damaged, have it
repaired at a professional service centre to prevent
causing adangerous situation. It is forbidden to use
EN
the appliance if it has adamaged power cord.
▪ Before connecting the appliance to apower socket,
check that the rated voltage on its rating label matches
the electrical voltage in the power socket.
▪ Connect the appliance only to aproperly grounded
socket.
▪ The appliance is designed for use at home, in oces
and similar types of areas. Do not use it in very dusty or
humid rooms such as laundries or bathrooms, in areas
where chemical or explosive substances are stored, in
industrial surroundings or outdoors!
EN-3
2019 12/2019
Page 4
EN
▪ Do not place the appliance in the vicinity of an open
ame or appliances that are sources of heat.
▪ Do not place the appliance on unstable surfaces
such as carpets with very long and thick bres. Only
place the appliance on aclean, even, dry and smooth
surface.
▪ Before turning it on, check that the appliance is
correctly assembled according to the instructions in
this user’smanual. Do not start the appliance without
the protective grilles properly installed. Only use
original parts to assemble the appliance.
▪ Do not cover the appliance with any items while it is
running.
▪ Avoid coming into contact with the rotating parts of
SFN 4040SL
Pedestal Fan
the appliance. Never insert your ngers or other items
through the protective grille when the appliance is
plugged into apower socket. This applies particularly
when the appliance is in operation.
▪ Never submerge the appliance or its power cord in
water or any other liquid and do not wash it under
running water.
▪ Make sure the power cord does not hang over the
edge of atable and that it is not touching ahot surface.
EN-4
2019 12/2019
Page 5
Pedestal Fan
SFN 4040SL
▪ Always turn o the appliance and disconnect it
from the power socket when leaving it without
supervision, when not using it and before assembling,
disassembling or cleaning it.
▪ Ensure that the fan is disconnected from the mains
power supply before removing the protective grille.
▪ Disconnect the appliance from the power socket by
pulling on the plug, never pulling on the power cord.
Otherwise, this could damage the power cord or the
socket.
▪ Do not use the appliance if it is not working correctly, if
it has been damaged or has been submerged in water.
To avoid ahazardous situation arising, do not repair the
device yourself or modify it in any way. Have all repairs
EN
or adjustments performed at an authorised service
centre. By tampering with the appliance, you risk
voiding your legal rights arising from unsatisfactory
performance or quality warranty.
EN-5
2019 12/2019
Page 6
EN
Pedestal Fan
SFN 4040SL
A
1
3
4
5
2
7
6
8
9
10
B
EN-6
2019 12/2019
Page 7
Pedestal Fan
SFN 4040SL
C
EN
D
EN-7
2019 12/2019
Page 8
EN
DESCRIPTION OF THE APPLIANCE
A1 Protective grille (consists of two parts: front and rear)
A2 Fan blades with adiameter of 40 cm
A3 Motor unit
A4 Horizontal oscillation toggle switch
A5 Speed selector 0 - o, 1 - low speed, 2 - medium speed, 3 - high speed
A6 Screw for attaching the motor unit to the pole
A7 Fan head tilt angle adjustment screw
A8 Extensible pole
A9 Pole extension lock
A10 Base
Note:
The accessories include ascrew and anut for joining the protective grills.
BEFORE FIRST USE
■ Take the appliance and its accessories out of the packaging materials. Before disposing of the packaging materials,
make sure that no part of the appliance is missing.
ASSEMBLING AND DISASSEMBLING THE APPLIANCE
■ Before assembling or disassembling the appliance, make sure that it is turned o and disconnected from the
power socket.
■ Remove the nut from the underside of the extensible pole A8. Seat the extensible pole A8 on the base A10 so that
the opening of the extensible pole A8 is aligned with the hole in the base A10. Secure the extensible pole A8 in
place using the nut. Check that it is correctly tightened.
■ Remove the four screws A3 from the motor unit. Place the rear part of the protective grille A1 on to the motor unit
A3 so that the holes in the motor unit A3 are aligned with the holes in the protective grille A1. Secure the rear part
of the protective grille A1 using the screws.
■ Place the fan blades A2 on to the shaft of the motor unit A3 and rmly tighten the screws.
■ Now attach the front part of the protective grille A1 and fasten both parts together using the metal clamps and
asmall screw, which is apart of the grille assembly.
■ Place the motor unit A3 with the attached fan head on the extensible pole A8 and secure the fan head using the
screw A6.
■ Before putting the fan into operation, check that it is correctly assembled and that the protective grills are rmly
joined.
■ To disassemble, proceed in reverse sequence.
