Senao Networks PCE4550AH User Manual

802.11 a/n/ac Module

≤ -64dBm@MCS9

PCE4550AH

User’s Manual

PRODUCT DESCRIPTION

The PCE4550AH is a 5G dual band concurrent 3T3R PCIe module base
on QCA9880 commercial grade solution.

PRODUCT SPECIFICATION

RF Specificatio

Radio

1

Frequency Band

Data rate

Receive

Sensitivity (Typical

n

Support 5GHz

802.11a/n/ac

5.190~5.795GHz

1300Mbps

)

802.11a ≤ -94dBm@6Mbps

802.11a/ n_HT20 ≤ -93dBm @ MCS0/8/16

802.11n_HT40 ≤ -92dBm @ MCS0/8/16

802.11ac_HT80 ≤ -89dBm@MCS0

≤ -76dBm@54Mbps

≤ -74dBm @ MCS7/15/23

≤ -72dBm @ MCS7/15/23

Type

Connector

5150~5250MHz

5250~5350MHz

5470~5725MHz

5725~5850MHz

Dipole

UFL

3dBi

3dBi

3dBi

3dBi

Dipole

UFL

5.5 dBi

5.5 dBi

5.5 dBi

5.5 dBi

PIFA

UFL

6 dBi

6 dBi

6 dBi

6 dBi

Note: The EUT has three antennas. (3TX/3RX)

Any changes or modifications not expressly approved by the manufacturer could void the user's authority to
operate this equipment.

USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 20cm separation with the
antenna while this end product is installed and operated. The end user has to be informed that the IC
radio-frequency exposure guidelines for an uncontrolled environment can be satisfied. The end user has to also be
informed that any changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate this equipment. IC statement is required to be available in the users manual: This Class B
digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device must accept any interference received, i ncluding
interference that may cau s e undesired operation.

2 -

-

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the re ceiver is
connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.

IMPORTANT NOTE:
FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the
radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Operations in the 5.15-5.25GHz band are restricted to indoor usage only.

- 3 -