SENBO MACHINE MANUFACTURE SHSB User Manual

2.4G Wireless Remote Controller User Manual

1. Use description

（1）Battery installation
Unfastening the rear cover screw and remove it, install two NO.7 batteries. Be sure the
correction of polarity of battery. The flash of the SPEED_INDICATOR &
CAR_SELECT_INDICATOR will show it .

（2）The CAR_SELECT key & CAR_SELECT_INDICATOR
Use this key to ensure the unique correct corresponding of the remote to this car. Press the
CAR_SELECT key for more then 2 to 3 seconds, the CAR_SELECT_INDICATOR will turn
off, it shows that the remote can control this car .It can only control this car, and not defect
others. Note: Be Sure the power of the car is on, and the Closer between the transmitter
and the car.

（3）STOP key
The car will be stopped moving immediately as soon as this button is pressed in both
remote and manual operator mode.

（4）The SPEED_SLECT key & SPEED_SELECT indicator
This button is used to select the speed grade of the car. The grade will change in the range
of 3-level: low[one SPEED_INDICATOR flush ]、medium[two SPEED_INDICATOR flush]
and high[three SPEED_INDICATOR flush] speed. The change of the order is
LOW-MEDIUM-HIGH-MEDIUM-LOW as the button pressed. Note: Only the forward
direction moving can own this function, , the back word not

5 FORWARD_KEY & BACKWORD_KEY

Used to control the moving . Press one of the buttons, the car speed will ascend slowly to

the setup speed grade. So the child in this car won't have the sudden shock and feel
comfortable.

（6）LEFT_LEY & RIGHT_LEY
Used to control the left and right direction of the car.

Receiver:

3. Notice
（1）The transmitter owns energy-saving function. The power will automatic turn off as the
remoter is idle for about 10 seconds . it will work as any of the button is pressed.
（2）The CAR_SELECT Key must be operator once in the first time use of the remoter
and replace the remoter batteries.

（3）The performance of the remote will be affected with damp, wet. So keep it off .
（4）The transmitter is only for adult use