OPERATING THE APPLIANCE
Setting the speed and turning o the fan
■ Place the fan on an even, dry and smooth surface within reach of apower socket. Connect the power cord to
apower socket. To set the air ow speed, use the speed selector A5.
0 – turn o the fan;
1– set alow air ow speed;
2 – set amedium air ow speed;
3– set ahigh air ow speed.
■ When you have nished using the fan, always turn it o and disconnect it from the power socket.
Setting horizontal oscillation
■ The horizontal oscillation of the motor unit A3 can be set using the toggle switch A4. To start the horizontal
oscillation, push the toggle switch A4 down. The motor unit A3 will oscillate from side to side at an angle of
approximately 90°.
■ To turn o the oscillation, pull the toggle switch A4 up. This will turn o the oscillation.
SFN 4040SL
Pedestal Fan
EN-8
2019 12/2019
Page 9
Pedestal Fan
SFN 4040SL
Setting the vertical tilt angle of the motor unit
■ Before setting the vertical tilt angle of the motor unit A3, rst turn o the fan. Set the desired angle of the motor
unit A3 and then you may start the fan again.
Note:
The motor unit A2 may only be tilted up and down in alimited range. Do not set the tilt angle of the
motor unit A2 by force.
Setting the height of the fan
■ Turn o the fan before setting its height. Use one hand to rmly hold the bottom part of the extensible pole A8
and use the other hand to release the inner extension lock A9 by turning the locking screw anticlockwise. Slide
the top part of the extensible pole A8 in or out to set the desired fan height. To lock the set height in place, tighten
the locking screw clockwise.
CLEANING AND MAINTENANCE
■ Before cleaning it, make sure that the appliance is turned o and disconnected from the power socket.
■ Regularly remove dust from the appliance. For normal cleaning, aclean, dry cloth is sucient. In the event that it
is dirtier, disassemble the appliance and then wipe the individual parts with awiping cloth slightly dampened in
asolution of warm water and neutral detergent. Then wipe everything so that it is thoroughly dry. Make sure that
when cleaning, no water leaks into the motor unit A3.
■ Do not submerge the appliance or its power cord in water and do not wash it under running water.
■ For cleaning do not use steel wool, cleaning products with an abrasive eect, petrol and other solvents.
STORAGE
■ If you will not be using the fan for an extended period of time, store it in aclean, dry place or disassemble it and
put it back into the box.
TECHNICAL SPECIFICATIONS
Rated voltage range ............................................................................................................................................................................... 220−240 V
Rated frequency ................................................................................................................................................................................................ 50 Hz
Rated power ..........................................................................................................................................................................................................50 W
Electrical shock protection class ........................................................................................................................................................................... II
Noise level .......................................................................................................................................................................................................61 dB(A)
Maximum fan ow rate ....................................................................................................................................................................59.90 m3/min
Service value ..................................................................................................................................................................................1.37 (m3/min)/W
Maximum air velocity .................................................................................................................................................................................3.21 m/s
Measurement standard for service value .............................................................................................IEC 60879:1986, EN 50564:2011,
...........................................................................................................................................EN 60704-2-7:1998, EN 60704-1:2010, +A11: 2012
Contact details for obtaining more information .......................................................................FAST ČR, a. s., Černokostelecká 1621,
................................................................................................................................................................................. 251 01 Říčany, Czech Republic
The declared noise emission level of the appliance is 61dB(A), which represents alevel A of acoustic power with
respect to areference acoustic power of 1pW.
Explanation of technical terminology
Safety class for electrical shock protection:
Class II – electrical shock protection is provided by double or heavy-duty insulation.
We reserve the right to change text and technical specications.
EN
EN-9
2019 12/2019
Page 10
EN
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED
PACKAGING MATERIALS
Dispose of used packaging material at asite designated for waste in your municipality.
DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT
This symbol on products or original documents means that used electric or electronic products
must not be added to ordinary municipal waste. For proper disposal, renewal and recycling hand
over these appliances to determined collection points. Alternatively, in some European Union states
or other European countries you may return your appliances to the local retailer when buying an
equivalent new appliance.
Correct disposal of this product helps save valuable natural resources and prevents potential
negative eects on the environment and human health, which could result from improper waste
disposal. Ask your local authorities or collection facility for more details.
In accordance with national regulations penalties may be imposed for the incorrect disposal of this type of
waste.
For business entities in European Union states
If you want to dispose of electric or electronic appliances, ask your retailer or supplier for the necessary
information.
Disposal in other countries outside the European Union
This symbol is valid in the European Union. If you wish to dispose of this product, request the necessary
information about the correct disposal method from the local council or from your retailer.
This product meets all the basic requirements of EU directives related to it.
SFN 4040SL
Pedestal Fan
EN-10
2019 12/2019
Loading...